Thermo-flow Analysis of Cylinder with Crossed Splitter Plates with a Characteristics-based Scheme

Yıl 2021, Cilt: 24 Sayı: 2, 83 - 91, 26.05.2021

Seyed Esmail Razavi Tohid Adibi Hussein Hassanpour

https://doi.org/10.5541/ijot.783614

Cited By: 2

Öz

In the present work, the laminar flow through a circular cylinder with two crossed splitter plates is analyzed. The characteristic-based method has been used along with the unstructured grid. The current research has been done to detect the proper conditions according to the geometrical parameters in which the optimal heat transfer is taking place. Geometric control parameters are the angle of splitter plates (\theta) and the ratio of length of the splitter plate to cylinder radius (n=L/D). It was found that the use of a two-branched splitter plate is not wise in Reynolds number less than 100 due to its insignificant effect in flow properties. In angle 30° between two plates, the least drag force is witnessed with respect to other angles. Application of double branched splitter with angles more than 60° is not recommended, which will increase the total drag significantly. Since the splitter plate increases, the overall heat transfer from the cylinder and splitter set is enhanced. Minimum drag over the cylinder, and maximum convection drop from it is taken place when the dimension length is 0.75. Between dimensionless lengths 1.25 and 1.5, the Nusselt number oscillates with least amplitude and such behavior is also observed when two splitters are 60°apart.

Anahtar Kelimeler

Double splitter plate, incompressible flow, Navier-stokes equations, Nusselt number

Kaynakça

• [1] T. Adibi, S. E. Razavi, and O. Adibi, "A Characteristic-based Numerical Simulation of Water-titanium Dioxide Nano-fluid in Closed Domains," International Journal of Engineering. 33. 1. 158-163, 2020
• [2] M. Y. Malik, M. Awais, T. Salahuddin, A. Hussain, and S. Bilal, "Mixed-convection boundary-layer flow of Sisko fluid along a stretching cylinder in a thermally strati ed medium," Scientia Iranica. 23. 6. 2587-2594, 2016
• [3] R. Bayat and A. B. Rahimi, "Numerical solution to N-S equations in the case of unsteady axisymmetric stagnation-point flow on a vertical circular cylinder with mixed convection heat transfer," Scientia Iranica. 25. 4. 2130-2143, 2018
• [4] F. Gu, J. S. Wang, X. Q. Qiao, and Z. Huang, "Pressure distribution, fluctuating forces and vortex shedding behavior of circular cylinder with rotatable splitter plates," Journal of Fluids and Structures. 28. 263-278, 2012
• [5] A. Igbalajobi, J. F. McClean, D. Sumner, and D. J. Bergstrom, "The effect of a wake-mounted splitter plate on the flow around a surface-mounted finite-height circular cylinder," Journal of Fluids and Structures. 37. 185-200, 2013
• [6] N. Boisaubert and A. Texier, "Effect of a splitter plate on the near-wake development of a semi-circular cylinder," Experimental Thermal and Fluid Science. 16. 1. 100-111, 1998
• [7] S. Shukla, R. N. Govardhan, and J. H. Arakeri, "Flow over a cylinder with a hinged-splitter plate," Journal of Fluids and Structures. 25. 4. 713-720, 2009
• [8] S. Tiwari, D. Chakraborty, G. Biswas, and P. K. Panigrahi, "Numerical prediction of flow and heat transfer in a channel in the presence of a built-in circular tube with and without an integral wake splitter," International Journal of Heat and Mass Transfer. 48. 2. 439-453, 2005
• [9] H. Akilli, B. Sahin, and N. Filiz Tumen, "Suppression of vortex shedding of circular cylinder in shallow water by a splitter plate," Flow Measurement and Instrumentation. 16. 4. 211-219, 2005
• [10] X. An, B. Song, W. Tian, and C. Ma, "Numerical Research of Flow past a Circular Cylinder with Splitter Plate at a Subcritical Reynolds Number Region," Journal of Shanghai Jiaotong University (Science). 24. 1. 113-121, 2019
• [11] T. R. Sahu, M. Furquan, Y. Jaiswal, and S. Mittal, "Flow-induced vibration of a circular cylinder with rigid splitter plate," Journal of Fluids and Structures, 2019
• [12] A. Ghiasi, "Numerical study on flow over a confined oscillating cylinder with a splitter plate," International Journal of Numerical Methods for Heat & Fluid Flow. 29. 5. 1629-1646, 2019
• [13] R. Mishra, S. S. Kulkarni, R. Bhardwaj, and M. C. Thompson, "Response of a linear viscoelastic splitter plate attached to a cylinder in laminar flow," Journal of Fluids and Structures. 87. 284-301, 2019
• [14] M. K. Chauhan, S. Dutta, B. S. More, and B. K. Gandhi, "Experimental investigation of flow over a square cylinder with an attached splitter plate at intermediate reynolds number," Journal of Fluids and Structures. 76. 319-335, 2018
• [15] G. R. S. Assi and P. W. Bearman, "Transverse galloping of circular cylinders fitted with solid and slotted splitter plates," Journal of Fluids and Structures. 54. 263-280, 2015
• [16] G. Ghassabi and M. kahrom, "Heat Transfer Enhancement of a Flat Plate Boundary Layer Distributed by a Square Cylinder: Particle Image Velocimetry and Temperature-Sensitive Paint Measurements and Proper Orthogonal Decomposition Analysis," International Journal of Engineering. 31. 11. 1962-1971, 2018
• [17] S. E. Razavi and T. Adibi, "A novel multidimensional characteristic modeling of incompressible convective heat transfer," Journal of Applied Fluid Mechanics. 9. 4. 1135-1146, 2016
• [18] T. Adibi, "Three-dimensional characteristic approach for incompressible thermo-flows and influence of artificial compressibility parameter," Journal of Computational & Applied Research in Mechanical Engineering (JCARME). 8. 2. 223-234, 2019
• [19] T. Adibi, O. Adibi, and S. E. Razavi, "A characteristic-based solution of forced and free convection in closed domains with emphasis on various fluids " International Journal of Engineering. 32. 10. 1679-1685, 2019
• [20] T. Adibi and S. E. Razavi, "A new characteristic approach for incompressible thermo-flow in Cartesian and non-Cartesian grids," International Journal for Numerical Methods in Fluids. 79. 8. 371-393, 2015
• [21] S. W. Churchill and M. Bernstein, "a correlation coefficient for forced convection from gases and liquids to a circular cylinder in cross flow," J. Heat Transfer. 99. 300-306, 1977
• [22] Seyed Esmail Razavi, Vahid Farhangmehr, and F. Barar, " Impact of a Splitter Plate on Flow and Heat Transfer Around Circular Cylinder at Low Reynolds Numbers," Journal of Applied Sciences. 8. 1286-1292, 2008