FLOW BOILING BEHAVIORS OF VARIOUS REFRIGERANTS INSIDE HORIZONTAL TUBES: A COMPARATIVE RESEARCH STUDY

Year 2022, Volume: 23 Issue: 1, 1 - 20, 30.03.2022

Oğuz Emrah Turgut , Mustafa Asker

https://doi.org/10.18038/estubtda.749040

Abstract

FLOW BOILING BEHAVIORS OF VARIOUS REFRIGERANTS INSIDE HORIZONTAL TUBES: A COMPARATIVE RESEARCH STUDY

Abstract

In this study, convective boiling behaviors of refrigerants (R22, R134a, R290, R404a, R410a, R600, R507, R717, and R744) are compared with existing flow boiling correlations. Flow boiling heat transfer rates under the primary influences of vapor quality and mass flux are plotted and compared with the experimental results that are extracted from the literature. A statistical approach is introduced for error analysis and a valid correlation is proposed for each refrigerant. Correlation of Wojtan et al. with 30% of experimental data in 20% error region is selected as the best correlation while Shah Correlation with 10% of experimental data in 20% error regions performs the worst. The result of the analysis indicates that flow boiling heat transfer values are strongly dependent upon mass velocity and heat flux. It is observed that existing correlations are in good agreement with experimental works at low heat flux rates whereas deviations are getting bigger for high heat flux rates.

Keywords

Flow Boiling, Horizontal tubes, Refrigerants

References

• [1] Shah MM. Chart correlation for saturated boiling heat transfer: Equations and further study. ASHRAE Trans, 1982; 88:185-196.
• [2] Gungor KE, Winterton RHS. Simplified general correlations for saturated flow boiling and comparisons of correlations with data. Can J Chem Eng, 1987; 65:148-156.
• [3] Kandlikar SG, Masahiro Shoji Vijay KD. Handbook of Phase Change: Boiling and Condensation. Taylor & Francis, Flow Boiling in Circular Tubes, Chapter 15, 1999.
• [4] Wojtan L, Ursenbacher T, Thome JR. Investigation of flow boiling in horizontal tubes: Part I-A new diabatic two-phase flow pattern map. Int J Heat Mass Transf, 2005; 48:2955–2969
• [5] Wojtan L, Ursenbacher T, Thome JR. Investigation of flow boiling in horizontal tubes: Part-II development of a new heat transfer model for stratified-wavy, dryout and mist flow regimes. Int J Heat Mass Transf, 2005; 48:2970–2985.
• [6] Liu Z, Winterton RHS. A General correlation for saturated and subcooled flow boiling in tubes and Annuli based on a nucleate boiling pool boiling, Int J Heat Mass Transf, 1991; 34:695–702.
• [7] Wattelet JP, Chato J, Christoffersen BR, Gaibel JA, Ponchner M, Kenny PJ, Shimon RL, Villaneuva TC, Rhines NL, Sweeny KA, Allen DG, Hershberger TT. Heat transfer flow regimes of refrigerants in a horizontal tube evaporator. ACRC Report TR–55. 1994.
• [8] Bivens DB, Yokozeki A. A heat transfer of zeotropic refrigerant mixtures for energy efficiency and environmental progress, Elsevier, Amsterdam, 1994.
• [9] Kew PA, Cornwell K. Correlations for the prediction of boiling heat transfer in small-diameter channels. Appl Therm Eng, 1997; 17:705–715.
• [10] Menhendale SS, Jacobi AM, Shah RK. Fluid flow and heat transfer at micro- and meso-scale with application to heat exchanger design. Appl Mech Rev, 2000;53:175–193.
• [11] Kandlikar SG. Fundamental issues related to flow boiling in mini channels and micro channels. Exp Therm Fluid Sci, 2002; 26:389-407.
• [12] Fang X, Zhuang F, Chen C, Wu Q, Chen Y, Chen, Y, He Y. Saturated Flow Boiling Heat Transfer: Review and Assessment of Prediction Methods. Heat Mass Transf, 2019; 55: 197-222.
• [13] Yang CH, Nalbandian H, Lin FC, Flow boiling heat transfer and pressure drop of refrigerants HFO-1234yf and HFC-134a in a small circular tube. Int J Heat Mass Tran, 2018; 121:726-735
• [14] Cheng L, Xia G, Thome JR, Flow boiling heat transfer and two phase flow phenomena of CO2 in macro- and micro-channel evaporators: Fundamentals, applications and engineering design. Appl. Therm Eng, 2021; 195:117070 [15] Mauro AW, Napoli, Pelella F, Viscito L, Flow pattern, condensation and boiling inside and outside smooth and enhanced surfaces of propane (R290). State of the art review. Int J Heat Mass Tran, 2021; 174:121316
• [16] Horak P, Formanek M, Fecer R, Plasek J, Evaporation of refrigerant R134a, R404A, and R407C with low mass flux in smooth vertical tube. Int J Heat Mass Tran, 2021; 181:121845
• [17] Yang ZQ, Chen GF, Zhao YX, Tang QX, Xue HW, Song QL, Gong MQ, Experimental study on flow boiling heat transfer of a new azeotropic mixture of R1234ze(E)/R600a in a horizontal tube. Int J Refrig, 2018; 9: 224-235
• [18] Thome JR, Cheng L, Ribatski G, Vales L. Flow boiling of ammonia and hydrocarbons: A state-of-the-art review. Int J Refrig, 2008; 31:603-620.
• [19] Kattan N, Thome JR, Favrat D, Flow boiling in horizontal tubes. Part 1: Development of a diabatic two-phase flow pattern map. J Heat Transfer, 1998; 120:140-147
• [20] Wojtan L, Ursenbacher T, Thome JR, Dynamic void fractions in stratified types of flow, Part II: Measurements for R-22 and R-410A. Int J Multiphase Flow, 2004; 30:125-137
• [21] Greco A, Vanoli GP. Flow boiling of R22, R134A, R507, R404A and R410A inside a smooth horizontal tube. Int J Refrig, 2005; 28:872-880.
• [22] Cheng L, Ribatski G, Wojtan L, Thome JR. New flow boiling heat transfer model and flow pattern map for carbon dioxide evaporating inside horizontal tubes. Int J Heat Mass Transf, 2006; 49:4082–4094.
• [23] Park CY, Hrnjak PS. CO2 and R-410A flow boiling heat transfer, pressure drop and flow pattern at low temperatures in a horizontal smooth tube. Int J Refrig, 2007; 30:166–178.
• [24] Yang Z, Peng XF, Ye P. Numerical and experimental investigation of two phase flow during boiling in a coiled tube. Int J Heat Mass Transf, 2008; 51:1003-1016.
• [25] Moreno Quiben J, Cheng L, da Silva Lima RJ, Thome JR. Flow boiling in horizontal flatten tubes: Part I – Two-phase frictional pressure drop results and model. Int J Heat Mass Transf, 2009; 52:3634-3644.
• [26] Moreno Quiben J, Cheng L, da Silva Lima RJ, Thome JR. Flow boiling in horizontal flatten tubes: Part II – Flow boiling heat transfer results and model. Int J Heat Mass Transf, 2009; 52:3645-3653.
• [27] Gao Y, Shao S, Zhan B, Chen Y, Tian C. Heat transfer and pressure drop characteristics of ammonia during flow boiling inside a horizontal small diameter tube. Int J Heat and Mass Transf, 2018; 127: 981-986.
• [28] Wang H, Fang X. Evaluation analysis of correlations of flow boiling heat transfer coefficients applied to ammonia. Heat Transf Eng, 2016; 37: 32- 44.
• [29] Turgut OE, Asker M. Saturated Flow Boiling Heat Transfer Correlation for Carbon Dioxide for Horizontal Smooth Tubes. Heat and Mass Transfer 2017; 53: 2165–2185.
• [30] Turgut OE, Asker M, Çoban MT. Saturated Flow Boiling Heat Transfer Correlation for Small Channels Based on R134a Experimental Data. Arab J Sci Eng, 2016; 41: 1921-1939.
• [31] Zürcher O, Favrat D, Thome JR. Evaporation of refrigerants in a horizontal tube: an improved flow pattern dependent heat transfer model compared to ammonia data, Int J Heat Mass Transf, 2002; 45:303-317.
• [32] Wen MY, Ho CH, Evaporation heat transfer and pressure drop characteristics of R-290 (propane), R-600 (butane), and a mixture of R-290/R-600 in the three-lines serpentine small tube-bank. Appl Therm Eng, 2005; 25:2921-2936
• [33] Oh JT, Pamitran AS, Choi KI, Hrnjak P, Experimental investigation on two-phase flow boiling heat transfer of five refrigerants in horizontal small tubes of 0.5, 1.5 and 3.0 mm inner diameters, Int J Heat Mass Trans, 54; 2011:2080-2088