Voltage Control of Cuk Converter with PI and Fuzzy Logic Controller in Continuous Current Mode

Yıl 2020, Cilt: 8 Sayı: 2, 127 - 134, 30.04.2020

Mehmet Yılmaz , Muhammedfatih Corapsiz , Muhammed Reşit Çorapsız

https://doi.org/10.17694/bajece.660025

Cited By: 3

Öz

In today's energy systems, many equipment operate with Direct Current (DC) voltage. However, it is not always possible to obtain the voltage level required for the operation of these equipment from standard power supplies. For this reason DC-DC converters are used to achieve the desired voltage values for equipment with different DC voltage levels. These converters are divided into three general categories, named Buck, Boost and Buck-Boost. The most preferred converter is the Cuk converter with low output ripple voltage, which can operate in both buck and boost modes. In this study, a detailed analysis of the Cuk converter, which is frequently used in Photovoltaic (PV) Panels was performed and different control methods of the output voltage were proposed. While performing this analysis, the dynamic model of the Cuk converter was created in which, Proportional-Integral (PI) and Fuzzy Logic (FL) are used to control the output voltage of the Cuk converter. The performances of both controllers were compared with respect to performance parameters such as steady state error, settling time and rise time. When the results obtained were evaluated as a whole, it was observed that FLC achieved the desired reference with less rise and settling time. In this study, modeling and controller applications of Cuk converter are realized by using MATLAB / SIMULINK program

Anahtar Kelimeler

DC-DC Converter, Cuk Converter, PI Controller, Fuzzy Logic Controller, Voltage Control

Kaynakça

• [1] Bodur, H., (2012).Power Electronics. İstanbul: Birsen Publisher.
• [2] Mohan, N., Undeland, T. M., & Robbins, W. P. (2003). Power electronics: converters, applications, and design. John wiley & sons.
• [3] Rashid M. H, R. (2015). Power Electronics Devices, Circuits and Applications. London: Pearson Education.
• [4] Gupta, Yelamarthi & P, Sri. (2014). Analysis and Design of CUK Converter using PI Controller for PV Application. International Journal for Scientific Research & Technology. 2. 2321-613.
• [5] Rakshit, Saptarshi & Maity, Jayabrata. (2018). Fuzzy Logic Controlled Ćuk Converter. 0771-0775. 10.1109/ICCSP.2018.8524168.
• [6] Boaretto, Fernanda & Junior, João & Marca, Ygor & Santos Dias de Moraes, Paulo Mario Dos & Kirsten, André. (2018). Small-Signal Modelling of the Cuk Converter. 10.13140/RG.2.2.17307.16164.
• [7] Assaf, Mohamed & Seshsachalam, D. & Chandra, Dinesh & Tripathi, Ramesh. (2005). DC-DC converters via matlab/simulink. 464-471.
• [8] Pires, V. & Foito, Daniel & Baptista, F.R.B. & Silva, Fernando. (2016). A photovoltaic generator system with a DC/DC converter based on an integrated Boost-Ćuk topology. Solar Energy. 136. 1-9. 10.1016/j.solener.2016.06.063.
• [9] Algazar, Mohamed & AL-monier, Hamdy & EL-halim, Hamdy & Salem, Mohamed. (2012). Maximum power point tracking using fuzzy logic control. International Journal of Electrical Power & Energy Systems. 39. 21-28. 10.1016/j.ijepes.2011.12.006.
• [10] G, Dileep & Singh, S.N.. (2017). Selection of non-isolated DC-DC converters for solar photovoltaic system. Renewable and Sustainable Energy Reviews. 76. 1230-1247. 10.1016/j.rser.2017.03.130.
• [11] Mehran, Kamyar & Giaouris, Damian & Zahawi, Bouchaib. (2009). Modeling and stability analysis of closed loop current-mode controlled Cuk converter using Takagi–Sugeno fuzzy approach. 2.
• [12] Cezar, Julio & Luiz, Juliano & Gules, Roger. (2018). Photovoltaic AC-Module Based on a Cuk Converter with a Switched-Inductor Structure. IEEE Transactions on Industrial Electronics. PP. 1-1. 10.1109/TIE.2018.2856202.
• [13] Tiwari Neeraj, Bhagwan Das D. MPPT controller for photo voltaic systems using Cuk DC/DC convertor. International Journal of Advanced Technology and Engineering Research (IJATER).
• [14] Algazar MohamedM, et al. Maximum power point tracking using fuzzy logic control. Int J Electr Power Energy Syst 2012; 39(1): 21–8.
• [15] Chen Zengshi.PI and sliding mode control of a Cuk converter. IEEE Trans PowerElectron 2012; 27(8): 3695– 703.
• [16] J. A. M. Bleijs and J. A.Gow,”Fast maximum power point control of current-fed DC-DC converter for photovoltaic arrays”,Electornic Letters, Vol. 37, No. 1, January 2001,pp. 5-6.
• [17] Singh MD. Power Electronics, Tata Mc Graw-Hill Education;2008, Different topologies are introduced based on the conventional Cuk converters that are given in the literature.
• [18] Corapsiz, M. F., & Erenturk, K. (2015). Trajectory tracking control and contouring performance of three-dimensional CNC. IEEE Transactions on Industrial Electronics, 63(4), 2212-2220.
• [19] Çorapsız, M. R.. "Performance Analysis of Speed Control of PMDC Motor using Fuzzy Logic Controller". Eastern Anatolian Journal of Science 3 / 2 (Kasım 2017): 16-29.
• [20] Çorapsız, M. R., Reduction of commutation torque ripples in brushless direct current motors, Karadeniz Technical University, Graduate Institute of Natural and Applied Sciences, Trabzon, 2018.
• [21] Kahveci, H., The implementation of an electronic differential system based on fuzzy logic for direct driven electric vehicles, Karadeniz Technical University, Graduate Institute of Natural and Applied Sciences, Trabzon, 2013.
• [22] Mamdani, E.H. ve Assilian, S., An Experiment in Linguistic Synthesis with A Fuzzy Logic Controller, International Journal of Man–Machine Studies, 7,1 (1975) 1–13.
• [23] DURANAY, Zeynep Bala, GULDEMIR, Hanifi . "Study of Fuzzy Logic Control of Dc-Dc Buck Converter". Fırat University Turkish Journal of Science and Technology 12 / 2 (Ekim 2017): 23-31.