Effect of the position of the hot source on mixed convection in a rectangular cavity

Abstract

This work presents a study by numerical simulation of mixed convection in a rectangular cavity with a sinusoidal temperature imposed on the right vertical wall while the other wall on the left is kept at a cold temperature. The upper and lower walls are thermally insulated, the inlet and outlet ports are respectively located on the hot wall to the bottom and on the top to the left. The enclosure represents a practical system such as an air-cooled electronic device, the heat source represents a radiator or an electronic component located in three different positions towards the left side at the bottom, the center and towards the right side at the top in such an enclosure. All calculations are made for a range of Richardson number from 0 to 10 and Reynolds numbers from 50 to 200. The influence of Richardson number, the position of the heat source and the influence of amplitude and phase deviation of the temperature imposed on the Nusselt number on the hot surface is studied. The results are presented in the form of streamlines and isotherms graphs as well as the variation in maximum temperature and mean Nusselt number under different conditions. The numerical resolution of the governing equations is obtained using the software of Multiphysics Comsol based on the finite element method.

Keywords

• Numerical Heat Transfer
• Rectangular Enclosure
• Mixed Convection
• Position of the Hot Source
• Cooling
• Sinusoidal Temperature
• Finite Element Methods

References

1. The article references can be accessed from the .pdf file.