Research Article

Comparison of T-Type Converter and NPC for the Wind Turbine Based on Doubly-Fed Induction Generator

Volume: 9 Number: 2 April 30, 2021
EN

Comparison of T-Type Converter and NPC for the Wind Turbine Based on Doubly-Fed Induction Generator

Abstract

A three-phase T-type converter topology proposes for wind turbine based on doubly fed induction generator (DFIG). The proposed converter consists of only twelve power switches without flying capacitors or any clamping diodes. The proposed system is implemented to grid side converter of wind turbine. Fuzzy logic controllers are more widely used in wind turbines compared to traditional control systems. Fuzzy logic PI controller has been applied to T-type and the conventional neutral-point clamped (NPC) converters control circuits. Total harmonic distortion (THD) value of current of presented system is measured as 1.76%. Also, DC-link voltage utilization can be maintained. Comparisons are conducted with T- type converter and a 3L-NPC) method under same operation conditions. The proposed scheme has been carried out to verify in simulation results.

Keywords

References

  1. S. Bayhan, S. Demirbas and H. Abu-Rub, "Fuzzy-PI-based sensorless frequency and voltage controller for doubly fed induction generator connected to a DC microgrid," in IET Renewable Power Generation, vol. 10, no. 8, pp. 1069-1077, 9 2016, doi: 10.1049/iet-rpg.2015.0504.
  2. S. Demirbas, "Self-tuning fuzzy-PI-based current control algorithm for doubly fed induction generator," in IET Renewable Power Generation, vol. 11, no. 13, pp. 1714-1722, 15 11 2017, doi: 10.1049/iet-rpg.2016.0700.
  3. M. Z. Sujod and I. Erlich, "A new protection scheme for three-level NPC converter based DFIG using zero state control," IEEE PES ISGT Europe 2013, Lyngby, 2013, pp. 1-5, doi: 10.1109/ISGTEurope.2013.6695240.
  4. C. Qin, C. Zhang, A. Chen, X. Xing and G. Zhang, "A Space Vector Modulation Scheme of the Quasi-Z-Source Three-Level T-Type Inverter for Common-Mode Voltage Reduction," in IEEE Transactions on Industrial Electronics, vol. 65, no. 10, pp. 8340-8350, Oct. 2018, doi: 10.1109/TIE.2018.2798611.
  5. M. Schweizer and J. W. Kolar, "Design and Implementation of a Highly Efficient Three-Level T-Type Converter for Low-Voltage Applications," in IEEE Transactions on Power Electronics, vol. 28, no. 2, pp. 899-907, Feb. 2013, doi: 10.1109/TPEL.2012.2203151.
  6. M. Barzegar-Kalashani, B. Tousi, M. A. Mahmud and M. Farhadi-Kangarlu, "Non-linear integral higher-order sliding mode controller design for islanded operations of T-type three-phase inverter-interfaced distributed energy resources," in IET Generation, Transmission & Distribution, vol. 14, no. 1, pp. 53-61, 17 1 2020, doi: 10.1049/iet-gtd.2019.0795.
  7. Z. Zhang, A. Anthon and M. A. E. Andersen, "Comprehensive loss evaluation of neutral-point-clamped (NPC) and T-Type three-level inverters based on a circuit level decoupling modulation," 2014 International Power Electronics and Application Conference and Exposition, Shanghai, 2014, pp. 82-87, doi: 10.1109/PEAC.2014.7037833.
  8. S. Tohidi, P. Tavner, R. McMahon, H. Oraee, MR. Zolghadri, S.Shao S, et al. “Low voltage ride-through of DFIG and brushless DFIG: similarities and differences” Electric Power System Research,vol. 110, p.p. 64-72, 2014. doi: 10.1016/j.epsr.2013.12.018.

Details

Primary Language

English

Subjects

Electrical Engineering

Journal Section

Research Article

Publication Date

April 30, 2021

Submission Date

November 16, 2020

Acceptance Date

February 6, 2021

Published in Issue

Year 2021 Volume: 9 Number: 2

APA
Gencer, A. (2021). Comparison of T-Type Converter and NPC for the Wind Turbine Based on Doubly-Fed Induction Generator. Balkan Journal of Electrical and Computer Engineering, 9(2), 123-128. https://doi.org/10.17694/bajece.826624
AMA
1.Gencer A. Comparison of T-Type Converter and NPC for the Wind Turbine Based on Doubly-Fed Induction Generator. Balkan Journal of Electrical and Computer Engineering. 2021;9(2):123-128. doi:10.17694/bajece.826624
Chicago
Gencer, Altan. 2021. “Comparison of T-Type Converter and NPC for the Wind Turbine Based on Doubly-Fed Induction Generator”. Balkan Journal of Electrical and Computer Engineering 9 (2): 123-28. https://doi.org/10.17694/bajece.826624.
EndNote
Gencer A (April 1, 2021) Comparison of T-Type Converter and NPC for the Wind Turbine Based on Doubly-Fed Induction Generator. Balkan Journal of Electrical and Computer Engineering 9 2 123–128.
IEEE
[1]A. Gencer, “Comparison of T-Type Converter and NPC for the Wind Turbine Based on Doubly-Fed Induction Generator”, Balkan Journal of Electrical and Computer Engineering, vol. 9, no. 2, pp. 123–128, Apr. 2021, doi: 10.17694/bajece.826624.
ISNAD
Gencer, Altan. “Comparison of T-Type Converter and NPC for the Wind Turbine Based on Doubly-Fed Induction Generator”. Balkan Journal of Electrical and Computer Engineering 9/2 (April 1, 2021): 123-128. https://doi.org/10.17694/bajece.826624.
JAMA
1.Gencer A. Comparison of T-Type Converter and NPC for the Wind Turbine Based on Doubly-Fed Induction Generator. Balkan Journal of Electrical and Computer Engineering. 2021;9:123–128.
MLA
Gencer, Altan. “Comparison of T-Type Converter and NPC for the Wind Turbine Based on Doubly-Fed Induction Generator”. Balkan Journal of Electrical and Computer Engineering, vol. 9, no. 2, Apr. 2021, pp. 123-8, doi:10.17694/bajece.826624.
Vancouver
1.Altan Gencer. Comparison of T-Type Converter and NPC for the Wind Turbine Based on Doubly-Fed Induction Generator. Balkan Journal of Electrical and Computer Engineering. 2021 Apr. 1;9(2):123-8. doi:10.17694/bajece.826624

Cited By

All articles published by BAJECE are licensed under the Creative Commons Attribution 4.0 International License. This permits anyone to copy, redistribute, remix, transmit and adapt the work provided the original work and source is appropriately cited.Creative Commons Lisansı