Gas-liquid two-phase flow pressure drop in flattened tubes: an experimental and numerical study

Year 2024, Volume: 10 Issue: 1, 196 - 206, 31.01.2024

Banipal Nanno Yaqop

https://doi.org/10.18186/thermal.1429927

Abstract

Experimental, numerical and empirical research is carried out on pressure drop features of air-water two-phase flow in horizontal flattened tubes. Circular tubes of 10.5 mm I.D. made of copper were successively flattened into inner heights of 9, 8, and 6 mm (AR=1.27, 1.5, and 2.2, respectively). The experiment operation conditions were 200, 500, and 1000 kg/m2s for mass velocity, 6, 8, 10 LPM for flow rate, and 0 to 0.005 for gas quality. Also, the pressure drop for R134a and R410A was estimated numerically using ANSYS Fluent. The simulation test condi-tions were for vapor quality of 0.1 to 0.9 and saturation temperature of 40°C, while the condi-tions for mass velocity and flowrate are taken as that of the experiment test. The experimental data were examined to see how different factors affect on the pressure gradient. According to the outcomes and as compared to the circular tube, the pressure gradient was raised up to 27%, 95%, and 218% for tubes flattened with aspect ratio of 1.27, 1.5, and 2.2, respectively. More-over, the pressure drop for either air-water or refrigerant fluids is increased dramatically with increasing flow rate, but it decreases with increasing vapor quality. When compared to known circular tube correlations, a good agreement was achieved. Finally, the minimum difference between the experimental, numerical, and correlated results was less than 3% for gas quality of 0.0048 and aspect ratio of 2.2.

Keywords

Flattened Tube Pressure Drop, Two-Phase Flow, Numerical Model, Aspect Ratio, Refrigerant Fluids

References

• REFERENCES
• [1] Russell CMB. Condensation of Steam in a Long Reflux Tube. In: Heat Transfer and Fluid Flow Service: HTFS Research Symposium; 1980. Paper No. HTFS RS 352.
• [2] Schoenfeld PD, Kroger DG. Flooding during reflux condensation of steam in an inclined elliptical tube. Proceedings of the International Conference on Heat Exchangers for Sustainable Development. Lisbon, Portugal; 1998. p. 107–115.
• [3] Fiedler S, Auracher H. Pressure drop during reflux condensation of R134A in a small diameter tube. Exp Therm Fluid Sci 2004;28:139–144. [CrossRef]
• [4] Fajriocta U, Jong TO, Agus SP. Evaluation of Pressure Drop of Two-Phase Flow Boiling with R290 in Horizontal Mini Channel. J Adv Res Fluid Mech Therm Sci 2022;89:160–166. [CrossRef]
• [5] Muhammad SA, Zahid A, Mujtaba MA, et al. Two-phase frictional pressure drop with pure refrigerants in vertical mini/micro-channels. Case Stud Therm Eng 2021;23:1–11. [CrossRef]
• [6] Saisorn S, Wongwises S. Flow pattern, void fraction and pressure drop of two-phase air–water flow in a horizontal circular micro-channel. Exp Therm Fluid Sci 2008;32:748–760. [CrossRef]
• [7] Triplett KA, Ghiaasiaan SM, Abdel-Khalik SI, LeMouel A, McCord BN. Gas liquid two-phase flow in microchannels. Part II: void fraction and pressure drop. Int J Multiphase Flow 1999;25:395–410. [CrossRef]
• [8] Ahmadpour A, Noori Rahim Abadi SMA. Thermal-hydraulic performance evaluation of gas-liquid multiphase flows in a vertical sinusoidal wavy channel in the presence/absence of phase change. Int J Heat Mass Transf 2019;138:677–689. [CrossRef]
• [9] Rout SK, Mishra DP, Nath TD, Asit KA. Numerical Analysis of Mixed Convection through an Internally Finned Tube. Adv Mech Eng 2012;4:1–10. [CrossRef]
• [10] Rout SK, Nath TD, Asit KA, Mishra DP. CFD supported performance estimation of an internally finned tube heat exchanger under mixed convection flow. Procedia Eng 2012;38:585–597. [CrossRef]
• [11] Kim HK, Lee EJ, Byun HW. Condensation heat transfer and pressure drop in flattened smooth tubes having different aspect ratios. Exp Thermal Fluid Sci 2013a;46:245–253. [CrossRef]
• [12] Razi P, Akhavan-Behabadi MA, Saeedinia M. Pressure drop and thermal characteristics of CuO–base oil nanofluid laminar flow in flattened tubes under constant heat flux. Int Commun Heat Mass Transf 2011;38:964–971. [CrossRef]
• [13] Yousefi E, Nazif HR, Khaboshan HN, Azarinia A. Non-Uniform Magnetic Field Effect on Forced Convection Heat Transfer of Flattened Tubes Using Two-Phase Mixture Model. Heat Transfer Eng 2020;42:1041–1058. [CrossRef]
• [14] Quiben JM, Cheng L, Lima RJDS, Thome JR. Flow boiling in horizontal flattened tube: Part I – Two-phase frictional pressure drop results and model. Int J Heat Mass Transf 2009;52:3634–3644. [CrossRef]
• [15] Thome JR, Quiben JM. Refrigeration Evaporation Characteristics inside Flat Passages. ARTI Final Report ARTI-21CR/605-20040-01; 2004. Arlington, VA, USA.
• [16] Wilson MJ, Newella TA, Chatoa JC, Infante Ferreira CA. Refrigerant charge, pressure drop, and condensation heat transfer in flattened tubes. Int J Refrigeration 2003;26:442–451. [CrossRef]
• [17] Koyama S, Kuwaharaa K, Nakashitaa K, Yamamotob K. An experimental study on condensation of refrigerant R134a in a multi-port extruded tube. Int J Refrigeration 2003;24:425–432. [CrossRef]
• [18] Mohammed Gh MK, Muna SK, Raid AM. Experimental investigation of coolant side characteristic on the performance of air-cooled condenser structured by horizontal flattened tube. Int J Heat Tech 2022;40:828–836. [CrossRef]
• [19] Seyyed MANR Abadi, William AD, Pega H, Josua PM. Numerical study of steam condensation inside a long inclined flattened channel. Int J Heat Mass Transf 2019;134:450–467. [CrossRef]
• [20] Cheng L, Mewes D. Review of two-phase flow and flow boiling of mixtures in small and mini channels. Int J Multiphase Flow 2006;32:183–207. [CrossRef]
• [21] Mahdi F, Morteza K-Aliabadi, Ashkan A. A parametric study on heat transfer and pressure drop characteristics of circular tube with alternating flattened flow path. Int J Therm Sci 2021;160:1–18. [CrossRef]
• [22] Darzi M, Akhavan-Behabadi MA, Sadoughi MK, Razi P. Experimental study of horizontal flattened tubes performance on condensation of R600a vapor. Int Commun Heat Mass Transf 2015;62:18–25. [CrossRef]
• [23] Nasr M, Akhavan-Behabadi MA, Marashim SE. Performance evaluation of flattened tube in boiling heat transfer enhancement and its effect on pressure drop. Int Commun Heat Mass Transf 2010;37:430–436. [CrossRef]
• [24] Cristiano BT, Ribatski G, Thome JR. Saturated flow boiling heat transfer and critical heat flux in small horizontal flattened tubes. Int J Heat Mass Transf 2012;55:7873–7883. [CrossRef]
• [25] Akhavan-Behabadi, Sadoughi MK, Darzi M, Fakoor-Pakdaman M, Abbasi A. Simultaneous Effects of Flattening Tube and Adding Nanoparticles on Boiling Heat Transfer. J Thermophysics Heat Transfer 2017;31:78–85. [CrossRef]
• [26] Kim HK, Lee EJ, Byun HW. Evaporation heat transfer and pressure drop of R-410A in flattened smooth tubes having different aspect ratios. Int J Refrigeration 2013b;36:363–374. [CrossRef]
• [27] Lee EJ, Kim NH. Evaporation heat transfer and pressure drop in flattened microfin tubes having different aspect ratios. Int J Heat Mass Transf 2016;92:283–297. [CrossRef]
• [28] Fazelnia H, Sajadi B, Azarhazin S, Akhavan-Behabadi MA, Zakeralhoseini S. Experimental study of the heat transfer coefficient and pressure drop of R1234yf condensing flow in flattened smooth tubes. Int J Refrigeration 2019;106:120–132. [CrossRef]
• [29] Azarhazin S, Sajadi B, Fazelnia H, Behabadi M, Zakeralhoseini S. Boiling heat transfer coefficient and pressure drop of R1234yf flow inside smooth flattened tubes: An experimental study. Appl Therm Eng 2020;165:114595. [CrossRef]
• [30] Zhang J, Li W, Sherif SA. A numerical study of condensation heat transfer and pressure drop in horizontal round and flattened minichannels. Int J Therm Sci 2016;106:80–93. [CrossRef]
• [31] Lockhart RW, Martinelli RC. Proposed correlation of data for isothermal two-phase, two-component flow in pipes. Chem Eng Prog 1949;45:39–48.