-

Abstract

In this study, the effect of the annealing process on the microstructure and the stress distribution of the Magnesium Diboride wires were investigated. The presented microstructure properties of the Copper/Magnesium Diboride wires are characterized for the varous diameters fabricated by the Continuous Tube Forming and Filling (CTFF) by using Scanning Electron Microscopy (SEM) and Electron Dispersive Spectroscopy (EDS) and the stress distribution is calculated analytically. In this study, it is observed that values of stress components are maximum at the interface region of Copper/Magnesium Diboride wires

Keywords

• -

MAGNEZYUM DİBORÜR TELLERİN MİKRO YAPISI VE GERİLME ANALİZİ - MICROSTRUCTURE AND STRESS ANALYSIS OF THE MAGNESIUM DIBORIDE WIRES

Abstract

MAGNEZYUM DİBORÜR TELLERİN MİKRO YAPISI VE GERİLME ANALİZİ 

Bu çalışmada, ısıl işlem prosesinin süperiletken Magnezyum Diborür tellerin mikro yapısına ve oluşan gerilme dağılımlarına etkisi incelenmektedir. Sürekli Tüp Biçimlendirme ve Doldurma (CTFF) prosesi ile farklı çaplarda üretilen süperiletken Bakır/Magnezyum Diborür tellerin mikro yapısı Taramalı Elektrom Mikroskopu
(SEM) ve Enerji Dağılım Spektroskopisi (EDS) kullanılarak karakterize edilmektedir ve gerilme dağılımı hesapları analitik olarak hesaplanmıştır. Bu çalışmada, Bakır/Magnezyum Diborür tellerin ara bölgesinde gerilme değerlerinin
maksimum değerde olduğu görülmektedir.

MICROSTRUCTURE AND STRESS ANALYSIS OF THE MAGNESIUM DIBORIDE WIRES

In this study, the effect of the annealing process on the microstructure and the stress distribution of the Magnesium Diboride wires were investigated. The presented microstructure properties of the Copper/Magnesium Diboride wires are characterized for the varous diameters fabricated by the Continuous Tube Forming and Filling (CTFF) by using Scanning Electron Microscopy (SEM) and Electron Dispersive Spectroscopy (EDS) and the stress distribution is calculated analytically. In this study, it is observed that values of stress components are maximum at the interface region of Copper/Magnesium Diboride wires.

Keywords

• Eksenel simetri, magnezyum diborür, artık gerilme, süperiletken tel

References

1. Sumption, M.D., Bhatia, M., Buta, F., Bohnenstiehl, S., Tomsic, M. , Rindfleisch, M., Yue, J., Phillips, J. , Kawabata, S., Collings, E.W., “Solenoidal coils made from MgB2 strands,” Supercond. Sci. Technol. c.18, s. 961– 965, 2005. and multifilamentary
2. Sumption, M. D., Bhatia, M., Buta, F., Bohnenstiehl, S., Tomsic, M., Rindfleisch, M., Yue, J., Phillips, J., Kawabata, Multifilamentary MgB2-based solenoidal and racetrack coils, Physica C, c. 458, s.12-20. E. W. (2007).
3. Sumption, M.D., Bohnenstiehl, S., Buta, F., Majoros, M., Kawabata, S., Tomsic, M., Rindfleisch, M., Phillips, J., Yue, J., Collings, E.W., “Wind and React and React and Wind MgB2 Solenoid, Racetrack and Pancake Coils,” IEEE Trans. Appl. Super. c. 17, s. 2286–2290, 2007.
4. Sumption, M.D., Bhatia, M., Rindfleisch, M., Phillips, J., Tomsic, M., Collings, E.W., “MgB2/Cu racetrack coil winding, insulating, and testing,” IEEE Trans. Appl. Superconduct. c. 15, s. 1457–1460, 2005.
5. Arda, L., Sacli, O.A., Tomsic, M., Dur, O., Hascicek, Y.S., “Field dependence of the critical current density of MgB2/Cu wire for coil development,” Supercond. Sci. Technol. c.20, s. 1054–1058, 2007.
6. Kawagoe, A., Matsushima, K., Yoshidome, Y., Kawabata, S., Sumiyoshi, F., Yanagi, N., Mito, T., Kuichi, M., Otabe, E. S., Matsushita, T., Tanaka, K., ve Wakuda, T. (2011). Development of an MgB2 Coil
7. Wound With a Parallel Conductor Composed of Two Tapes With Insulation. IEEE Trans. on Appl. Super., c. 21, s.1612-1615.
8. Kitaguchi, H., Kumakura, H. ve Togano, K. (2011).

9. Strain effect in MgB2/stainless steel superconducting tape. Physica C, c. 363, s. 198-201. Arda, L., Ataoglu, S., Sezer, S. ve Abdulaliyev, Z. (2007). Residual stress analysis of multi-layered buffer layers on Ni substrate for YBCO coated conductor. Surf. Coat. Tech., c. 202, s. 439–446.
10. Sumption, M. D., Bhatia, M., Dou, S. X., Rindfliesh, M., Tomsic, M., Arda, L., Ozdemir, M., Hascicek, Y. S. ve Collings, E. W. (2004). Irreversibility field and flux pinning in MgB2 with and without SiC additions,
11. Supercond. Sci. Technol, c.17, s. 1180-1184.
12. Aslanoglu, Z., Arda, L., Akin, Y., Hascicek, Y. S., Sumption, Characterization ve MgB2 development. Advences in Cryogenic Engineering Materials, c. 50 B, s. 533-540. Tomsic, M. (2004). conductors for coil
13. Timoshenko S. P., Goodier, J. N. (1970). Theory of elasticity, McGraw-Hill, New York.
14. Yu, Y. H., Lai, M. O., Lu, L. ve Yang, P. (2008).
15. Measurement of residual stress of PZT thin film on Si(1 0 0) by synchrotron X-ray rocking curve technique, J. Alloy. Compound, c. 449, s. 556-59. Arda, L., Ataoglu, S., Abdulaliyev, Z. ve Sacli, O. A. (2009). Stress analysis of ceramic insulation coating on Cu/MgB2 wires for W&R MgB2 coils. J.Alloy Compound, c. 470, s. 404-407.
16. Geliş Tarihi: 16.12.2013 Kabul Tarihi: 14.07.2014