WASTE MINERAL OILS RE-REFINING WITH PHYSICOCHEMICAL METHODS

Year 2020, , 62 - 69, 01.04.2020

Ufuk Vural

https://doi.org/10.31127/tuje.616960

Cited By: 7

Abstract

Refining of waste mineral oils is usually done by distillation or acid/clay methods, or a combination of both. In this study, waste oil refining was carried out in order to obtain higher efficiency than acid /clay method by using more environmentally friendly physicochemical methods which could be an alternative to acid /clay method and distillation methods. For this purpose, demetalization and decolorization stages were applied in order. It was observed that the oils obtained had equivalent parameters to base oils.

Keywords

Waste Mineral Oil, Recycling, Re-refining

References

• Abu-Elella, R., Ossman, M.E., Farouq, R., AbdElfatah, M. (2015), “Used motor oil treatment: turning waste oil into valuable products”, International Journal of Chemical and Biochemical Sciences. Vol. 7, pp. 57-67.
• Arner, R, (1992). “Used Oil Recycling Markets and Best Management Practice in the United States”, Presented to the National Recycling Congress, Boston, USA.
• Arpa, O., Yumrutas, R., Demirbas, A. (2010). “Production of diesel-like fuel from waste engine oil by pyrolytic distillation”, Appl Energy, Vol. 87, pp. 122-127.
• Bhushan, Z. K., Anil, S. M., Sainand, K., Shivkumar, H. (2016). “Comparison between Different Methods of Waste Oil Recovery”, International Journal of Innovative Research in Science, Engineering and Technology. Vol. 5, No. 11, pp. 2001-2009.
• Boadu, K. O., Joel, O. F., Essumang, D. K. and Evbuomwan, B. O., (2019). “A Review of Methods for Removal of Contaminants in Used Lubricating Oil”, Chemical Science International Journal, Vol. 26, No. 4, pp. 1-11
• Bridjanian, H., Sattarin, M. (2006). “Modern recovery methods in used oil rerefining”, Petrol Coal Vol. 48, pp. 40–43.
• Diphare, M. J., Muzenda, E., Pilusa, I. J., Mollagee, M., (2015). “A Comparison of Waste Lubricating Oil Treatment Techniques”, 2nd International Conference on Environment, Agriculture and Food Sciences (ICEAFS'2013) August 25-26, Kuala Lumpur (Malaysia)
• Diran, B. (1997). “The Little Adsorption Book: A Practical Guide for Engineers and Scientists”. CRC Press, Boca Raton, FL, USA.
• Durrani, H.A. (2014). “Re-Refining Recovery methods of used lubricating oil”, International Journal of Engineering Sciences & Research Technology. Vol. 3, No. 3, pp. 1216-1220.
• Giovanna, F. D., Khlebinskaia, O., Lodolo, A. and Miertus, S. (2003). “Compendium of Used Oil Regeneration Technologies”, International Centre for Science and High Technology of the United Nations Industrial Development Organization (ICS-UNIDO), Trieste. 1-210
• Hamad, A., Al-Zubaidya, E., Muhammad, E.F. (2005). “Used lubricating oil recycling using hydrocarbon solvents”, Environ. Manage. Vol. 74, pp. 153–159.
• Hamawand, I., Yusaf, T., Rafat, S. (2013), “Recycling of waste engine oils using a new washing agent”, Energies. pp.1023-1049.
• Hani, F. B., Al-Wedyan, H. (2011), “Regeneration of Base-Oil from Waste-Oil under Different Conditions and Variables”, African Journal of Biotechnology”, pp. 1150-1153.
• Havemann, R. (1978), “The KTI used oil re-refining process”. In Proceedings of the 3rd International Conference of Used Oil Recovery and Reuse, Houston, TX, USA, pp. 16–18.
• Hegazi, S. E. F, Mohamd, Y. A., Hassan, M. I. (2017). “Recycling of waste engine oils using different acids as washing agents”, International Journal of Oil, Gas and Coal Engineering, Vol(5), No.5, pp.69-74.
• Kalnes, T., (1990). “Treatment and recycling of waste lubricants”. A petroleum refinery integration study. In: AICHE National Meeting, San Diego, CA, pp. 19–22.
• Kannan S. C., Mohan Kumar, K. S., Sakeer Hussain, M., Deepa Priya, N. K. (2014), “Studies on reuse of refined used automotive lubricant oil”, Research Journal of Engineering Science. Vol. 3, No. 6, pp. 8-14.
• Lam, S. S. And Chase, A. A. (2012). “A Review on Waste to Energy Processes Using Microwave Pyrolysis”, Energies. Vol.5, pp. 4209-4232.
• Lam, S.S., Liewa, K. K., Jusoh, A. A., Chong, C. T., Ani, F. N., Chase, H. A.(2016). “Progress in waste oil to sustainable energy, with emphasis on pyrolysis techniques”. Renewable and Sustainable Energy Reviews. Vol. 53, pp. 714-753.
• Oladimeji, T. E, Sonibare, J. A, Omoleye, J. A, Adegbola, A. A, Okagbue, H. I. (2018). “Data on the treatment of used lubricating oil from two different sources using solvent extraction and adsorption”, Data in Brief. Vol. 19, pp. 2240- 2252.
• Ouffoue, S. K, Oura, L., YAPO, K. D., Coffy A. A., (2013). “Physicochemical characterization of waste oils and analysis of the residues in contaminated soil”, International Journal of Environmental Monitoring and Analysis, Vol. 1, No. 4, pp 162-166.
• Puerto-Ferre, E., Kajdas, C. (1994). “Clean technology for recycling waste lubricating oils”, In Proceedings of 9th International Colloquium, Ecological and Economic Aspects of Tribology, Esslingen, Germany, pp. 14–16.
• Quang, D. V., Carriero, G., Schieppati, R., Comte, A., Andrews, J. W. (1974), “Propane purification of used lubricating oils”. Hydrocarb. Process, Vol. 53, pp. 129–131.
• Resmî gazete. (2008). “Atık yağların kontrolü yönetmeliği”. Sayı: 26952.
• Rincon, J., Canizares, P., Garcia, M. T. 2005), “Regeneration of used lubricating oil by polar solvent extraction”. Ind. Eng. Chem. Res. Vol. 44: pp. 43-73.
• Rincon, J., Canizares, P., Garcia, M. T., Gracia, I. (2003), “Regeneration of used lubricant oil by propane extraction”. Ind. Eng. Chem. Res. Vol. 42, pp. 4867–4873.
• Secretariat of the Stockholm Convention on Persistent Organic Pollutants, (2007). “Guidelines On Best Available Techniques And Provisional Guidance On Best Environmental Practices, Relevant to Article 5 and AnnexC of the Stockholm Convention on Persistent Organic Pollutants”, United Nations Environment Programme, International Environment House. Geneva, Switzerland
• Udonne, J. D., Bakare, O. A. (2013),.“Recycling of used lubricating oil using three samples of acids and clay as a method of treatment”. International Archive of Applied Sciences and Technology. Vol. 4, No. 2, pp. 8–14.
• US EPA (1996 ). “Managing Used Oil: Advice for Small Businesses”. Report. 530EPA-F-96-004.
• Web Map Tile Service, 1. http://www.cprac.org/docs/olis_eng.pdf (20.06.2019).
• Zitte L. F., Awi-Waadu, G. D. B. and Okorodike, C. G, (2016). “Used-Oil Generation and Its Disposal along East-West Road, Port Harcourt Nigeria”, International Journal of Waste Resources, Vol. 6, No. 1, 1-5.