Bonding strength of polyvinyl acetate PVAc and casein adhesives in small diameter beech wood

Year 2016, Supplement 1, 36 - 40, 15.08.2016

Andromachi Mıtanı Ioannis Barboutıs

https://doi.org/10.15177/seefor.15-03

Abstract

As a matter of fact, beech wood is one of the most important commercial hardwood species in southeastern Europe. Beech is utilized mainly as round wood and fuel wood. Overall harvest of beech wood is comparable to those of pine and oak forests. Effective and maximum value use of small-diameter hardwood timber has long been of interest to forest managers and researchers. Gluing or bonding wood has been widely used for many centuries. Moreover, a wide variety of adhesives types is utilised, due to their extensive use in many different applications with wood. Beech wood Fagus sylvatica L. , was used in order to investigate the bond ability of beech wood. For the bonding the used adhesives were PVAc and casein glue, both of D3. The adhesives were applied to one or two surfaces and the half of them were immersed in water in order to investigate the influence of moisture on bonding strength. According to the results, the average modulus of rapture was influenced by the type of adhesive. The samples of beech wood bonded with PVAc had higher modulus of rapture compared to the samples of beech laminated with glue Casein-gap from 1.03 to 2.2 N/mm². Additionally, the highest average modulus of rapture rate recorded in beech samples coated with PVAc on both bonding surfaces reaches 21.05 N/mm². The statistical analysis of the results revealed that the average bonding strength of those samples only air-conditioned, did not show any statistically significant difference from the average bonding strength of the samples immersed in water

Keywords

beech wood, bonding, casein, PVAc, shear strength

References

• Burdurlu, E., Usta, I., Kilis, Y., Ulupinar, M. 2007. The effect on shear strength of different surfacing techniques in Oriental beech (Fagus orientalis Lipsky) and Scotch pine (Pinus sylvestris L.) bonded joints. Journal of adhesion science and technology, 21, 3-4, 319-330(12).
• Cassens, D. 2007. Hardwood lumber and veneer series-Basswood. Purdue University. Purdue extension. FNR-274-W.
• EN 205, 2003. Adhesives. Wood adhesives for non-structural applications. Determination of tensile shear strength of lap joints.
• EN 204, 2001. Classification of thermoplastic wood adhesives for non-structural applications.
• Ertekin, M., Kırdar, E., Ayan, S. 2015. The effects of exposure, elevation and tree age on seed characteristics of Fagus orientalis Lipsky. South-east Eur for 6 (1): 15-23. DOI: http://dx.doi.org/10.15177/seefor.15-03
• Frihart, R. Charles 2005. USDA, Forest service, Forest products laboratory, Madison, WI: Wood adhesion and adhesives. Handbook of wood chemistry and wood composites.
• Keskin, H., Atar, M., Akyildiz, H. 2009. Bonding strengths of polyvinyl acetate, desmodur-VTKA, phenol- formaldehyde and urea-formaldehyde adhesives in wood materials impregnated with Vacsol Azure. Materials and Design. 30, 3789-3794, Turkey.
• Konnerth, J., Wolfgang, G., Harm, M., Muller, U. 2006. Comparison dry strength of spruce and beech wood glyed with different adhesives by means of scarf- and lap joints testing method. Holz als Roh- und Werkstoff.. 64: 269-271. Austria
• Özçifci, A., Yapici, F. 2008. Effects of machining method and grain orientation on the bonding strength of some wood species. Journal of materials processing technology. 202, 353-358. Turkey.
• Pizzo, B., Lavisci, P., Misani, C., Triboulot, P., Macchoni, N. 2003. Measuring the shear strength ratio of glued joints within the same specimen. Holz Roh-Werkst. 61:273-280.
• Pohler, E., Klingner, R., Kunniger, T. 2005. Beech (Fagus sylvatica L.) - Technological properties, adhesion behavior and colour stability with and without coatings of the red heartwood. Switzerland.
• Rowland, G. Adhesives and adhesion. 1998. CHEM NZ. No 71, 17-27.
• Skarvelis, M., Mantanis, G. I. 2010. Physical and mechanical properties of beech wood harvested in the Greek public forests. Wood Researches, 58 (1).
• Tout, R. 2000. A review of adhesives for furniture. International Journal of Adhesion & Adhesives. Elsevier science Ltd. 20, 269-272.
• Vassiliou, V., Barboutis, I., Karastergiou, S. 2000. Bending strength properties of finger-joined with PVAc glue beech wood. Scientific anniversary of Forestry and Natural Environment Faculty. 43 .513-529.
• Gardner, D.J. 2006. Adhesion mechanisms of durable wood adhesive bonds. in D.D. Stokke, L.H. Groom (Eds.), Characterization of the Cellulosic Cell Wall. Chapter 19, 254 – 265. Blackwell Publishing.
• Wiedenbeck, J. K., Blankenhorn, P. R., Scholl, M., Stover, L. R. 2003. Small-diameter hardwood utilization with emphasis on higher value. www.ncsu.edu/feop/symposium/procedings_2003
• Matthew, S., Bumgardner, Bruce G., Hansen, Albert T., Schuler and Philip, A. 2000. Araman Options for small diameter hardwood utilization. Past and present. Proceedings of the Annual Meeting of the SOFEW.