dubi̇ted Duzce University Journal of Science and Technology 2148-2446 Duzce University 10.29130/dubited.1749574 Wind Energy Systems Rüzgar Enerjisi Sistemleri Performance Evaluation of a Wind Turbine at High Altitudes Using an Aerostat-Based Stabilized Platform Bir Aerostat Tabanlı Stabilize Platform Kullanılarak Yüksek İrtifalarda Bir Rüzgar Türbininin Performans Değerlendirmesi https://orcid.org/0000-0002-2445-0220 Isilak Cemal ERZINCAN UNIVERSITY, ALI CAVIT CELEBIOGLU SCHOOL OF CIVIL AVIATION https://orcid.org/0000-0003-4345-761X Üncü İsmail Serkan ISPARTA UNIVERSITY OF APPLIED SCIENCES 04 19 2026 14 2 525 536 07 23 2025 02 24 2026 Copyright © 2013, Duzce University Journal of Science and Technology 2013 Duzce University Journal of Science and Technology

This study aims to evaluate and quantify wind turbine performance aloft using a field-deployable tethered aerostat test platform, combining a lightweight horizontal-axis turbine, a conical diffuser, and synchronized onboard measurements of atmospheric conditions and electrical output. The platform is designed to enable higher-altitude operation (up to ~500 m), while the results presented in this study are based on field measurements up to ~60 m. Field measurements show that the mean wind speed increased from approximately 4.6 m/s at 20 m to 6.1 m/s at 60 m, producing a corresponding rise in electrical power output from ~37 W at the lowest recorded operating point (V≈2.6 m/s) to a maximum of ~52 W at around 50 m altitude (V≈6.1 m/s), consistent with the cubic wind–power relationship. The conical diffuser was additionally assessed under comparable wind conditions (~6.1 m/s) and provided a modest gain from 50 W to 52 W (≈ 4%) for the present geometry. These results indicate that height-adjustable lighter-than-air deployment can improve energy yield in low-wind regions without tower infrastructure by leveraging the vertical wind gradient, while highlighting that diffuser benefits are measurable but limited under the tested conditions and merit further geometric optimization and repeated trials.

Bu çalışma, aktif stabilizasyon sistemine sahip helyum dolu bağlı bir aerostat kullanarak yüksek irtifalarda rüzgar türbini performansının değerlendirilmesine yönelik yenilikçi bir yaklaşım sunmaktadır. Aerostat platformu, hafif bir yatay eksenli rüzgar türbinini yaklaşık 500 metreye kadar yükseltebilmekte ve böylece yer tabanlı sistemlerin erişemediği daha güçlü, daha istikrarlı ve daha az türbülanslı rüzgar akımlarından faydalanma imkânı sağlamaktadır. Güç üretim verimliliğini en üst düzeye çıkarmak amacıyla, stabilizasyon mekanizması türbinin hâkim rüzgar yönlerine sürekli olarak hizalanmasını ve atmosferik türbülans kaynaklı dinamik kararsızlıkların en aza indirilmesini sağlar.Deneysel yapılandırma, anemometreler, barometrik altimetreler, sıcaklık sensörleri ve GPS modülleri dahil olmak üzere kapsamlı bir çevresel sensör seti içermekte ve gerçek zamanlı atmosferik verilerin yüksek hassasiyetle toplanmasını sağlamaktadır. Aynı anda, elektriksel çıkış parametreleri—gerilim, akım ve buna bağlı güç—sürekli olarak kaydedilmekte ve analiz edilmektedir. Bu güçlü veri toplama yaklaşımı, farklı meteorolojik koşullar altında ayrıntılı performans değerlendirmelerine olanak tanımaktadır. Elde edilen deneysel bulgular, aerostat tabanlı platformlarla yüksek irtifalarda konuşlandırılan rüzgar türbinlerinin enerji üretim performansını önemli ölçüde artırdığını göstermekte olup, bu teknolojiyi geleneksel kule tabanlı kurulumların coğrafi veya ekonomik olarak uygulanmasının zor olduğu durumlarda umut verici bir alternatif olarak öne çıkarmaktadır

 Aerostat system High-altitude wind energy Wind turbine performance Renewable energy Aerostat sistemi Yüksek irtifa rüzgar enerjisi Rüzgar türbini performansı Yenilenebilir enerji This research received no external funding. Ackermann, T. (Ed.). (2005). Wind power in power systems. John Wiley & Sons. https://doi.org/10.1002/0470012684 Adhikari, J., & Panda, S. K. (2015). Generation and transmission of electrical energy in high-altitude wind power generating system. IEEE Journal of Emerging and Selected Topics in Power Electronics, 3(2), 459–470. https://doi.org/10.1109/JESTPE.2015.2388702 Adhikari, J., Prasanna, I. V., & Panda, S. K. (2016). Power conversion system for high altitude wind power generation with medium voltage AC transmission. Renewable Energy, 93, 562–578. https://doi.org/10.1016/j.renene.2016.03.004 Alam, M. I., Pasha, A. A., Jameel, A. G. A., & Ahmed, U. (2023). High altitude airship: A review of thermal analyses and design approaches. Archives of Computational Methods in Engineering, 30(3), 2289–2339. https://doi.org/10.1007/s11831-022-09867-9 Ali, Q. S., & Kim, M.-H. (2022). Quantifying impacts of shell augmentation on power output of airborne wind energy system at elevated heights. Energy, 239, Article 121839. https://doi.org/10.1016/j.energy.2021.121839 Archer, C. L., & Caldeira, K. (2009). Global assessment of high-altitude wind power. Energies, 2(2), 307–319. https://doi.org/10.3390/en20200307 Bafandeh, A., & Vermillion, C. (2017). Altitude optimization of airborne wind energy systems via switched extremum seeking—Design, analysis, and economic assessment. IEEE Transactions on Control Systems Technology, 25(6), 2022–2033. https://doi.org/10.1109/TCST.2016.2632534 Bayati, M. (2024). Design and performance evaluation of a mid-range airborne wind turbine. Arabian Journal for Science and Engineering, 49, 15021–15036. https://doi.org/10.1007/s13369-024-08926-6 Cherubini, A., Papini, A., Vertechy, R., & Fontana, M. (2015). Airborne wind energy systems: A review of the technologies. Renewable and Sustainable Energy Reviews, 51, 1461–1476. https://doi.org/10.1016/j.rser.2015.07.053 Cheynet, E., Diezel, J. M., Haakenstad, H., Breivik, Ø., Peña, A., & Reuder, J. (2025). Tall wind profile validation of ERA5, NORA3, and NEWA datasets using lidar observations. Wind Energy Science, 10(4), 733–754. https://doi.org/10.5194/wes-10-733-2025 Çiftçi, A., & Dursun, M. (2017). Maximum power point tracking algorithm with permanent magnet synchronous generator used ın variable speed wind turbines. Duzce University Journal of Science and Technology, 5(2), 356–369. Diehl, M. (2013). Airborne wind energy: Basic concepts and physical foundations. In U. Ahrens, M. Diehl, & R. Schmehl (Eds.), Airborne wind energy (pp. 3–22). Springer. https://doi.org/10.1007/978-3-642-39965-7_1 Elshazly, E., Ye, Z., Chaer, I., & Elbaz, A. M. R. (2025). Design parameters of a lighter than air wind energy system and its applicability in Egypt. Results in Engineering, 25, Article 104365. https://doi.org/10.1016/j.rineng.2025.104365 Fathi, M., Bayati, M., & Farahani, G. (2022). New methodology for preliminary design of buoyant shrouded airborne wind energy system. Journal of The Institution of Engineers (India): Series C, 103(6), 1399–1413. https://doi.org/10.1007/s40032-022-00883-z Greenhalgh, D. (2017). Aerostat for electric power generation [Doctoral thesis, University of Southampton]. ePrints Soton. https://eprints.soton.ac.uk/415870/ Hao, Y., Li, Z., Yang, Y., Du, Q., & Wang, B. (2025). Design of a universal safety control computer for aerostats. Electronics, 14(9), Article 1880. https://doi.org/10.3390/electronics14091880 He, H., Niu, X., Li, X., Cai, Y., Li, L., Ye, X., & Wang, J. (2025). Characteristics of wind profiles for airborne wind energy systems. Energies, 18(9), Article 2373. https://doi.org/10.3390/en18092373 Huang, Q., Shi, Y., Wang, Y., Lu, L., & Cui, Y. (2015). Multi-turbine wind-solar hybrid system. Renewable Energy, 76, 401–407. https://doi.org/10.1016/j.renene.2014.11.060 Korukçu, M. Ö. (2021). Solidity optimization for an H-Darrieus wind turbine. Duzce University Journal of Science and Technology, 9(2), 535–544. https://doi.org/10.29130/dubited.813917 Kosasih, B., & Tondelli, A. (2012). Experimental study of shrouded micro-wind turbine. Procedia Engineering, 49, 92–98. https://doi.org/10.1016/j.proeng.2012.10.116 Lansdorp, B., & Williams, P. (2006, September 18–21). The Laddermill—Innovative wind energy from high altitudes in Holland and Australia [Conference paper]. Proceedings of Global Windpower 06, Adelaide, Australia. TU Delft Repository. http://resolver.tudelft.nl/uuid:9ebe67f0-5b2a-4b99-8a3d-dbe758e53022 Lunney, E., Ban, M., Duic, N., & Foley, A. (2017). A state-of-the-art review and feasibility analysis of high altitude wind power in Northern Ireland. Renewable and Sustainable Energy Reviews, 68(2), 899–911. https://doi.org/10.1016/j.rser.2016.08.014 Ohya, Y., & Karasudani, T. (2010). A shrouded wind turbine generating high output power with wind-lens technology. Energies, 3(4), 634–649. https://doi.org/10.3390/en3040634 Patel, M. R. (2005). Wind and solar power systems: Design, analysis, and operation (2nd ed.). CRC Press. https://doi.org/10.1201/9781420039924 Qu, W., He, X., Duan, C., Qin, Y., He, Z., & Yang, Y. (2024). Study on the influence of tip clearance on working characteristics of high-altitude fan. Aerospace, 11(10), Article 823. https://doi.org/10.3390/aerospace11100823 Süzer, A. E., Atasoy, V. E., & Ekici, S. (2022). A framework on the investigation of wind characteristics based on Weibull distribution function by comparative scrutiny of estimation methods: Application to an airport. International Journal of Green Energy, 19(3), 254–269. https://doi.org/10.1080/15435075.2021.1941049 Tanürün, H. E., & Acır, A. (2022). Investigation of the hydrogen production potential of the H-Darrieus turbines combined with various wind-lens. International Journal of Hydrogen Energy, 47(55), 23118–23138. https://doi.org/10.1016/j.ijhydene.2022.04.196 Urtasun, A., Sanchis, P., San Martín, I., López, J., & Marroyo, L. (2013). Modeling of small wind turbines based on PMSG with diode bridge for sensorless maximum power tracking. Renewable Energy, 55, 138–149. https://doi.org/10.1016/j.renene.2012.12.035