This paper describes an
autopilot system design to regulate the altitude, heading and forward speed in
the fixed-wing flight mode of the Osprey V22 VTOL (vertical takeoff and land)
tilt rotor UAV accordingly to a reference, which is generated the trajectory
sub-block. X- Plane flight simulator developed by Laminar Research, is used to
test and optimize the parameter values of the autopilot system, which is
designed using feedback, feedforward and PID controllers in MATLAB / Simulink
environment (Software in the Loop- SIL). The receiver and sender blocks to
perform the data interactions between MATLAB / Simulink and X-Plane flight
simulator are created in MATLAB / Simulink environment. The receiver block is
used to transfer data from the X-Plane flight simulator to the controller,
while the sender block is used to transfer control signals from the controller
to the X-Plane flight simulator program. The data communication between the two
is UDP. The autopilot system under test is embedded in the Raspberry-Pi
minicomputer and a hardware-in loop (HIL) test system created. The reaction of
the control algorithm running on the Raspberry-Pi minicomputer to the virtual
sensor data generated by the X-Plane flight simulator investigated. It is
observed that, the Osprey-V22 aircraft can perform tasks autonomously in the
horizontal flight mode, from the experiments and the results obtained. This
study also describes the first stage of an undergoing project which aims to
develop a robust autopilot for Osprey V22 VTOL UAV.
Primary Language | English |
---|---|
Journal Section | Research Articles |
Authors | |
Publication Date | April 15, 2018 |
Submission Date | February 28, 2018 |
Acceptance Date | March 30, 2018 |
Published in Issue | Year 2018 Volume: 2 Issue: 1 |