jnse

Journal of Naval Sciences and Engineering

1304-2025

Millî Savunma Üniversitesi

10.56850/jnse.1784964

Electrical Energy Transmission, Networks and Systems High Voltage Electrical Engineering (Other)

Elektrik Enerjisi Taşıma, Şebeke ve Sistemleri Yüksek Gerilim Elektrik Mühendisliği (Diğer)

KABLO KESİTİNİN YERALTI XLPE KABLOLARINDA KISMI DEŞARJ KONUMLANDIRMASINA ETKİSİ

EFFECT OF THE CABLE CROSS-SECTION FOR LOCATING PARTIAL DISCHARGES IN UNDERGROUND XLPE CABLES

https://orcid.org/0000-0003-2032-2261

Atsever

Mert Bekir

DENİZ HARP OKULU KOMUTANLIĞI, DENİZ HARP OKULU (DEKANLIK), ELEKTRİK ELEKTRONİK MÜHENDİSLİĞİ BÖLÜMÜ

https://orcid.org/0000-0001-6430-3009

Yarkan

Serhan

FENERBAHÇE ÜNİVERSİTESİ, MÜHENDİSLİK VE MİMARLIK FAKÜLTESİ

https://orcid.org/0000-0001-6528-3812

Hocaoğlu

Mehmet Hakan

İstanbul Ticaret Üniversitesi Mühendislik Fakültesi

Advanced Online Publication 1 22 09 16 2025 11 11 2025

2003

Journal of Naval Sciences and Engineering

Yer altı kablolarında sık sık PD olayı yaşanmaktadır. Zamanla bu PD’ler kalıcı ve tehlikeli arızalara neden olarak kablolarda geri döndürülemez hasarlara ve dolayısıyla arz güvenliğinde azalmaya neden olabilir. Bu nedenle PD’lerin yerlerinin tespit edilmesi ve kalıcı arızaya dönmeden müdahale edilmesi gerekmektedir. PD konumu temel yürüyen dalga denklemleri ile tespit edilebilmektedir. Bu nedenle kablo kesitinin PD konumuna etkisi kaçınılmazdır. Bu çalışmada farklı kablo kesitlerinde aynı PD konumu içi farklı mesafeler bulunduğu tespit edilmiştir. Sonuçlar bir kablo fiderinin EMTP-ATP Draw’da kapsamlı simülasyon modeli üzerinde gösterilmiştir. Simülasyon verileri gerçek arazi ile uyumludur.

Partial discharge (PD) frequently occurs in underground cables. Gradually, these discharges can lead to permanent and hazardous faults, causing severe damage to the cable insulation and distribution in the service quality. Therefore, it is crucial to accurately locate PD sources and intervene before they evolve into irreversible failures. PD location can be determined using fundamental traveling wave equations. Therefore, cable cross-section significantly affects the cable parameters and eventually performance of PD localization method is hindered. In this study, it was observed that identical PD sources yielded different location estimates when cable cross-sections are varied. These results were demonstrated through a comprehensive simulation model of a cable feeder developed in EMTP-ATP Draw program using actual field data.

partial discharge location cable modelling

kısmi deşarj konum tespiti kablo modellemesi

EMRA (Energy Market Regulatory Authority).

1353221

Alqtish, M., Di Fatta, A., Rizzo, G., Akbar, G., Li Vigni, V., Imburgia, A., Ala, G., Candela, R., & Romano, P. (2025). “A review of partial discharge electrical localization techniques in power cables: Practical approaches and circuit models”. Energies, 18(10), 2583.

Atsever, M. B., Boyaci, A., Yarkan, S., & Hocaoglu, M. H. (2024). Onsite partial discharge detection and location system for underground cables using USRP-based measurement system. In 2024 6th Global Power, Energy and Communication Conference (GPECOM) (pp. 368–373). Budapest, Hungary.

Atsever, M. B., Deveci, U., Yuzgulec, S., Mesci, N., Yılmaz, S. C., Yarkan, S., & Hocaoglu, M. H. (2024). EMTP-ATP Draw based model for performance evaluation of onsite partial discharge measurement for underground XLPE cables. In 2024 3rd International Conference on Power Systems and Electrical Technology (PSET) (pp. 833–838). Tokyo, Japan.

Atsever, M. B., Yarkan, S., & Hocaoğlu, M. H. (2025). “Onsite non-invasive partial discharge detection and location system for underground cables using customized envelope detection” Measurement, 256, Article 117911.

Ba, X., Li, J., Pan, Y., Zeng, Y., Kou, H., Liu, W., Liu, J., Wu, L., & Guo, J. (2013). “Comparison of aqueous- and non-aqueous based tape casting for preparing YAG transparent ceramics” Journal of Alloys and Compounds, Vol. 577, pp. 228-231.

El Bahı Azzag, & Touaibia, I. (2019). “Cable fault location in medium voltage of Sonelgaz underground network.” Revue de Synthèse, 25(1), 33–44.

Feng, Z., Qi, J., & Lu, T. (2020). “Highly-transparent AlON ceramic fabricated by tape-casting and pressureless sintering method”. Journal of European Ceramic Society, Vol. 40, Issue 4, pp. 1168-1173.

Figiel, P., Rozmus, M., & Smuk, B. (2011). “Properties of alumina ceramics obtained by conventional and non-conventional methods for sintering ceramics”. Journal of Achievements in Materials and Manufacturing Engineering, Vol. 48, Issue 1, pp. 29-34.

Granado, J., Álvarez-Arroyo, C., Torralba, A., Rosendo-Macías, J. A., Chávez, J., & Burgos-Payán, M. (2015). “Time-domain analysis of partial discharges envelope in medium voltage XLPE cables.” Electric Power Systems Research, 125, 220–227.

Manotham, S., Channasanon, S., Nanthananon, P., Tanodekaew, S., & Tesavibul, P. (2021). “Photosensitive binder jetting technique for the fabrication of alumina ceramic”. Journal of Manufacturing Processes, Volume 62, pp. 313-322.

Mardiana, R., & Su, C. Q. (2010). “Partial discharge location in power cables using a phase difference method. ” IEEE Transactions on Dielectrics and Electrical Insulation, 17(6), 1738–1746.

Morales, A., & Ardila-Rey, J. A. (2023). “A review on partial discharge diagnosis in cables: Theory, techniques, and trends.” Measurement: Journal of the International Measurement Confederation, 216, Article 112882.

Robles, G., Martinez, J. M., Sanz, J., Tellini, B., Zappacosta, C., & Rojas, M. (2008). Designing and tuning an air-cored current transformer for partial discharges pulses measurements. 2008 IEEE Instrumentation and Measurement Technology Conference, Victoria, BC, Canada, 2021–2025.

Robles, G., Shafiq, M., & Martínez-Tarifa, J. M. (2019). “Designing a Rogowski Coil with Particle Swarm Optimization.” Proceedings of 5th International Electronic Conference on Sensors and Applications), 4(1), 10.

Rohani, M. N. K. H., Isa, M., Sukardi, A. B., Ismail, B., Rosmi, A. S., & Mustafa, W. A. (2016). “Geometrical shapes impact on the performance of ABS-based coreless inductive sensors for PD measurement in HV power cables.” IEEE Sensors Journal, 16(17), 6625–6632.

Serttaş, F., & Hocaoglu, F. O. (2025). “A novel partial discharge signal detection and estimation method: Mycielski algorithm. ” Electrical Engineering, 107*, 2829–2843.

Shafiq, M., Hussain, G. A., Kütt, L., Elkalashy, N. I., & Lehtonen, M. (2015). “Partial Discharge Diagnostic System for Smart Distribution Networks Using Directionally Calibrated Induction Sensors.” Electric Power Systems Research, 119(2), 447–461. https://doi.org/10.1016/j.epsr.2014.10.027

Shafiq, M., Kütt, L., Lehtonen, M., Nieminen, T., & Hashmi, M. (2013). “Parameters identification and modeling of high-frequency current transducer for partial discharge measurements.” IEEE Sensors Journal, 13(3), 1081–1091.

Shamsoddini, M., Lan, T., Ko, S., & Chung, C. Y. (2025). “AI-driven single-end partial discharge localization in power cables based on time domain reflectometry and transfer function analyses” Electric Power Systems Research, 245, Article 111601.

Sukardi, A. B., Rohani, M. N. K. H., Isa, M., Ismail, B., Rosmi, A. S., & Mustafa, W. A. (2018). “Modelling of single power line by ATP-Draw for partial discharge signal measurement.” In 5th IET International Conference on Clean Energy and Technology (CEAT2018) (pp. 1–6). Kuala Lumpur, Malaysia.

Yan, Y., Zhao, Y., Zhao, K., Trinchero, R., Stievano, I. S., & Li, H. (2023). “A practical partial discharge localization technique for HV cables. ” IET Generation, Transmission & Distribution, 17(11), 2523–2534.

Zhang, X., Pang, B., Liu, Y., Liu, S., Xu, P., Li, Y., Liu, Y., Qi, L., & Xie, Q. (2021). “Review on detection and analysis of partial discharge along power cables.” Energies, 14(22), 7692.

Zhou, C., Yi, H., & Dong, X. (2017). “Review of recent research towards power cable life cycle management” IET High Voltage, 2(3), 179–187