Araştırma Makalesi
BibTex RIS Kaynak Göster

District Heating and Power Generation Based Flue Gas Waste Heat Recovery

Yıl 2017, Cilt: 1 Sayı: 2, 63 - 68, 16.06.2017
https://doi.org/10.26701/ems.321813

Öz

In this study, integration of
appropriate renewable methods are going to be applied on conventional coal
fired steam power plant which has 660 MW full load capacity and including 4
Turbines (1 HP,1 IP and 2 LP), one Benson type boiler and having multi pre
heater stages for each unit. Steam parameters are 177 Bar and 541 o C
super-heater section and 50 bar 539 o C for re-heater section. Primary fuel is
coal except for startup and shut down operations. It is aimed by retrofitting
some renewable energy methods on existing power plant, thus eliminating
conventional type power plants adverse effects on thermodynamically,
environmental and economic issues. 



One
of the most important issue of conventional steam power plant operation is
waste heat recovery management. A widespread techniques has been developed on
this topic. It's possible to handle low grade heat by considering thermodynamic
and environmental facts and also dealing with restrictions and opportunities
after fulfilled feasibility study. In this study, it is being proposed waste
heat recovery by combining Organic-Rankine Cycle (ORC) with steam-Rankine cycle
at available section. Brief summary of operation is ORC takes place after
regenerative air preheater section and the target is to utilize waste heat of
flue gas either via district heating or power generation up to few MW values.
Depending upon the calculation and results additional modifications can further
be needed as well.

Kaynakça

  • [1] NREL. Dollars From Sense: The Economic Benefits of Renewable Energy Retrieved; November 24 2013. [2] United States Senate, One Hundred Eleventh Congress. First Session to Receive Testimony on a Majority Staff Draft for a Renewable Electricity Standard Proposal, Hearing before the Committee on Energy and Natural Resources; U.S. Government Printing Office; February 2009. [3] Froese R.E., Shonnard D.R., Miller C.A., Koers K.P. and Johnson D.M. (2010). An evaluation of greenhouse gas mitigation options for coal-fired power plants in the US Great Lakes States; Biomass and Bioenergy; 34(3), p. 251-262. [4] Babcock Operating/Maintanance Manual System Description for training Steam Generator.
  • [5] Kosmadakis G., Manolakos D., Papadakis G. (2011). Simulation and economic analysis of a CPV/thermal system coupled with an organic Rankine cycle for increased power generation; Solar Energy; 85(2); p. 308–324.
  • [6] Xu G., Huang S.W. and Yang Y.P. (2013). Techno-economic analysis and optimization of the heat recovery of utility boiler flue gas; Applied Energy; 112, p. 907-917.
  • [7] Chengyu L. and Huaixin W. (2016). Power cycles for waste heat recovery from medium to high temperature; Applied Energy; 180, p. 707–721. [8] Xiaoqu H., Junjie Y., Sotirios K. , Ming L., Kakaras E. and Feng X. (2016). Water extraction from high moisture lignite by means of efficient integration of waste heat and water recovery technologies with flue gas pre-drying system, Applied Thermal Engineering 110, pp.442–456.
  • [9] Jiaxi X., Jiangfeng W., Juwei L., Pan Z. and Yiping D. (2016). Thermo-economic analysis and optimization of a combined cooling and power (CCP) system for engine waste heat recovery; Energy Conversion and Management; 128; p. 303–316.
  • [10] Navid N., Parisa H. and Soheil P. (2016). Multi-objective optimization of a combined steam-organic Rankine cycle based on exergy and exergo-economic analysis for waste heat recovery application; Energy Conversion and Management; 127, p. 366–379. [11] Zhenying W., Xiaoyue Z., Zhen L. (2016). Evaluation of a flue gas driven open absorption system for heat and water recovery from fossil fuel boilers; Energy Conversion and Management; 128, p. 57–65.
  • [12] Xiling Z., Lin F., Xiaoyin W., Tao S., Jingyi W. and Shigang Z. (2016). Flue gas recovery system for natural gas combined heat and power plant with distributed peak-shaving heat pumps; Applied Thermal Engineering; 111, p. 599–607.
Yıl 2017, Cilt: 1 Sayı: 2, 63 - 68, 16.06.2017
https://doi.org/10.26701/ems.321813

Öz

Kaynakça

  • [1] NREL. Dollars From Sense: The Economic Benefits of Renewable Energy Retrieved; November 24 2013. [2] United States Senate, One Hundred Eleventh Congress. First Session to Receive Testimony on a Majority Staff Draft for a Renewable Electricity Standard Proposal, Hearing before the Committee on Energy and Natural Resources; U.S. Government Printing Office; February 2009. [3] Froese R.E., Shonnard D.R., Miller C.A., Koers K.P. and Johnson D.M. (2010). An evaluation of greenhouse gas mitigation options for coal-fired power plants in the US Great Lakes States; Biomass and Bioenergy; 34(3), p. 251-262. [4] Babcock Operating/Maintanance Manual System Description for training Steam Generator.
  • [5] Kosmadakis G., Manolakos D., Papadakis G. (2011). Simulation and economic analysis of a CPV/thermal system coupled with an organic Rankine cycle for increased power generation; Solar Energy; 85(2); p. 308–324.
  • [6] Xu G., Huang S.W. and Yang Y.P. (2013). Techno-economic analysis and optimization of the heat recovery of utility boiler flue gas; Applied Energy; 112, p. 907-917.
  • [7] Chengyu L. and Huaixin W. (2016). Power cycles for waste heat recovery from medium to high temperature; Applied Energy; 180, p. 707–721. [8] Xiaoqu H., Junjie Y., Sotirios K. , Ming L., Kakaras E. and Feng X. (2016). Water extraction from high moisture lignite by means of efficient integration of waste heat and water recovery technologies with flue gas pre-drying system, Applied Thermal Engineering 110, pp.442–456.
  • [9] Jiaxi X., Jiangfeng W., Juwei L., Pan Z. and Yiping D. (2016). Thermo-economic analysis and optimization of a combined cooling and power (CCP) system for engine waste heat recovery; Energy Conversion and Management; 128; p. 303–316.
  • [10] Navid N., Parisa H. and Soheil P. (2016). Multi-objective optimization of a combined steam-organic Rankine cycle based on exergy and exergo-economic analysis for waste heat recovery application; Energy Conversion and Management; 127, p. 366–379. [11] Zhenying W., Xiaoyue Z., Zhen L. (2016). Evaluation of a flue gas driven open absorption system for heat and water recovery from fossil fuel boilers; Energy Conversion and Management; 128, p. 57–65.
  • [12] Xiling Z., Lin F., Xiaoyin W., Tao S., Jingyi W. and Shigang Z. (2016). Flue gas recovery system for natural gas combined heat and power plant with distributed peak-shaving heat pumps; Applied Thermal Engineering; 111, p. 599–607.
Toplam 7 adet kaynakça vardır.

Ayrıntılar

Konular Makine Mühendisliği
Bölüm Research Article
Yazarlar

Arif Özbek

Caglar Karaoglu Bu kişi benim

Yayımlanma Tarihi 16 Haziran 2017
Yayımlandığı Sayı Yıl 2017 Cilt: 1 Sayı: 2

Kaynak Göster

APA Özbek, A., & Karaoglu, C. (2017). District Heating and Power Generation Based Flue Gas Waste Heat Recovery. European Mechanical Science, 1(2), 63-68. https://doi.org/10.26701/ems.321813
AMA Özbek A, Karaoglu C. District Heating and Power Generation Based Flue Gas Waste Heat Recovery. EMS. Haziran 2017;1(2):63-68. doi:10.26701/ems.321813
Chicago Özbek, Arif, ve Caglar Karaoglu. “District Heating and Power Generation Based Flue Gas Waste Heat Recovery”. European Mechanical Science 1, sy. 2 (Haziran 2017): 63-68. https://doi.org/10.26701/ems.321813.
EndNote Özbek A, Karaoglu C (01 Haziran 2017) District Heating and Power Generation Based Flue Gas Waste Heat Recovery. European Mechanical Science 1 2 63–68.
IEEE A. Özbek ve C. Karaoglu, “District Heating and Power Generation Based Flue Gas Waste Heat Recovery”, EMS, c. 1, sy. 2, ss. 63–68, 2017, doi: 10.26701/ems.321813.
ISNAD Özbek, Arif - Karaoglu, Caglar. “District Heating and Power Generation Based Flue Gas Waste Heat Recovery”. European Mechanical Science 1/2 (Haziran 2017), 63-68. https://doi.org/10.26701/ems.321813.
JAMA Özbek A, Karaoglu C. District Heating and Power Generation Based Flue Gas Waste Heat Recovery. EMS. 2017;1:63–68.
MLA Özbek, Arif ve Caglar Karaoglu. “District Heating and Power Generation Based Flue Gas Waste Heat Recovery”. European Mechanical Science, c. 1, sy. 2, 2017, ss. 63-68, doi:10.26701/ems.321813.
Vancouver Özbek A, Karaoglu C. District Heating and Power Generation Based Flue Gas Waste Heat Recovery. EMS. 2017;1(2):63-8.

Dergi TR Dizin'de Taranmaktadır.

Flag Counter