INFLUENCE OF PH ON THE STRUCTURAL AND MORPHOLOGICAL PROPERTIES OF ZnS THIN FILMS

Yıl 2010, Cilt: 11 Sayı: 1, 17 - 22, 24.09.2010

A Kassım W.t Tan S.m Ho N Saravanan

Öz

The ZnS thin films have been obtained from aqueous solution by means of cyclic voltammetry method. The electrochemical bath consisted of zinc sulphate, sodium thiosulfate and triethanolamine.

The effect of electrolyte pH on the properties of ZnS thin films was investigated within the range from 3 to 9. The cyclic voltammetry was used to analyse the electrochemical bath. The structural and morphological of thin films were investigated by X-ray diffraction and atomic force microscopy, respectively.

The thin films obtained have cubic structure and single phase as analysed by XRD. As the pH was reduced from 9 to 3, the intensities of the peaks corresponding to ZnS increased. AFM image shows the thin films prepared at pH 3 are homogeneous and well covered on the substrate. These thin films consist of small grains which lead to deposition of smoother films. However, as the pH increases up to 7, the number of grains decreases and larger grain size could be obtained. Therefore, the pH plays a major role in synthesis of ZnS thin film and the pH 3 is the best pH under current conditions.

Anahtar Kelimeler

-

Uygulamalı Bilimler ve Mühendislik

Öz

ZnS ince filmler çevrimsel voltametri yöntemiyle sulu çözeltiden elde edilmiştir. Elektrokimyasal banyo çinko sülfat, sodyum tiosulfat ve triethnalomine içermiştir. ZnS yapısal özellikleri üzerine elktrolitin pH etkisi 3-9 aralıklar arasında incelenmiştir. Çevrimsel voltametri elektro-kimyasal banyoyu analiz etmek için kullanılmıştır. Atomik kuvvet mikroskopu ve X-ışınları (XRD) kırınımı analizleri ile ince filmler yapısal ve morfolojik olarak incelenmiştir. Zns yapılar kübik yapıda ve tek fazlı olduğu XRD sonuçlarından elde edilmiştir. pH değeri 9’dan 3’ e indirgendiğinde ZnS pik şiddetlerinin azaldığı gözlenmiştir. pH 3’de hazırlanan örneklerin kuvvet mikroskopu analizleri bu filmlerin alttaş ile uyumlu olarak büyüdüğü gösterilmiştir. Bu ince filmler bundan başka küçük tane büyüklüğüne sahip oldukları bu çalışmada gösterilmiştir. Diğer taraftan banyonun pH değeri 7’ye kadar arttırıldığına tane sayısı azalmış ve fakat tane büyüklüğü artmıştır. Böylece pH 3 değerindeki banyolamanın ince film hazırlamada önemli bir etkisi olduğu bu çalışma ile gösterilmiştir

Anahtar Kelimeler

Çevrimsel voltmetri, İnce film, Zinc sülfür, Metal kalgonide

Kaynakça

• Anuar, K., Tan, W.T., Atan, M.H., Dzulkefly, K.A., Md. Jelas, H., Ho, S.M. and Na- galingam, S. (2009). Influence of bath temperature and pH value on properties of chemically deposited Cu4SnS4 thin films. Journal of the Chilean Chemical Society 54(3), 256-259.
• Dubrovin, I.V., Budennaya, L.D., Mizetskaya, I.B. and Sharkina, E.V. (1983). Inorg. Mater. 19, 1603-1608.
• Jiang, T., Hall, N., Ho, A. and Morin, S. (2005). Quantitative analysis of electrodeposited tin film morphologies by atomic force mi- croscopy. Thin Solid Films 417, 76-85.
• Ezema, F.I., Nnabuchi, M.N. and Osuji, R.U. (2006). Optical properties of CuS thin films deposited by chemical bath deposi- tion technique and their applications. Trends in Applied Sciences Research 1(5), 467-476.
• Huang, J.F., Zhu, H., Cao, L.Y., Wu, J.P. and He, H.Y. (2008). Influence of pH value on the ZnS optical thin films prepared by electrodeposition. Journal of Synthetic Crystals 37(4), 862-865.
• Ihanus, J., Ritala, M., Leskela, M., Prohaska, T., Resch, R., Friedbacher, G. and Grasser- bauer, M. (1997). AFM studies on ZnS thin films grown by atomic layer epitaxy. Applied Surface Science 120(1-2), 43-50.
• Kale, R.B., Lokhande, C.D., Mane, R.S. and Han, S.H. (2007). Cd0.5Zn0.5Se wide range composite thin films for solar cell buffer layer application. Applied Surface Science 253, 3109-3112.
• Kumar, P., Kumar A., Dixit, P.N. and Sharma, T.P. (2006). Optical, structural and elec- trical properties of zinc sulphide vacuum evaporated thin film. Indian Journal of Pure and Applied Physics 44(9), 690-693.
• Mane, R.S., Todkar, V.V. and Lokhande, C.D. (2004). Low temperature synthesis of nanocrystalline As2S3 thin films using novel chemical bath deposition route. Ap- plied Surface Science 227, 48-55.
• McLaughlin, M., Sakeek, H.F., Maguire, P., Graham, W.G., Molloy, J., Morrow, T., Laverty, S. and Anderson, J. (1993). Properties of ZnS thin films prepared by 248-nm pulsed laser deposition. Applied Physics Letters 63(14), 1865-1867.
• Uygulamalı Bilimler ve Mühendislik
• Moualkia, H., Hariech, S. and Aida, M.S. (2009). Properties of CdS thin films grown by chemical bath deposition as a function of bath temperature. Materials Science Forum 609, 243-247.
• Nadaud, N., Lequeux, N., Nanot, M., Jove, J. and Roisnel, T. (1998). Structural studies of tin-doped indium oxide (ITO) and In4Sn3O12. Journal of Solid State Chemis- try 135(1), 140-148.
• Riveros, G., Gomez, H., Henriquez, R., Sshrebler, R. and Cordova, R. (2002). Electrodeposition and characterization of ZnX (X=Se, Te) semiconductor thin films. Boletin de la Sociedad Chilena de Quimica 47(4), 411-429.
• Subramanian, B., Sanjeeviraja, C. and Jaya- chandran, M. (2001). Cathodic electrode- position and analysis of SnS films for photoelectrochemical cells. Materials Chemistry and Physics 71, 40-46.
• Wu, X., Lai, F., Lin, L., Lv, J., Zhuang, B., Yan, Q. and Huang, Z. (2008). Optical inho- mogenity of ZnS films deposited by ther- mal evaporation. Applied Surface Science 254(20), 6455-6460.
• Yazici, A.N., Oztas, M. and Bedir, M. (2003). Effect of sample producing conditions on the thermoluminescence properties of ZnS thin films developed by spray pyrolysis method. Journal of Luminescence 104(1- 2), 115-122.
• Zhou, L., Xue, Y. and Li, J. (2009). Study on ZnS thin films prepared by chemical bath deposition. Journal of Environmental Sci- ences 21(1), S76-S79.