CHARACTERIZATION OF WASTE OILS IN AIR-BREATHING JET TURBINE ENGINES

Volkan Pelitli; Özgür Doğan; H. Jülide Köroğlu

CHARACTERIZATION OF WASTE OILS IN AIR-BREATHING JET TURBINE ENGINES

Abstract

In response to Waste Management strategies and environmental regulations throughout the country, the waste oils from turbojet and turbofan turbines were characterized according to the “Regulation on Control of Waste Oils (OG dated 30.07.2008 and numbered 26952)” which was published by the Ministry of Environment and Urbanization of Turkey for the integrated interim storage, recycling, and/or disposal of these products. Representative waste oil samples were taken from a total of 19 supersonic military aircraft operated in different conditions and investigated for the following criteria: arsenic, cadmium, chromium, lead, polychlorinated biphenyls, chlorine, total halogens and flash point. The results obtained from analyses indicated that the heavy metals were below the maximum permissible limits for material recycling but in 5 samples of total samples chlorine and total halogens were above limit of 200 ppm. Because of the aforementioned properties, all of these materials can be used either as the raw materials in base oil production industry or as combustible in cement kilns and power station as substitute for regular fuel oils.

Keywords

References

[1] Springer Reference [Online], http://www.springerreference.com/docs/html/chapterdbid/307227.html [Ziyaret Tarihi: 1 Mayıs 2013].
[2] Bourgeois, M.(n.d.), “Used Oil Management: International Experiences and Approach For Colombia”, International Fair and Seminar, Solid and Hazardous waste integral management XXI Century.
[3] Basel Convention [Online], http://www.basel.int/Portals/4/Basel%20Convention/docs/meetings/sbc/workdoc/old%20docs/tech-y8.pdf [Ziyaret Tarihi: 3 Mayıs 2013].
[4] Kauffman, Robert, E., Sqrow, L., Swartzbaugh, Joseph, T. and Wolf, J., D., “Advanced Lubricant Segregation Capability for Prototype Oil Collection Facility”, WL-TR-94-2082, Dayton, Ohio, USA Wright Laboratory, 1994.
[5] Tanatmış, A. A., “Uçak Bakımında Ferrografik Aşınma Analiz Teknikleri”, Erciyes Üniversitesi Fen Bilimleri Enstitüsü Dergisi 23 (1-2), 161-170, 2007.
[6] İstanbul Teknik Üniversitesi [Online], http://web.itu.edu.tr/~yukselen/Uck351/11-%20Pervane%20teorisi.pdf [Ziyaret Tarihi: 14 Mayıs 2013].
[7] Private Pilot Ground School [Online], http://www.free-online-private-pilot-ground-school.com/turbine-engines.html [Ziyaret Tarihi: 15 Mayıs 2013].
[8] Aircraft Engine Design [Online], http://www.aircraftenginedesign.com/custom.html4.html [Ziyaret Tarihi: 20 Mayıs 2013].

[9] İstanbul Teknik Üniversitesi [Online], http://web.itu.edu.tr/~yuceil/teaching/uck421/uck421-week1.pdf [Ziyaret Tarihi: 22 Mayıs 2013].
[10] Lockheed Martin [Online], http://www.lockheedmartin.com/us/products/f16/F-16Specifications.html [Ziyaret Tarihi: 20 Mayıs 2013].
[11] National Aeronautics And Space Administration [Online], http://www.grc.nasa.gov/WWW/k-12/airplane/trbtyp.html [Ziyaret Tarihi: 23 Mayıs 2013].
[12] İstanbul Teknik Üniversitesi [Online], http://ninova.itu.edu.tr/tr/dersler/ucak-uzay-fakultesi/779/uck-474/ekkaynaklar?g72116 [Ziyaret Tarihi: 24 Mayıs 2013].
[13] Airforce-technology [Online], http://www.airforce-technology.com/projects/f-4-phantom-fighter-bomber/ [Ziyaret Tarihi: 27 Mayıs 2013].
[14] GE Aviation [Online], http://www.geaviation.com/engines/military/f110/f110-129.html [Ziyaret Tarihi: 27 Mayıs 2013].
[15] Lockheed Martin [Online], http://www.lockheedmartin.com/us/products/f16.html [Ziyaret Tarihi: 28 Mayıs 2013].
[16] EverySpec [Online], http://www.everyspec.com/MIL-PRF/MIL-PRF-000100-09999/MIL-PRF-7808L_5699/ [Ziyaret Tarihi: 29 Mayıs 2013].
[17] Turbine Powered [Online], http://www.turbinefun.com/Turbine_Engine_Oils.asp [Ziyaret Tarihi: 30 Mayıs 2013].
[18] EverySpec [Online], http://www.everyspec.com/MIL-PRF/MIL-PRF-010000-29999/MIL-PRF-23699F_6702/ [Ziyaret Tarihi: 29 Mayıs 2013].
[19] Beane, G.A., Gschwender, L.J. and Shimski, J.T., “Military Aircraft Propulsion Lubricants- Current and Future Trends”, AGARD-CP-294, Conference proceedings No. 394, Aircraft Gear and Bearing Systems, 1986.
[20] USA Naval Educatıon and Training Professional Development And technology Center [Online], http://www.navybmr.com/study%20material/navedtra%2014008.pdf [Ziyaret Tarihi: 30 Mayıs 2013].
[21] Exxon Mobil Aviation Lubricants (2013) [Online], http://www.exxonmobil.com/lubes/exxonmobil/emal/files/TTopic15_UsedOilEval.pdf [Ziyaret Tarihi: 4 Haziran 2013].
[22] Bonanno, A. S., Bassilakis, R. and Serio, M., “TG-FTIR methods for the evaluation of lubricant contamination,” ACS Div. of Fuel Chem. Prepr. 41 (1), 62–70, 1996.
[23] Ake, F. K. “J79-15/-17 Turbojet Engine Accident Investigation Procedures,” ASD-TR-75-19, 1975.
[24] Buhl, P. H., Henderson, C. M., Murphy, C. M. and Ravner, H., “Reclaiming of Deteriorated Specification MIL-L-7808 Aircraft Gas Turbine Oils”, NRL Memorandum Report 674, U.S. Naval Research Laboratory, Washington, 1957.
[25] Feinberg, F., “Evaluation of MIL-L-23699 Lubricating Oil Performance in the J79 Engine”, Naval Air Propulsion Test Center Trenton N J, 1974.
[26] Türk Hava Kuvvetleri Komutanlığı [Online], http://www.hvlojk.tsk.tr/iha/TURK%20KATALOG11%20(IDEF).pdf [Ziyaret Tarihi: 7 Haziran 2013].
[27] Türk Hava Kuvvetleri Komutanlığı [Online], http://www.hvkk.tsk.tr/TR/EnvanterdekiUcaklar.aspx?ID=7 [Ziyaret Tarihi: 12 Haziran 2013].
[28] Türk Hava Kuvvetleri Komutanlığı [Online], http://www.hvkk.tsk.tr/TR/Fotogaleri.aspx?ID=69 [Ziyaret Tarihi: 12 Haziran 2013].
[29] Schwetje, A., Varır, A., Hamarat, E. Ve Özdoğan, J., “Özel Atık ile İlgili AB Direktiflerinin Uyumlaştırılması ve Uygulamaları”, Çevre ve Orman Bakanlığı, Ankara, 2007.
[30] ASTM D 6595-00, Standard Test Method for Determination of Wear Metals and Contaminants in Used Lubricating Oils or Used Hydraulic Fluids by Rotating Disc Electrode Atomic Emission Spectrometry, American Society for Testing and Materials (ASTM), West Conshohocken, Pennsylvania, 2005.
[31] Standard Methods For The Examination of Water and Wastewater, Method 4110 B, Ion Chromatography with Chemical Suppression of Eluent Conductivity. American Public Health Association, 21st Edition, 2005.
[32] EN 12766-1, Petroleum products and used oils – Determination of PCBs and related products – Part 1: Separation and determination of selected PCB congeners by gas chromatography (GC) using an electron capture detector (ECD), 2000.
[33] EN 12766-2, Petroleum products and used oils – Determination of PCBs and related products – Part 2: Calculation of polychlorinated biphenyl (PCB) content, 2001.
[34] ASTM D 6450-05, Standard Test Method for Flash Point by Continuously Closed Cup (CCCFP) Tester. American Society for Testing and Materials (ASTM), West Conshohocken, Pennsylvania, 2010.
[35] Exxon Mobil Aviation Lubricants [Online], http://www.exxonmobil.com/USA-English/Aviation/PDS/GLXXENAVIEMMobil_Jet_Oil_II.aspx [Ziyaret Tarihi: 18 Haziran 2013].
[36] Ritchie, G.D., Still, K.R., Rossi, J. III, Bekkedal, M. Y.-V., Bobb A.J. and Arfsten, D.P., “Biological and health effects of exposure to kerosene-based jet fuels and performance additives”, J. Toxicol. Environ, Health B Crit. Rev. 6(4), 357-451, 2003.
[37] University of Washington [Online], http://courses.washington.edu/ [Ziyaret Tarihi: 21 Haziran 2013].
[38] Roza, G., “Understanding the Elements of the Periodic Table-Bromine”, First Edition, The Rosen Publishing Group Inc., New York, 2009.

Details

Primary Language

English

Subjects

-

Journal Section

Research Article

Authors

Volkan Pelitli This is me
Türkiye

Özgür Doğan This is me
Türkiye

H. Jülide Köroğlu This is me
Türkiye

Publication Date

March 1, 2014

Submission Date

September 4, 2013

Acceptance Date

December 12, 2013

Published in Issue

Year 2014 Volume: 32 Number: 1

IZ

https://izlik.org/JA56SZ65GJ

Cite

RIS / Bibtex

APA

Pelitli, V., Doğan, Ö., & Köroğlu, H. J. (2014). CHARACTERIZATION OF WASTE OILS IN AIR-BREATHING JET TURBINE ENGINES. Sigma Journal of Engineering and Natural Sciences, 32(1), 82-95. https://izlik.org/JA56SZ65GJ

AMA

1.Pelitli V, Doğan Ö, Köroğlu HJ. CHARACTERIZATION OF WASTE OILS IN AIR-BREATHING JET TURBINE ENGINES. SIGMA. 2014;32(1):82-95. https://izlik.org/JA56SZ65GJ

Chicago

Pelitli, Volkan, Özgür Doğan, and H. Jülide Köroğlu. 2014. “CHARACTERIZATION OF WASTE OILS IN AIR-BREATHING JET TURBINE ENGINES”. Sigma Journal of Engineering and Natural Sciences 32 (1): 82-95. https://izlik.org/JA56SZ65GJ.

EndNote

Pelitli V, Doğan Ö, Köroğlu HJ (March 1, 2014) CHARACTERIZATION OF WASTE OILS IN AIR-BREATHING JET TURBINE ENGINES. Sigma Journal of Engineering and Natural Sciences 32 1 82–95.

IEEE

[1]V. Pelitli, Ö. Doğan, and H. J. Köroğlu, “CHARACTERIZATION OF WASTE OILS IN AIR-BREATHING JET TURBINE ENGINES”, SIGMA, vol. 32, no. 1, pp. 82–95, Mar. 2014, [Online]. Available: https://izlik.org/JA56SZ65GJ

ISNAD

Pelitli, Volkan - Doğan, Özgür - Köroğlu, H. Jülide. “CHARACTERIZATION OF WASTE OILS IN AIR-BREATHING JET TURBINE ENGINES”. Sigma Journal of Engineering and Natural Sciences 32/1 (March 1, 2014): 82-95. https://izlik.org/JA56SZ65GJ.

JAMA

1.Pelitli V, Doğan Ö, Köroğlu HJ. CHARACTERIZATION OF WASTE OILS IN AIR-BREATHING JET TURBINE ENGINES. SIGMA. 2014;32:82–95.

MLA

Pelitli, Volkan, et al. “CHARACTERIZATION OF WASTE OILS IN AIR-BREATHING JET TURBINE ENGINES”. Sigma Journal of Engineering and Natural Sciences, vol. 32, no. 1, Mar. 2014, pp. 82-95, https://izlik.org/JA56SZ65GJ.

Vancouver

1.Volkan Pelitli, Özgür Doğan, H. Jülide Köroğlu. CHARACTERIZATION OF WASTE OILS IN AIR-BREATHING JET TURBINE ENGINES. SIGMA [Internet]. 2014 Mar. 1;32(1):82-95. Available from: https://izlik.org/JA56SZ65GJ