TY  - JOUR
T1  - An experimental study for a single-pass solar air heater integrated with artificial roughness
AU  - Bader, Nabaa M.
AU  - Mushatet, Khudheyer S.
PY  - 2024
DA  - September
JF  - Journal of Thermal Engineering
PB  - Yildiz Technical University
WT  - DergiPark
SN  - 2148-7847
SP  - 1292
EP  - 1305
VL  - 10
IS  - 5
LA  - en
AB  - The utilization of solar air heaters are significant due to its capacity to diminish the reliance on fossil fuel-based power usage, hence mitigating pollution and conserving energy. The thermal-performance of a solar heater was analyzed using experimental simulations. Different types of artificial roughness, such as delta-winglet-vortex generators, ribs, or a combination of ribs and delta-winglet, were tested in a single-pass solar air heater. The objective of this study is to identify the optimal design that maximizes the thermal efficiency of a solar air heater. The relative roughness height-ratio remains constant at 0.6, although the pitch ratio is fixed at 10 and various attack angles are used. The experimental investigation was conducted within a range of Reynolds numbers (5000-14000). The usual levels of irradiance varied as 330 W/m2 - 850 W/m2. Based on the results, the average bulk temperature of the roughened solar air heater was 37% greater than that of a smooth SAH under peak sun irradiation. The inclined ribs at a 60° angle exhibited superior thermal efficiency compared to the other instances. These ribs covered a greater surface area and greatly enhanced the convective heat-transfer rate.
KW  - Artificial Roughness
KW  - Friction
Factor
KW  - Solar Air Heater
KW  - Thermal Efficiency
CR  - [1]	Raitila J, Tsupari E. Feasibility of solar-enhanced drying of woody biomass. Bioenerg Res 2019;13:210–221. [CrossRef]
CR  - [2]	Chemkhi S, Zagrouba F, Bellagi A. Drying of agricultural crops by solar energy. Desalination 2004;168:101–109. [CrossRef]
CR  - [3]	Jamali B, Rasekh M, Jamadi F, Gandomkar R, Makiabadi F. Using PSO-GA algorithm for training artificial neural network to forecast solar space heating system parameters. Appl Therm Engineer 2019;147:647–660. [CrossRef]
CR  - [4]	Taslim ME, Li T, Kercher DM. Experimental heat transfer and friction in channels roughened with angled, V-shaped, and discrete ribs on two opposite walls. ASME J Turbomach 1996;118:20–28. [CrossRef]
CR  - [5]	Thianpong C, Chompookham T, Skullong S, Promvonge P. Thermal characterization of turbulent flow in a channel with isosceles triangular ribs. Int Comm Heat Mass Transf 2009;36:712–717. [CrossRef]
CR  - [6]	Nidhul K, Yadav AK, Anish S, Kumar S. Critical review of ribbed solar air heater and performance evaluation of various V-rib configuration. Renew Sustain Energy Rev 2021;142:110871. [CrossRef]
CR  - [7]	Bezbaruah PJ, Das RS, Sarkar BK. Experimental and numerical analysis of solar air heater accoutered with modified conical vortex generators in a staggered fashion. Renew Energy 2021;180:109–131. [CrossRef]
CR  - [8]	Mushatet K, Nashee S. Experimental and computational investigation for 3-D duct flow with modified arrangement ribs turbulators. Therm Sci 2021;25:1653–1663. [CrossRef]
CR  - [9]	Nashee SR, Mushatet KS. 3D numerical and experimental analysis for turbulent flow and heat transfer in a duct integrated with ribs turbulators. TEST Engineer Manage 2020;83:21810–21821.
CR  - [10]	Mushatet KS, Edan IL. Effect of winglet vortex generators orientation on heat transfer enhancement. Int J Mech Mechatron Engineer 2018;18:8–24.
CR  - [11]	Kumar A, Layek A. Evaluation of the performance analysis of an improved solar air heater with Winglet shaped ribs. Exp Heat Transf 2022;35:239–257. [CrossRef]
CR  - [12]	Rajendran V, Singaraj K, Rajarathinam J. Environmental, economic, and performance assessment of solar air heater with inclined and winglet baffle. Environ Sci Pollut Res Int 2023;30:14337–14352. [CrossRef]
CR  - [13]	Bader NM, Mushatet KS. Thermal performance improvement of artificially roughened solar air heater. Engineer Rev 2022;43:66–81. [CrossRef]
CR  - [14]	Mushatet KS, Bader NM. Experimental investigation for the performance of the solar air dryer with vortex generator. Defect Diffus Forum 2022;419:57–67. [CrossRef]
CR  - [15]	Hajabdollahi H. Thermoeconomic assessment of integrated solar flat plate collector with cross flow heat exchanger as solar air heater using numerical analysis. Renew Energy 2021;168:491–504. [CrossRef]
CR  - [16]	Chamoli S, Lu R, Xu D, Yu P. Thermal performance improvement of a solar air heater fitted with winglet vortex generators. Sol Energy 2018;159:966–983. [CrossRef]
CR  - [17]	Zhao Z, Luo L, Qiu D, Wang Z, Sunden B. On the solar air heater thermal enhancement and flow topology using differently shaped ribs combined with delta-winglet vortex generators. Energy 2021;224:119944. [CrossRef]
CR  - [18]	Rout SK, Mishra DP, Thatoi DN, Acharya AK. Numerical analysis of mixed convection through an internally finned tube. Adv Mech Engineer 2012;4:918342. [CrossRef]
CR  - [19]	Rout SK, Thatoi DN, Acharya AK, Mishra DP. CFD supported performance estimation of an internally finned tube heat exchanger under mixed convection flow. Procedia Engineer 2012;38:585–597. [CrossRef]
CR  - [20]	Rout SK, Pulagam MKR, Sarangi SK. Prospect of a fully solar energy-driven compact cold store for low income farming communities. In: Ramgopal M, Rout SK, Sarangi SK, eds. Advances Air Conditioning and Refrigeration Singapore: Springer; 2021. pp. 13–21. [CrossRef]
CR  - [21]	Rout SK, Mohapatra T, Mohanty CP, Mishra P. Experimental investigation of thermal performance of solar air heater having hemispherical fins on absorber plates. In: Ramgopal M, Rout SK, Sarangi SK, editors. Advances Air Conditioning and Refrigeration Singapore: Springer; 2021. pp. 337–343. [CrossRef]
CR  - [22]	Hannun RM, Hamoud MA. Comparison study for the utilization of solar power with different positions lie in Iraq and on the equator and northern region. Thesis, University of Thi-Qar, Iraq; 2021.
CR  - [23]	Ekechukwu O, Norton B. Review of solar-energy drying systems II: An overview solar drying technology. Energy Conver Manage 1999;40:615–655. [CrossRef]
CR  - [24]	Joudi KA. Some aspects of solar irradiance calculations. In: Proceedings of the 3rd Arab International Solar Energy Conference; Feb 1988; Baghdad.
CR  - [25]	Ekechukwu OV, Norton B. Review of solar-energy drying systems III: Low temperature air-heating solar collectors for crop drying applications. Energy Conver Manage 1999;40:657–667. [CrossRef]
CR  - [26]	Ebrahim MA, Saini JS, Solanki SC. Heat transfer and friction in solar air heater duct with V-shaped rib roughness on absorber plate. Int J Heat Mass Transf 2002;45:3383–3396. [CrossRef]
CR  - [27]	Sivakandhan C, Arjunan TV, Matheswaran MM. Thermohydraulic performance enhancement of a new hybrid duct solar air heater with inclined rib roughness. Renew Energy 2020;147:2345–2357. [CrossRef]
UR  - https://dergipark.org.tr/en/pub/thermal/issue//1546881
L1  - https://dergipark.org.tr/en/download/article-file/4202779
ER  -