The Production and Characterization of Seashell Reinforced Epoxy Composite Material

Yıl 2023, Cilt: 6 Sayı: 2, 116 - 123, 18.12.2023

Cihat Aydın , Sinan Avcı

https://doi.org/10.54565/jphcfum.1396541

Öz

In this study, it was aimed to examine the production, characterization and mechanical properties of epoxy matrix composites added with seashells collected from different coastal locations of the Mersin Region, which is a natural raw material. Natural seashells with different mass ratios were ground into different sizes and added into epoxy, the matrix material. By performing physical and chemical characterization of the produced composites, the next step is to analyze and produce the product with the best and most superior properties.

Anahtar Kelimeler

Natural raw materials, Waste product, Epoxy, Composite, Reinforcement

Destekleyen Kurum

Mersin University

Proje Numarası

This work was supported by the Management Unit of Scientific Research Projects of Mersin University (BAP) (Project Number: 2020-1-TP2-4035).

Teşekkür

This work was supported by the Management Unit of Scientific Research Projects of Mersin University (BAP) (Project Number: 2020-1-TP2-4035). Authors wish to thank Mersin University BAP. This article was derived from Sinan Avci's master's thesis, Mersin University Institute of Science and Technology, Department of Nanotechnology and Advanced Materials.

Kaynakça

• Ateş, E., Aztekın, K. (2011). Parçacık ve fiber takviyeli polimer kompozilerin yoğunluk ve basma dayanımı özellikleri. Journal of the Faculty of Engineering & Architecture of Gazi University, 26(2).
• Mustaţă, F., & Cascaval, C. N. (1997). Rheological and thermal behaviour of an epoxy resin modified with reactive diluents. Journal of polymer engineering, 17(6), 491-506.
• Mustata, F., Cascaval, CN. and Bicu, I. (1995). Viscosimetric investigation of plasticized epoxy resin. Polymer Plast Technol Eng, 34,461–73.
• Mustatâ, F., & Bicu, I. (1998). Plastified epoxy resins modified by hydrophilic and hydrophobic silica. Polymer–Plastics Technology and Engineering, 37(2), 127-140.
• Munz, M., Sturm, H., & Stark, W. (2005). Mechanical gradient interphase by interdiffusion and antiplasticisation effect—study of an epoxy/thermoplastic system. Polymer, 46(21), 9097-9112.
• Sánchez-Cabezudo, M., Prolongo, M., Salom, C., & Masegosa, R. (2006). Cure kinetics of epoxy resin and thermoplastic polymer. Journal of thermal analysis and calorimetry, 86(3), 699-705.
• Prolongo, MG., Arribas, C., Salom, C. and Masegosa, RM. (2007). Phase separation, cure kinetics, and morphology of epoxy/poly(vinyl acetate)blends. J Appl Polym Sci. 103, 1507–16.
• Nakamura, Y., Yamaguchi, M., Okubo, M.and Matsumoto, T. (1992). Effects of particle size on mechanical and impact properties of epoxy resin filled with spherical silica. J Appl Polym Sci. 45:s.1281–9.
• Erdogan, BC., Seyhan, AT., Ocak, Y., Tanoglu, M., Balkose, D., and Ulku, S. (2008). Cure kinetics of epoxy resin–natural zeolite composites. J Thermal Anal Calorim 94: s.743–7.
• Francis, B., Lakshmana Rao, V., Geert, VP., Posada, F., Groeninckx, G. and Ramaswamy, R.,(2006).et al. Cure kinetics, morphological and dynamic mechanical analysis of diglycidyl ether of bisphenol-A epoxy resin modified with hydroxyl terminated poly(etherether ketone) containing pendent tertiary buthyl groups. Polymer 47: s.5411–9.
• Francis, B., Thomas, S., Jose, J., Ramaswamy, R., Lakshmana Rao ,V. (2005). Hydroxyl terminated poly(ether ether ketone) with pendent methyl group toughened epoxy resin:miscibility, morphology and mechanical properties. Polymer 46: s.12372–85.
• Mazumdar, S. K.(2001). Composites manufacturing: Materials, product and process engineering. USA: CRC Press.
• Dai, H.(2001). Material, Process and Product Design of Thermoplastic Composite Materials,Prude University, Proquest Information and Learning.
• Sönmez, M. (2009). Polimer Matrisli Kompozitlerin Endüstri Ürünler Tasarımında Önemi Ve Geleceği: Türkiye’den Dört Örnek Firma Üzerine Bir İnceleme, İstanbul Teknik Üniversitesi, Fen Bilimleri Enstitüsü.
• Pala, İ. (2015). Tekstil lifleri ile takviyelendirilmiş kompozit malzemelerin ürün tasarımında kullanılması, İstanbul Teknik Üniversitesi, Fen Bilimleri Enstitüsü, s. 26.
• Aydin C., Aydin H. The synthesis and optical dispersions parameters of Cadmium doped Tin-oxide thin films by the Sol-Gel method, Journal of Physical Chemistry and Functional Materials, 4 (2021) 42-48.
• Aydin C, Synthesis of Pd:ZnO nanofibers and their optical characterization dependent on modified morphological properties, Journal of Alloys and Compounds, 777 (2019) 145-151.
• Aydin C, The functionalization of morphological, structural and optical properties of Fe doped SnO2 nanocrystals synthesized by the sol–gel method, Journal of Materials Science: Materials in Electronics, 29 (2018) 20087-20096.
• H. Aydin, C. Aydin, A.A. Al-Ghamdi, W.A. Farooq, F. Yakuphanoglu, Refractive index dispersion properties of Cr-doped ZnO thin films by sol-gel spin coating method, Optik, 127 (2016) 1879-1883.
• Aydin C, N.M. Khusayfan, A.A. Al-Ghamdi, F. El-Tantawy, W.A. Farooq, F. Yakuphanoglu, Facile synthesis, electrical and optical properties of Cu-doped GaN nanorods by sol-gel technique, Journal of Sol-Gel Science and Technology, 78 (2016) 68-75.
• Aydin H, H.M. El-Nasser, C. Aydin, A.A. Al-Ghamdi, F. Yakuphanoglu, Synthesis and characterization of nanostructured undoped and Sn-doped ZnO thin films via sol-gel approach, Applied Surface Science, 350 (2015) 109-114.
• Aydin H, A. Tataroglu, A.A. Al-Ghamdi, F. Yakuphanoglu, F. El-Tantawy, W.A. Farooq, A novel type heterojunction photodiodes formed junctions of Au/LiZnSnO and LiZnSnO/p-Si in series, Journal of Alloys and Compounds, 625 (2015) 18-25.
• A. Orhan, C. Aydin, H. Aydin, A.A. Al-Ghamdi, F. El-Tantawy, F. Yakuphanoglu, Synthesis and optical properties of iron doped gallium nitride nanostructures by sol gel method, Microsystem Technologies-Micro-and Nanosystems-Information Storage and Processing Systems, 21 (2015) 1219-1224.
• Aydin C, M.S. Abd El-sadek, K.B. Zheng, I.S. Yahia, F. Yakuphanoglu, Synthesis, diffused reflectance and electrical properties of nanocrystalline Fe-doped ZnO via sol-gel calcination technique, Optics and Laser Technology, 48 (2013) 447-452.
• M. Soylu, H. Aydin, A.A. Al-Ghamdi, W.A. Farooq, F. Yakuphanoglu, Study of optical and electrical assessments of the quaternary MgZnSnO system containing different Mg content, Journal of Materials Science: Materials in Electronics, 25 (2014) 4235-4245.
• H. Aydin, A. Tataroğlu, A.A. Al-Ghamdi, F. Yakuphanoglu, F. El-Tantawy, W.A. Farooq, A novel type heterojunction photodiodes formed junctions of Au/LiZnSnO and LiZnSnO/p-Si in series, Journal of Alloys and Compounds, 625 (2015) 18-25.
• H. Aydin, Electrical and Optical Properties of Titanium Dioxide-Carbon Nanotube Nanocomposites, Journal of Nanoelectronics and Optoelectronics, 9 (2014) 608-613.
• M. Benhaliliba, C.E. Benouis, F. Yakuphanoglu, A. Tiburcio-Silver, C. Aydin, S. Hamzaoui, Z. Mouffak, Detailed investigation of submicrometer-sized grains of chemically sprayed (Sn1−xAlx, O2) (0≤x≤0.085) thin films, Journal of Alloys and Compounds, 527 (2012) 40-47.
• H. Aydin, S.A. Mansour, C. Aydin, A.A. Al-Ghamdi, O.A. Al-Hartomy, F. El-Tantawy, F. Yakuphanoglu, Optical properties of nanostructure boron doped NiO thin films, Journal of Sol-Gel Science and Technology, 64 (2012) 728-733.