A numerical approach in the investigation of the effects of diethyl ether and ethanol mixtures on combustion characteristics and NO emissions in a DI diesel engine

Abstract

In this study, the effects of adding ethanol and diethyl ether to diesel fuel on combustion characteristics and NO emissions were numerically investigated. 100% diesel fuel (D100) and by volume 90% diesel+10% ethanol blend (D90E10), 80% diesel+20% ethanol blend (D80E20), 80% diesel+10% ethanol+10% diethyl ether blend (D80E10DEE10) and 85% diesel+ 10% ethanol+5% diethyl ether mixture (D85E10DEE5) was used as fuel. Analyzes were carried out using a single cylinder direct injection diesel engine at 2000 and 3000 rpm engine speed conditions. AVL FIRE software was used for numerical study. In-cylinder pressure, cumulative heat release rate, turbulent kinetic energy (TKE), NO emissions and velocity distributions in the combustion chamber were investigated for five different fuel types. As a result, the in-cylinder pressure and heat release rate of ethanol and diethyl ether blended fuels were lower than diesel fuel at both speeds. This is due to the calorific value of the fuel. It was observed that NO emissions decreased as the ethanol content in the fuel increased. For both engine speeds, the highest TKE value was obtained in D90E10 mixed fuel, and the lowest value was found in D80E10DEE10 mixture fuel. Ethanol positively affected the turbulent kinetic energy. The flow rate of ethanol was higher than diesel and diethyl ether fuel.

Keywords

• Diesel fuel blends
• ethanol
• diethyl ether
• NO emission

References

1. Calik, A. (2017). Pamuk yağı biyodizelinin motor ses seviyesine olan etkilerinin incelenmesi. Çukurova University Journal of the Faculty of Engineering and Architecture, 32(4): 147-152. https://doi.org/10.21605/cukurovaummfd.371016
2. Calik, A. (2018). Hidrojen ile yakıt zenginleştirmenin dizel motorun motor performansı ve emisyon özelliklerine etkisi. Çukurova University Journal of the Faculty of Engineering and Architecture, 33(3): 255-262. https://doi.org/10.21605/cukurovaummfd.504771
3. Carvalho, M., Torres, F., Ferreira, V., Silva, J., Martins, J., Torres, E. (2020). Effects of diethyl ether introduction in emissions and performance of a diesel engine fueled with biodiesel-ethanol blends. Energies, 13(15): 1-13. https://doi.org/10.3390/en13153787
4. Wang, S., Viswanathan, K., Esakkimuthu, S., Azad, K. (2021). Experimental investigation of high alcohol low viscous renewable fuel in DI diesel engine. Environmental Science and Pollution Research, 28: 12026–12040. DOI: 10.1007/s11356-020-08298-y
5. Sivalakshmi, S., Balusamy, T. (2013). Effect of biodiesel and its blends with diethyl ether on the combustion, performance and emissions from a diesel engine. Fuel, 106: 106–110. https://doi.org/10.1016/j.fuel.2012.12.033
6. Ibrahim, A. (2018). An experimental study on using diethyl ether in a diesel engine operated with diesel-biodiesel fuel blend. Engineering Science and Technology, an International Journal, 21(5): 1024–1033. https://doi.org/10.1016/j.jestch.2018.07.004
7. Pugazhvadivu, M., Rajagopan, S. (2009). Investigations on a diesel engine fuelled with biodiesel blends and diethyl ether as an additive. Indian Journal of Science and Technology, 2(5): 31-35. DOI:10.17485/ijst/2009/v2i5/29462
8. Verma, T.N., Nashine, P., Chaurasiya, P.K., Rajak, U., Afzal, A., Kumar, S., Singh, S.V., Azad, A. (2020). The effect of ethanol-methanol-diesel-microalgae blends on performance, combustion and emissions of a direct injection diesel engine. Sustainable Energy Technologies and Assessments, 42: 1-20. https://doi.org/10.1016/j.seta.2020.100851

9. Venu, H., Madhavan, V. (2017). Influence of diethyl ether (DEE) addition in ethanol-biodiesel-diesel (EBD) and methanol-biodiesel-diesel (MBD) blends in a diesel engine. Fuel, 189: 377–390. https://doi.org/10.1016/j.fuel.2016.10.101
10. Sugash, G., Rubalingam, S., Kumar, U.P., Kumar, G.V., Akashragam, L. (2019). Investigation of performance and emissions of DI diesel engine with cottonseed biodiesel along with diethyl ether. International Journal of Ambient Energy, 1-4. DOI: 10.1080/01430750.2019.1630308
11. Nishanth, S., Gunasekar, N., Nanthakumar, S., Prakash, R., Kumar, T.S. (2020). Experimental investigation on performance and emission characteristics of VCR engine working with biodiesel and diethyl ether. Materials Today: Proceedings, 45(2): 836-840. https://doi.org/10.1016/j.matpr.2020.02.913
12. Ayhan, V., Tunca, S. (2017). The effect of diethyl ether-diesel blends a direct injection diesel engine on performance and emissions. Sakarya University Journal of Science (SAUJS), 22(2): 710-718. Doi: 10.16984/saufenbilder.321228
13. Loganathan, M., Madhavanb, V., Balasubramanianc, K.A., Thanigaiveland, V. (2020). Investigation on the effect of diethyl ether with hydrogen-enriched cashew nut shell (CNS) biodiesel in direct injection (DI) diesel engine. Fuel, 277: 1-12. https://doi.org/10.1016/j.fuel.2020.118165
14. Sezer, İ. (2018). A review study on the using of diethyl ether in Diesel engines: effects on NOx emissions. International Journal of Automotive Engineering and Technologies, 7(4): 164-183. https://doi.org/10.18245/ijaet.475044
15. Sezer, İ. (2019). A review study on using diethyl ether in diesel engines: Effects on fuel properties, injection, and combustion characteristics. Energy & Environment, 31(2): 179-214. https://doi.org/10.1177/0958305X19856751
16. Sudhakar, S., Sivaprakasam, S. (2014). Experimental investigation on combustion characteristics of di diesel engine using diethyl ether fumigation with ethanol blended diesel. International Journal Of Renewable Energy Research, 4(4): 872-878.
17. Banapurmath, N.R., Khandal, S.V., RanganathaSwamy, L., Chandrashekar, T.K. (2015). Alcohol (ethanol and diethyl ethyl ether)-Diesel blended fuels for Diesel engine applications-A feasible solution. Advances in Automobile Engineering, 4(1): 1-8. Doi:10.4172/2167-7670.1000117
18. Usta, N., Can, O., Ozturk, E. (2005). Comparison of biodiesel and ethanol as an alternative diesel engine fuel, Journal of Engineering Sciences, 11(3): 325-334.
19. Xiong, J., Li, C. (2019). Study on emission of dimethyl ether engine by Avl-fire. Earth and Environmental Science, 252: 1-9. Doi: 10.1088/1755-1315/252/4/042006
20. Iliev, S. (2015). A comparison of ethanol and methanol blending with gasoline using a 1-D engine model. Procedia Engineering, 100: 1013–1022. https://doi.org/10.1016/j.proeng.2015.01.461
21. Mohan, B., Yang, W., Yu, W., Tay, K.L., Chou, S.K. (2015). Numerical simulation on spray characteristics of ether fuels. Energy Procedia, 75: 919-924. https://doi.org/10.1016/j.egypro.2015.07.243
22. Yılmaz, M. (2019). Comparison of ethanol and gasoline in engine cylinder flow, M.Sc thesis, Bursa Uludağ University, Institute of science and technology, Bursa, Turkey.
23. Rajak, U., Nashineb, P., Verma, T.N. (2020). Numerical study on emission characteristics of a diesel engine fuelled with diesel-spirulina microalgae-ethanol blends at various operating conditions. Fuel, 262: 1-20. https://doi.org/10.1016/j.fuel.2019.116519
24. Xu, Z., Duan, X., Liu, Y., Denga, B., Liu, J. (2020). Spray combustion and soot formation characteristics of the acetone-butanolethanol/diesel blends under diesel engine-relevant conditions. Fuel, 280: 1-17. https://doi.org/10.1016/j.fuel.2020.118483
25. Sezer, I. (2017). Experimental investigation the effects of ethanol and diethyl ether addition into diesel fuel on engine performance and exhaust emissions. J. of Thermal Science and Technology, 37(1): 61-68.
26. Paul, A., Bose, P.K., Panua, R., Debroy, D. (2015). Study of performance and emission characteristics of a single cylinder CI engine using diethyl ether and ethanol blends. Journal of the Energy Institute, 88(1): 1-10. https://doi.org/10.1016/j.joei.2014.07.001
27. Dimitriou, P., Wang, W., Peng, Z. (2015). A piston geometry and nozzle spray angle investigation in a di diesel engine by quantifying the air-fuel mixture. Int. J. Spray Combust. Dyn., 7: 1–24. https://doi.org/10.1260/1756-8277.7.1.1
28. Soni, D.K., Gupta, R. (2017). Numerical analysis of flow dynamics for two piston bowl designs at different spray angles. J. Clean. Prod., 149: 723-734. https://doi.org/10.1016/j.jclepro.2017.02.142
29. Soni, D.K., Gupta, R. (2016). Numerical investigation of emission reduction techniques applied on methanol blended diesel engine. Alexandria Eng. J., 55: 1867-1879. https://doi.org/10.1016/j.aej.2016.02.019
30. Temizer, I. (2020). The combustion analysıs and wear effect of biodiesel fuel used in a diesel engine. Fuel, 270: 1-9. https://doi.org/10.1016/j.fuel.2020.117571
31. Bashtani, J., Seddighi, S., Bahrabadi-Jovein, I. (2018). Control of nitrogen oxide formation in power generation using modified reaction kinetics and mixing. Energy, 145: 567-581. https://doi.org/10.1016/j.energy.2017.12.143
32. Jayaprabakar, J., Anish, M., Beemkumar, N., Mathew, A., George, A.A. (2017). Effect of diethyl ether blended with neem oil methyl esters in CI engine. International Journal of Ambient Energy, 40: 116-118. https://doi.org/10.1080/01430750.2017.1372814