Research Article

Modified tension band wiring technique for olecranon fractures: where and how should the K-wires be inserted to avoid articular penetration?

Volume: 49 Number: 2 May 22, 2015
  • Mehmet Ozsoy
  • Onur Kizilay
  • Ceren Gunenc
  • Arzu Ozsoy
  • Deniz Demiryurek
  • Mutlu Hayran
  • Burcu Ercakmak
  • Abdurrahman Sakaogullari
TR EN

Modified tension band wiring technique for olecranon fractures: where and how should the K-wires be inserted to avoid articular penetration?

Abstract

Objective: Articular penetration of K-wires is a possible complication of the modified tension band wiring technique. However, there is no clear information or evidence regarding the entry point or introduction angle for K-wires to avoid this complication. The aim of this experimental study was to evaluate the effect of varying K-wire insertion points and angles on the risk for articular penetration during modified tension band wiring for olecranon fractures.

Methods: All anatomical measurements were made on 50 cadaveric ulnas, and all other measurements were performed on exact foam replications of the 50 cadaveric ulnas. Morphometric measurements, including olecranon height and heights of the central, radial and ulnar facets of the semilunar notch, were taken. In the sagittal plane, articular angle and tubercle angle were measured. Two 1.6-mm parallel K-wires were inserted from 0, 5 and 8 mm anterior to the dorsal cortex of the olecranon process at angles of 20Åã and 30Åã. K-wire articular penetration was evaluated both visually and radiographically.

Results: The mean central, radial and ulnar heights of the semilunar notch were 17.3 mm (14.7–20.0),16.2 mm (12.0–21.0) and 15.8 mm (13.30–20.5), respectively. We observed no articular penetration at the 0-mm level at 20Åã and 30Åã (0 mm 20Åã and 0 mm 30Åã, respectively) or at 5 mm 20Åã. At 8 mm 30Åã wire introduction, more than 64% articular penetration was observed on either facet. The sequence from least to most likely to cause articular penetration was: 0 mm = 5 mm 20Åã > 5 mm 30Åã = 8 mm 20Åã > 8 mm 30Åã. The radial height of the semilunar notch was negatively correlated to the risk of articular penetration, when the wire was introduced at 8 mm 30Åã, 8 mm 20Åã and 5 mm 30Åã (all p<0.047). There were poor correlations between radiological and direct observational assessments, particularly for 8 mm 20Åãand 5 mm 30Åã. The frequency of intra-articular positioning for those observed to be radiologically extra-articular was 4/28 (14.3%) for 8 mm 30Åã, 4/7 (57.1%) for 8 mm 20Åã and 5/6 (83.3%) for 5 mm 30Åã.

Conclusion: When applying the modified tension band wiring technique to prevent articular penetration, K-wires should be inserted in the first 5 mm from dorsal cortex of the olecranon process at a maximum angle of 20Åã. Moreover, if the wires are required to be inserted more anteriorly because of the anatomical configuration of the fracture, they should be inserted at a shallow angle in the sagittal plane in relation to the proximal cortex of the ulna.

Keywords

References

  1. Van Der Horst CM, Keeman JN. Treatment Of Olecra- non Fractures. Neth J Surg 1983;35:27–9.
  2. Weber Bg, Vasey H. Osteosynthesıs In Olecranon Fractures. [Article in German] Z Unfallmed Berufskr 1963;56:90–6. [Abstract]
  3. Mueller ME, Allgoewer W, Sneider R, Willengner R. In Manual of internal fixation. Techniques recomended by the AO-Group. New York, Springer 1991. p. 460–461.
  4. Mullett JH, Shannon F, Noel J, Lawlor G, Lee TC, O’Rourke SK. K-wire position in tension band wiring of the olecranon - a comparison of two techniques. Injury 2000;31:427–31.
  5. Prayson MJ, Williams JL, Marshall MP, Scilaris TA, Lin- genfelter EJ. Biomechanical comparison of fixation meth- ods in transverse olecranon fractures: a cadaveric study. J Orthop Trauma 1997;11:565–72.
  6. Prayson MJ, Iossi MF, Buchalter D, Vogt M, Towers J. Safe zone for anterior cortical perforation of the ulna during tension-band wire fixation: a magnetic resonance imaging analysis. J Shoulder Elbow Surg 2008;17:121–5.
  7. Mauffrey CP, Krikler S. Surgical techniques: how I do it? Open reduction and tension band wiring of olecranon frac- tures. Injury 2009;40:461–5.
  8. Shatzker J. In The rationale of operative fracture care, pp. 123-130. Edited by J. Shatzker; Tile M, 123-130, Berlin, Springer-Verlag, 2005.

Details

Primary Language

English

Subjects

Health Care Administration

Journal Section

Research Article

Authors

Mehmet Ozsoy This is me

Onur Kizilay This is me

Ceren Gunenc This is me

Arzu Ozsoy This is me

Deniz Demiryurek This is me

Mutlu Hayran This is me

Burcu Ercakmak This is me

Abdurrahman Sakaogullari This is me

Publication Date

May 22, 2015

Submission Date

March 18, 2015

Acceptance Date

-

Published in Issue

Year 2015 Volume: 49 Number: 2

APA
Ozsoy, M., Kizilay, O., Gunenc, C., Ozsoy, A., Demiryurek, D., Hayran, M., Ercakmak, B., & Sakaogullari, A. (2015). Modified tension band wiring technique for olecranon fractures: where and how should the K-wires be inserted to avoid articular penetration? Acta Orthopaedica et Traumatologica Turcica, 49(2), 190-196. https://doi.org/10.3944/AOTT.2015.14.0155
AMA
1.Ozsoy M, Kizilay O, Gunenc C, et al. Modified tension band wiring technique for olecranon fractures: where and how should the K-wires be inserted to avoid articular penetration? Acta Orthopaedica et Traumatologica Turcica. 2015;49(2):190-196. doi:10.3944/AOTT.2015.14.0155
Chicago
Ozsoy, Mehmet, Onur Kizilay, Ceren Gunenc, et al. 2015. “Modified Tension Band Wiring Technique for Olecranon Fractures: Where and How Should the K-Wires Be Inserted to Avoid Articular Penetration?”. Acta Orthopaedica et Traumatologica Turcica 49 (2): 190-96. https://doi.org/10.3944/AOTT.2015.14.0155.
EndNote
Ozsoy M, Kizilay O, Gunenc C, Ozsoy A, Demiryurek D, Hayran M, Ercakmak B, Sakaogullari A (May 1, 2015) Modified tension band wiring technique for olecranon fractures: where and how should the K-wires be inserted to avoid articular penetration? Acta Orthopaedica et Traumatologica Turcica 49 2 190–196.
IEEE
[1]M. Ozsoy et al., “Modified tension band wiring technique for olecranon fractures: where and how should the K-wires be inserted to avoid articular penetration?”, Acta Orthopaedica et Traumatologica Turcica, vol. 49, no. 2, pp. 190–196, May 2015, doi: 10.3944/AOTT.2015.14.0155.
ISNAD
Ozsoy, Mehmet - Kizilay, Onur - Gunenc, Ceren - Ozsoy, Arzu - Demiryurek, Deniz - Hayran, Mutlu - Ercakmak, Burcu - Sakaogullari, Abdurrahman. “Modified Tension Band Wiring Technique for Olecranon Fractures: Where and How Should the K-Wires Be Inserted to Avoid Articular Penetration?”. Acta Orthopaedica et Traumatologica Turcica 49/2 (May 1, 2015): 190-196. https://doi.org/10.3944/AOTT.2015.14.0155.
JAMA
1.Ozsoy M, Kizilay O, Gunenc C, Ozsoy A, Demiryurek D, Hayran M, Ercakmak B, Sakaogullari A. Modified tension band wiring technique for olecranon fractures: where and how should the K-wires be inserted to avoid articular penetration? Acta Orthopaedica et Traumatologica Turcica. 2015;49:190–196.
MLA
Ozsoy, Mehmet, et al. “Modified Tension Band Wiring Technique for Olecranon Fractures: Where and How Should the K-Wires Be Inserted to Avoid Articular Penetration?”. Acta Orthopaedica et Traumatologica Turcica, vol. 49, no. 2, May 2015, pp. 190-6, doi:10.3944/AOTT.2015.14.0155.
Vancouver
1.Mehmet Ozsoy, Onur Kizilay, Ceren Gunenc, Arzu Ozsoy, Deniz Demiryurek, Mutlu Hayran, Burcu Ercakmak, Abdurrahman Sakaogullari. Modified tension band wiring technique for olecranon fractures: where and how should the K-wires be inserted to avoid articular penetration? Acta Orthopaedica et Traumatologica Turcica. 2015 May 1;49(2):190-6. doi:10.3944/AOTT.2015.14.0155