Buck-type Single-phase AC-AC Active Tracking Voltage Regulator Controlled by an Enhanced Hybrid Control Method

Yıl 2021, , 926 - 937, 30.08.2021

Faruk Yalçın , Felix Hımmelstoss

https://doi.org/10.16984/saufenbilder.900419

Öz

In this paper, a single-phase switch-mode buck-type AC-AC voltage regulator is presented with reduced numbers of elements which are used in the topology. Apart from similar studies in the literature, a new hybrid control method which is structured by the closed-loop PID controller and a new enhanced feedforward controller is used for the control of the regulator. The hybrid controller improves the active tracking capability of the reference to achieve an output voltage as close to the sine-wave with high quality. The input AC voltage may be an ideal sine wave or it may include harmonics. Both simulation and experimental tests are applied for the proposed regulator controlled by this control method. The experimental set-up for the regulator is designed for 0-200 Vp input voltage (50 Hz), 0-100 Vp output voltage, and 0.6 kW output power. The results proved the capability of the proposed buck-type switch-mode regulator to achieve the requested output voltage as near as possible to sine wave. The obtained output voltages for different load conditions and input-output parameters have less than 5% THD (total harmonic distortion) and high quality.

Anahtar Kelimeler

AC-AC regulator, active tracking, buck converter, single-phase, harmonics

Kaynakça

• [1] D. M. Lee, T. G. Habetler, R. G. Harley, T. L. Keister, and J. R. Rostron, “A voltage sag supporter utilizing a PWM-switched autotransformer,” IEEE Transactions on Power Electronics, vol. 22, no. 2, pp. 626–635, 2007.
• [2] S. Subramanian and M. K. Mishra, “Interphase AC-AC topology for voltage sag supporter,” IEEE Transactions on Power Electronics, vol. 25, no. 2, pp. 514–518, 2010.
• [3] A. Moghassemi and S. Padmanaban, “Dynamic voltage restorer (DVR): a comprehensive review of topologies, power converters, control methods, and modified configurations,” Energies, vol. 13, no. 16, article number: 4152, 2020.
• [4] A. AbuHussein and M. A. H. Sadi, “Fault ride-through capability improvement of grid connected PV system using dynamic voltage restorer,” Electric Power Components and Systems, vol. 48, no. 12-13, pp. 1296–1307, 2020.
• [5] J. Kaniewski, P. Szczesniak, M. Jarnut, and G. Benysek, “Hybrid voltage sag/swell compensators a review of hybrid AC/AC converters,” IEEE Industrial Electronics Magazine, vol. 9, no. 4, pp. 37–48, 2015.
• [6] M. K. Nguyen, Y. C. Lim, and J. H. Choi, “Single-phase z-source-based voltage sag/swell compensator,” 2013 Twenty-Eighth Annual IEEE Applied Power Electronics Conference and Exposition, pp. 3138–3142, 2013.
• [7] H. Hafezi and R. Faranda, “Dynamic voltage conditioner: a new concept for smart low-voltage distribution systems,” IEEE Transactions on Power Electronics, vol. 33, no. 9, pp. 7582–7590, 2018.
• [8] R. Faranda, A. Bahrami, and H. Hafezi, “Fault current limiting investigation for a single-phase dynamic voltage conditioner,” 2019 IEEE Milan Powertech, 2019.
• [9] R. Gupta and A. Kumar, “Control of multi-cell AC/DC and cascaded H-bridge DC/AC-based AC/DC/AC converter,” IETE Journal of Research, early access, 2020.
• [10] P. D. Singh and S. Gao, “Fuzzy based AC-DC-AC converter controlled micro hydro renewable power generation using parallel asynchronous generators for remote areas,” International Journal of Renewable Energy Research, vol. 10, no. 1, pp. 260–273, 2020.
• [11] K. Venkatesha, H. A. Vidya, R. Sinha, and G. Jayachitra, “Experimental analysis of symmetrical & asymmetrical PWM based single phase AC chopper for power quality improvement using FPGA real time controller,” 2017 International Conference On Smart Grids, Power and Advanced Control Engineering, pp. 267–272, 2017.
• [12] Y. B. Wang, P. Wang, G. W. Cai, C. Liu, D. B. Guo, H. W. Zhang, and B. D. Zhu, “An improved bipolar-type AC-AC converter topology based on nondifferential dual-buck PWM AC choppers,” IEEE Transactions on Power Electronics, vol. 36, no. 4, pp. 4052–4065, 2021.
• [13] S. Kim, D. Jang, H. G. Kim, and H. Cha, “Cascaded dual-buck AC-AC converter using coupled inductors,” 2018 International Power Electronics Conference, pp. 2619–2624, 2018.
• [14] A. A. Khan, H. Cha, J. W. Baek, J. Kim, and J. Cho, “Cascaded dual-buck AC-AC converter with reduced number of inductors,” IEEE Transactions on Power Electronics, vol. 32, no. 10, pp. 7509–7520, 2017.
• [15] A. Chakraborty, A. Chakrabarti, and P. K. Sadhu, “Analysis of a full-bridge direct AC-AC boost converter based domestic induction heater,” Revue Roumaine Des Sciences Techniques - Serie Electrotechnique Et Energetique, vol. 64, no. 3, pp. 223–228, 2019.
• [16] H. Sarnago, O. Lucia, A. Mediano, and J. M. Burdio, “Direct AC-AC resonant boost converter for efficient domestic induction heating applications,” IEEE Transactions on Power Electronics, vol. 29, no. 3, pp. 1128–1139, 2014.
• [17] H. F. Ahmed, H. Cha, A. A. Khan, and H. G. Kim, “A novel buck-boost AC-AC converter with both inverting and noninverting operations and without commutation problem,” IEEE Transactions on Power Electronics, vol. 31, no. 6, pp. 4241–4251, 2016.
• [18] A. A. Khan and H. Y. Cha, “A novel highly reliable three-phase buck-boost AC-AC converter,” 2016 IEEE Energy Conversion Congress and Exposition, 2016.
• [19] F. Yalcin, U. Arifoglu, and I. Yazici, “A new single phase inverter based on buck converter,” Sakarya University Journal of Science, vol. 24, no. 3, pp. 480–486, 2020.
• [20] F. Himmelstoss, “Aktive netzfilter,” Austrian Patent, patent no: AT 505460 B1, filed 10 July 2007, applied 15 January 2012.