POWER FACTOR CORRECTION IN INDUCTION HEATING SYSTEM USING PFC BOOST CONVERTER

Year 2020, Volume: 10 Issue: 2, 464 - 475, 30.12.2020

Hüseyin Çalık , Gökhan Yalçın , Erdal Şehirli

https://doi.org/10.36222/ejt.842619

Abstract

Today, with the increased energy needs, carbon emission caused by energy production affects the environment negatively. This situation has made it necessary that electrical energy should be used efficiently. In order to achieve this, institutions such as IEEE and IEC have established some electrical energy standards to be complied with, by the consumers. In order to increase energy efficiency following these standards, current and voltage harmonics in the system must be eliminated or kept at the required limit. Otherwise, these harmonics will cause deterioration of receivers fed from the distribution network or decrease in operating performance. For this reason, power factor correction (PFC) processes are applied in power systems. Induction heating systems, which have found a wide area of use in recent years, require PFC process due to their structure consisting power electronics elements and inductive heating crucible. This study aims to eliminate the network harmonics and harmonics distortions and to bring the power factor (PF) closer to '1' by using AC-DC converter with PFC in induction heating system. Induction heating system designed in the study has three phases and has a full bridge parallel resonance inverter operating at a frequency of 20 kHz and power of 17 kW. The system uses full wave uncontrolled rectifier and boost type DC-DC converter. Voltage control is provided through the PID controller. Designed system is simulated in MATLAB. Current and voltage graphics measured from network and load were evaluated, PF and THD values were analyzed.

Keywords

Harmonics Standarts, Power factor correction, Induction heating, Total harmonics distortion

References

• [1] IEEE Standard 519 – 1992, (Arrangement of IEEE Standart 519 – 1981), “ IEEE Recommended Practices and Requirements for Harmonic Control in Electrical Power Systems”, (1993).
• [2] Ozer, F.G., “Filtering and power compensation in nonlinearly loaded system”, Master Thesis, Yildiz Technical University Institute of Science, (2011).
• [3] Yalcin, G., Birbir, Y., Calik, H., “Design and Analysis of Induction Heating System with Parallel Resonant Inverter”, Internatıonal journal of renewable energy research-IJRER, Vol. 10, No. 2, 633-645, (2020).
• [4] Kubota, S., “ The Optimal Composition of Diesel Particulate Filter Using Induction Heating”, IEEE 18th International Power Electronics and Motion Control Conference (PEMC), (2018).
• [5] Sarnago, H., Lucia, O., “Dual-output boost resonant full bridge topology and its modulation strategies for high-performance induction heating applications”, IEEE Transactions on Industrial Electronics, Vol. 63, No. 6, (2016).
• [6] Naval, A., Sarnago, H., Lope, I. and Lucia, O., “Improved Litz wire manufacture process using resonant power converter-based induction heating”, The international journal for computation and mathematics in electrical and electronic engineering, Vol. 36, No. 2, (2017).
• [7] Zhang, H., Wu A., “Bridge-arm current reduction in DC-AC inverter”, International Journal of Electronics, Taylor & Francis, Vol. 105, No. 10, (2018).
• [8] Choi S.S., Lee C.W., Kim I.D., and Jung, J.H., “New Induction Heating Power Supply for Forging Applications Using IGBT Current-Source PWM Rectifier and Inverter”, 21st International Conference on Electrical Machines and Systems (ICEMS), (2018).
• [9] ]Sahin, E., Buyukkatirci, O., Akin, B., “AC-DC Converter Based Power Factor Correction Circuit Design and Application”, Eleco 2014 Electric - Electronic - Computer and Biomedical Engineering Symposium, Bursa, Turkey, (2014).
• [10] Sehirli, E., Altınay, M., “Simulation of Three-phase Voltage Source Pulse Width Modulated (PWM) LCL Filtered Rectifier Based on Input-output Linearization Nonlinear Control,” IEEE 12th International Conference on Optimization of Electrical and Electronic Equipment OPTIM 2010, 564 – 569, Brasov, Romania, (2010).
• [11] Ozturk, O., Koksoy, A., Karacasu, O., Balcı, M.E., Hocaoglu, M.H., “Labwiev Based Harmonic Responsibility Sharing Account in Three Phase Systems ”, Conference 2013, Energy Efficiency and Quality Symposium, Vol.1, (2013).
• [12] Oguz, Y., Guney, I., Calik, H., ” Power Quality Control and Design of Power Converter for Variable-Speed Wind Energy Conversion System with Permanent-Magnet Synchronous Generator”, The Scientific World Journal, (2013).
• [13] Birbir, Y., Nogay, H.S., “Harmonic variations in three-phase induction motors fed by PWM inverter with different stator coil pitches”, 6th WSEAS International Conference on Applications of Electrical Engineering, Istanbul, Turkey, (2007).
• [14] Colak, I., Bayindir, R., Kaplan, O., “Simulation of the Dc Capacitor Voltage Controlled Single Phase Shunt Active Power Filters for Power Quality Improvement”, Gazi University Journal of Science, (2010).Kentli, F., Yilmaz, M. (2015). Mathematical modelling of two-axis photovoltaic system with improved efficiency. Elektronika Ir Elektrotechnika, 21(4), 40-44.
• [15] Vijayan, A., Padma, S., “Maintaining Voltage Stability in Power System using FACTS Devices”, International Journal of Engineering Science Invention, (2013).
• [16] Singh, B., Verma, K.S., Mishra, P., Maheshwari, R., Srivastava, U., Baranwal, A. “Introduction to FACTS controller in Wind Power Farms: A Tehcnological Literrature Survey”, International Journal of Automation and Power Engineering, Vol 1, No 9, (2012).
• [17] Singh, B., Singh, B.N., Chandra, A., Al – Haddad, K., Pandey, A., Kothari, D.P., “A Review of Three – Phase Improved Power Quality AC – DC Converters”, IEEE Transactions on Industrial Electronics, 51, 641 – 660, (2004).
• [18] Yalcin, F., “A New Approach for Optimal Power Flow Calculation in AC-DC System Including FACTS Devices”, PHD Thesis, Sakarya University Institute of Science, (2013).
• [19] Altuntas, N., “A Novel Single Phase Soft Switched PFC Converter”, Journal of Electrical Engineering & Technology, 9, 1592-1601, (2014).
• [20] Madhavi, S.V., Ram Das, G.T., “Linear and Non-Linear Carrier Control of Soft Switched Isolated Boost Converter for Low Voltage Fuel Cell Applications”, International Journal of Renewable Energy Research-IJRER, Vol. 9, No. 2, (2019). International Journal of Renewable Energy Research-IJRER, Vol. 9, No. 2.
• [21] Yilmaz, M. (2018). Real measure of a transmission line data with load fore-cast model for the future. Balkan Journal of Electrical and Computer Engineering, 6(2), 141-145.
• [22] Fincan, B., Yılmaz, M., Goynusen, A., Erenay, H. K. (2017). Design and Optimization of a High Power Density and Efficiency Boost PFC. Balkan Journal of Electrical and Computer Engineering, 5(2), 50-59.
• [23] Özgönenel, O., Terzi, U. K., Khan, A. (2012). A hybrid approach for power quality monitoring. Turkish Journal of Electrical Engineering & Computer Sciences, 20(6), 854-869.
• [24] Celikel, R. Speed Control of BLDC Using NARMA-L2 Controller in Single Link Manipulator. Balkan Journal of Electrical and Computer Engineering, 7(2), 143-148.