The Effect of Mould Filling on the Mechanical Properties of Wall Tile Production
Abstract
This study is focused on the development of properties of ceramic wall tile bodies by changing the degree of mould filling under industrial conditions (Usak Seramik A.S., Usak, Turkey). The effects of spray dryer operating conditions and granule size distribution on the degree of mould filling have been investigated. The study measured the ceramic wall tile bodies water absorption, fired shrinkage, fired and dried strength, and porosity. The granule size and distribution were changed by adjusting the pressure and the nozzles’ diameter of the spray dryer. This study aimed to reduce grain size and quantity over 500 microns and to increase quantity between 500 microns and 75 microns by increasing the spray dryer pressure and reducing the nozzle disc diameter. It was also aimed to increase the degree of mould filling by decreasing granule size. 200 tone wall tile slips were prepared and 11,000 m2 of wall tile products were produced. The phase and microstructure analysis were investigated using an X-ray diffractometer (XRD) and scanning electron microscope (SEM). As a result of this study, it was found that a lower granule size of above 500 µm improved the technical characteristics of the tiles. Ceramic wall tiles produced with lower granule grain size have high strength values, mainly due to the higher degree of mold filling. The ceramic tile production parameters in the Usak Seramik Company have been rearranged according to the data obtained from this study. This granule size and distribution set is now an industrial production standard in Usak Seramik.
Keywords
References
- Amorós JL, Orts MJ, Mestre S, Garcia-Ten J, Feliu C, Porous single-fired wall tile bodies: Influence of quartz particle size on tile properties, J. Eur. Ceram.Soc. 2010;30:17–28.
- Amoros JL, Sanchez E, Cantavella V, Monzo M, Mechanical properties of green ceramic bodies. Qualicer 2000; 59-75 Applied Ceramic Technology. Sacmi Imola, vol.2, p. 96-143, 2002, ISBN 88-88108-55-6.
- Aydin T, Tarhan M, Tarhan B, Addition of cement kiln dust in ceramic wall tile bodies. Journal of Thermal Analysis and Calorimetry. https://doi.org/10.1007/s10973-018-7615-y. 2019; 136: 527–533.
- Beddow JK, Particle & Particle Systems Characterization. Volume 12, Isssue 4, First published: August 1995https://doi.org/10.1002/ppsc.19950120411.
- Celik H. Technological characterization and industrial application of two Turkish clays for the ceramic industry. Applied Clay Science. 2010;50:245–254.
- Freire MN, Holanda JNF, Characterization of avian eggshell waste aiming its use in a ceramic wall tile paste. Cerâmica 2006;52:240-244.
- Kingery WD, Bowen HK, Uhlmann DR, Introduction to Ceramics. USA: John Wiley and Sons Inc;ISBN 0-471-47860-1. 1960. pp 809.
- Reed JS, Favalli R C, Pimenta MM, Paschoa JOA, Numerical simulation of spray dryers. Principles of ceramic s processing second ed. Qualicer 2002, pg. 3-10.
- Ring TA, Fundamentals of Ceramic Powder Processing and Synthesis. Academıc Press, Inc, 1996, p. 655.
- Santomaso A, Lazzaro P, Canu P, Powder flowability and density ratios: the impact of granules packing. Chemical Engineering Science. 2003; 58(13):2857-2874.