Heat Transfer from an Oscillated Vertical Annular Fluid Column Through a Porous Domain: a Thermodynamic Analysis of the Experimental Results

Abstract

Heat transfer in an oscillating vertical annular fluid column flowing through a porous domain in the single phase or bubbly flow two-phase regime (sub-cooled or saturated nucleate flow boiling) are investigated experimentally and theoretically, in quasi-steady state conditions. Forced oscillations are applied to water via a frequency controlled dc motor and a piston-cylinder device. Heat transfer is from the stationary concentric tubular electric heating element outer surface to the reciprocating flow. The heat transfer in an oscillating vertical annular fluid column flowing in the single phase or in the bubbly flow regime is altered by using stainless steel wool porous medium. For the single phase region of flow, it is understood that, the effective heat transfer mechanism is enhanced and it is due to the hydrodynamic boundary layer which can not follow the core flow. Bubbly (nucleate) flow boiling in oscillating flow is also investigated experimentally and theoretically using a simplified thermodynamic analysis. The onset of boiling temperature is distinctly dropped compared to the pool and flow boiling experiments on polished surfaces due the finned surface effect of the steel porous domain, due to the enhanced mixing of the boundary layer flow and core flow; due to the improvement of apparent surface roughness and due to the alteration of ebullition cycle (bubbles are limited by the cell volume here). The developed correlation predicted cycle-space averaged Nusselt number is shown to be in good agreement with the experimental data. The present investigation has possible applications in moderate sized wicked heat pipes, boilers, compact heat exchangers and steam generators.

Keywords

• Salınım,Isı geçişi deneyi

References

1. Akdag, U. and A.F. Ozguc, Experimental investigation of heat transfer in oscillating annular flow. International Journal of Heat and Mass Transfer, 2009. 52(11-12): p. 2667-2672.
2. Akdag, U., M. Ozdemir, and A.F. Ozguc, Heat removal from oscillating flow in a vertical annular channel. Heat and Mass Transfer, 2008. 44(4): p. 393-400.
3. Arslan, G. and M. Ozdemir, Correlation to predict heat transfer of an oscillating loop heat pipe consisting of three interconnected columns. Energy Conversion and Management, 2008. 49(8): p. 2337-2344.
4. Bau, H. and K. Torrance, Low Rayleigh number thermal convection in a vertical cylinder filled with porous materials and heated from below. Journal of Heat Transfer, 1982. 104(1): p. 166-172.
5. Chatwin, P.C., Longitudinal Dispersion of Passive Contaminant in Oscillatory Flows in Tubes. Journal of Fluid Mechanics, 1975. 71(Oct14): p. 513-527.
6. Chen, Z.D. and J.J.J. Chen, A simple analysis of heat transfer near an oscillating interface. Chemical Engineering Science, 1998. 53(5): p. 947-950.
7. Chuah, Y. and V. Carey, Boiling Heat Transfer in a Shallow Fluidized Particulate Bed. Journal of Heat Transfer, 1987. 109(1): p. 196-203.
8. Costello, C. and E. Redeker. Boiling heat transfer and maximum heat flux for a surface with coolant supplied by capillary wicking. in Chem. Eng. Progr. Symposium Ser. 1963.

9. Damronglerd, P. and Y. Zhang, Transient fluid flow and heat transfer in a porous structure with partial heating and evaporation on the upper surface. Journal of Enhanced Heat Transfer, 2006. 13(1).
10. Dhir, D.V.K., Boiling and two-phase flow in porous media. Annual review of heat transfer, 1994. 5(5).
11. Dhir, V., Boiling heat transfer. Annual review of fluid mechanics, 1998. 30(1): p. 365-401.
12. Dhir, V. and I. Catton, Dryout heat fluxes for inductively heated particulate beds. Journal of Heat Transfer, 1977. 99(2): p. 250-256.
13. Faghri, A. and Y. Zhang, Transport phenomena in multiphase systems. 2006: Academic press.
14. Faghri, A. Heat pipe science and technology. in Fuel and Energy Abstracts. 1995.
15. Furberg, R., Enhanced Boiling Heat Transfer on a Dendritic and Micro-Porous Copper Structure. 2011.
16. Kurzweg, U.H. and L. Dezhao, Heat-Transfer by High-Frequency Oscillations - a New Hydrodynamic Technique for Achieving Large Effective Thermal-Conductivities. Physics of Fluids, 1984. 27(11): p. 2624-2627.
17. Li, H., et al., Three-dimensional numerical simulation of fluid flow with phase change heat transfer in an asymmetrically heated porous channel. International Journal of Thermal Sciences, 2010. 49(12): p. 2363-2375.
18. Li, C. and G. Peterson, Parametric study of pool boiling on horizontal highly conductive microporous coated surfaces. Journal of heat transfer, 2007. 129(11): p. 1465-1475.
19. Li, H. and K. Leong, Experimental and numerical study of single and two-phase flow and heat transfer in aluminum foams. International Journal of Heat and Mass Transfer, 2011. 54(23): p. 4904-4912.
20. Lin, Z.R., et al., Experimental study on effective range of miniature oscillating heat pipes. Applied Thermal Engineering, 2011. 31(5): p. 880-886.
21. Lipinski, R.J., Model for boiling and dryout in particle beds.[LMFBR]. 1982, Sandia National Labs., Albuquerque, NM (USA).
22. Naik, A.S. and V. Dhir, Forced flow evaporative cooling of a volumetrically heated porous layer. International Journal of Heat and Mass Transfer, 1982. 25(4): p. 541-552.
23. Najjari, M. and S. Ben Nasrallah, Numerical study of boiling with mixed convection in a vertical porous layer. International Journal of Thermal Sciences, 2002. 41(10): p. 913-925.
24. Nield, D.A. and A. Bejan, Mechanics of Fluid Flow Through a Porous Medium. 2013: Springer.
25. Ozawa, M. and A. Kawamoto, Lumped-Parameter Modeling of Heat-Transfer Enhanced by Sinusoidal Motion of Fluid. International Journal of Heat and Mass Transfer, 1991. 34(12): p. 3083-3095.
26. Ozdemir, M., An experimental study on an oscillating loop heat pipe consisting of three interconnected columns. Heat and Mass Transfer, 2007. 43(6): p. 527-534.
27. Ramesh, P. and K. Torrance, Stability of boiling in porous media. International journal of heat and mass transfer, 1990. 33(9): p. 1895-1908.
28. Rannenberg, M. and H. Beer, Heat transfer by evaporation in capillary porous wire mesh structures. Letters in Heat and Mass Transfer, 1980. 7(6): p. 425-436.
29. Rudemiller, G.R., A fundamental study of boiling heat transfer mechanisms related to impulse drying. 1989.
30. Sondergeld, C.H. and D. Turcotte, An experimental study of two‐phase convection in a porous medium with applications to geological problems. Journal of Geophysical Research, 1977. 82(14): p. 2045-2053.
31. Udell, K.S., Heat transfer in porous media considering phase change and capillarity—the heat pipe effect. International Journal of Heat and Mass Transfer, 1985. 28(2): p. 485-495.
32. Xiaoguo, T. and P. Cheng, Correlations of the cycle-averaged Nusselt number in a periodically reversing pipe flow. International Communications in Heat and Mass Transfer, 1993. 20(2): p. 161-172
33. Wan, Z.P., X.W. Wang, and Y. Tang, Condenser design optimization and operation characteristics of a novel miniature loop heat pipe. Energy Conversion and Management, 2012. 64: p. 35-42
34. Wang, X.W., Z.P. Wan, and Y. Tang, Heat transfer mechanism of miniature loop heat pipe with water-copper nanofluid: thermodynamics model and experimental study. Heat and Mass Transfer, 2013. 49(7): p. 1001-1007.
35. Watson, E.J., Diffusion in Oscillatory Pipe-Flow. Journal of Fluid Mechanics, 1983. 133(Aug): p. 233-244.
36. Zhang, J.G. and U.H. Kurzeg, Numerical simulation of time-dependent heat transfer in oscillating pipe flow. Journal of Thermophysics and Heat Transfer, 1991. 5(3): p. 401-406.
37. Zhao, T.S. and P. Cheng, A numerical study of laminar reciprocating flow in a pipe of finite length. Applied Scientific Research, 1998. 59(1): p. 11-25.
38. Zhao, T. and P. Cheng, A Numerical-Solution of Laminar Forced-Convection in a Heated Pipe Subjected to a Reciprocating Flow. International Journal of Heat and Mass Transfer, 1995. 38(16): p. 3011-3022.
39. Zhao, T.S. and P. Cheng, Oscillatory Heat Transfer in a Pipe Subjected to a Laminar Reciprocating Flow. Journal of Heat Transfer, 1996. 118(3): p. 592-597