Comparative Analysis of Bearing Capacity Methods for Batman Soils: A GIS-Based Approach

Öz

In this study, the spatial distribution of Standard Penetration Test (SPT) data and allowable bearing capacity calculations were evaluated for the central district of Batman, covering an area of approximately 54 km². Geotechnical data obtained from 253 boreholes were analyzed within a Geographic Information Systems (GIS) environment, and spatial prediction maps were generated for various depths (1.5, 3.0, 4.5, 7.5, 9.0, and 15.0 m) using the Inverse Distance Weighting (IDW) interpolation method. The allowable bearing capacities of the soils were calculated based on the empirical approaches proposed by Terzaghi and Peck (1967) and Meyerhof (1974), assuming a foundation width of 3 m. The analyses revealed that SPT-N values generally exhibit a linear increase with depth. At shallow depths, the northern and western parts of the study area—particularly near the Batman River (Girbereşik and Yeniköy)—are characterized by 'loose' to 'medium dense' soil formations, indicating low bearing capacity and potential settlement risks. The spatial distribution of bearing capacity showed that approximately 19% of the area has a low bearing capacity (< 163 kN/m²), 32% has a moderate capacity (163–325 kN/m²), and 49% presents a high bearing capacity (326–488 kN/m²). A comparison of the two analytical methods demonstrated a high degree of spatial compatibility; however, as depth and SPT-N values increased, the Meyerhof (1974) method yielded higher (more optimistic) bearing capacity values compared to the Terzaghi and Peck (1967) approach due to the influence of the depth factor. The GIS-based microzonation maps produced in this study provide a crucial spatial database for safe foundation design, urban planning, and earthquake risk mitigation in the region.

Anahtar Kelimeler

• Geographic information systems
• Standard penetration test
• Bearing capacity
• Inverse distance weighting

Kaynakça

1. Acar, M. C., & Özdemir, D. (2023). Geographical information system approach in evaluating geotechnical properties of soils: Kayseri Oymaağaç case study. Journal of the Faculty of Engineering and Architecture of Gazi University, 38(2), 1079–1092.
2. AFAD. (2025). AFAD earthquake catalog. Disaster and Emergency Management Presidency. https://deprem.afad.gov.tr/event-catalog
3. Aydın, K. (2010). A study on SPT-Vs correlation in Ankara metro routes [Master's thesis]. Gazi University, Graduate School of Natural and Applied Sciences, Turkey.
4. Barka, A. A. (1992). The North Anatolian fault zone. Annales Tectonicae, 6, 164–195.
5. Batman Provincial Directorate of Disaster and Emergency Management. (2022). Provincial disaster risk reduction plan (IRAP).
6. Bowles, J. E. (1996). Foundation analysis and design (5th ed.). McGraw-Hill Companies, Inc.
7. Çabalar, A. F., Canbolat, A., Akbulut, N., Tercan, S. H., & Işık, H. (2019). Soil liquefaction potential in Kahramanmaras, Turkey. Geomatics, Natural Hazards and Risk, 10(1), 1822–1838.
8. Çabalar, A. F., Karabas, B., Mahmutluoglu, B., & Yildiz, O. (2021). An IDW-based GIS application for assessment of geotechnical characterization in Erzincan, Turkey. Arabian Journal of Geosciences, 14(20), 2129. https://doi.org/10.1007/s12517-021-08535-6

9. Civelekler, E., & Pekkan, E. (2022). The application of GIS in visualization of geotechnical data (SPT-soil properties): A case study in Eskisehir-Tepebaşı, Turkey. International Journal of Engineering and Geosciences, 7(3), 302–313. https://doi.org/10.26833/ijeg.980611
10. Clayton, C. R. (1995). The standard penetration test (SPT): Methods and use. Construction Industry Research and Information Association.
11. Çinicioğlu, S. F. (2005, May). Understanding and calculation of bearing capacity under static and dynamic loads [Seminar]. UCTEA Chamber of Civil Engineers, Istanbul Branch.
12. Demir, G. (2013). Preparation of geo-engineering properties of the foundation soil in Gürsu (Bursa) residential area using Geographical Information Systems (GIS) [Master's thesis]. Balıkesir University, Institute of Science and Technology.
13. Demirtaş, O. (2022). Mapping geotechnical data by GIS: A case study of Elazığ city, Turkey (Master’s thesis, Hasan Kalyoncu University, Department of Civil Engineering).
14. Directorate of EIA and Permitting. (2017). Batman province 2017 environmental status report. Governorship of Batman.
15. Genç, D. (2008). Soil mechanics and foundations. UCTEA Chamber of Geological Engineers Publications.
16. Imamoğlu, M. Ş., & Çetin, E. (2007). Seismicity of Southeast Anatolia region and its vicinity. Dicle University Ziya Gökalp Faculty of Education Journal, (9), 93–103.
17. Karabaş, B. (2019). Use of Geographic Information System for evaluating some geotechnical properties in Malatya, Turkey [Master's thesis]. Hasan Kalyoncu University, Graduate Education Institute.
18. Karabaş, B., Akbulut, N., & Demirtaş, O. (2026). GIS-Based IDW Mapping of Soil Index Properties: A Case Study of Elazığ Center. Dicle Üniversitesi Mühendislik Fakültesi Mühendislik Dergisi, 17(1). https://doi.org/10.24012/dumf.1850431
19. KGM. (2023). Intercity distance query. General Directorate of Highways. https://www.kgm.gov.tr/Sayfalar/KGM/SiteTr/Uzakliklar/illerArasiMesafe.aspx
20. Küpçü, S., Çabuk, A., & Uyguçgil, H. (2015). Geographic information systems (No. 2057; 1st ed.). Anadolu University Faculty of Open Education.
21. Law on the Establishment of Two Provinces and Five Districts and Amending the Annexed Schedules of the Decree-Law No. 190, Law No. 3647 (1990). https://www.mevzuat.gov.tr/mevzuatmetin/1.5.3647.pdf
22. Mayne, P. W., Christopher, B. R., & DeJong, J. (2002). Subsurface investigations—Geotechnical site characterization: Reference manual. Federal Highway Administration (FHWA).
23. Orhan, M. (2022). Geotechnical engineering and foundation construction (Vol. 1). Gazi Publishing.
24. Rockwell, T., Barka, A., Dawson, T., Akyuz, S., & Thorup, K. (2001). Paleoseismology of the Gazikoy-Saros segment of the North Anatolia fault, northwestern Turkey: Comparison of the historical and paleoseismic records, implications of regional seismic hazard, and models of earthquake recurrence. Journal of Seismology, 5, 433–448.
25. Şengör, A. M. C. (1980). Fundamentals of the neotectonics of Turkey. Geological Society of Turkey.
26. Şengül, T., & Karabaş, B. (2021). Kütahya Merkez ilçesinde sıvılaşma potansiyelinin Coğrafi Bilgi Sistemi ile incelenmesi. Bilecik Şeyh Edebali Üniversitesi Fen Bilimleri Dergisi, 8(2), 817-825. https://doi.org/10.35193/bseufbd.962190
27. Tonbul, S., & Sunkar, M. (2008, October). Evaluation of site selection in Batman city in terms of geomorphological features and natural risks [Paper presentation]. National Geomorphology Symposium, Çanakkale, Turkey.
28. Uzuner, B. A. (2016). Basic soil mechanics with solved problems (10th ed.). Teknik Publishing.
29. Yıldız, O. (2022). Seismic site characterization of Battalgazi in Malatya, Turkey. Arabian Journal of Geosciences, 15(9), 867. https://doi.org/10.1007/s12517-022-10170-x
30. Yıldız, Ö. (2024). Integrated GIS-based mapping and ANFIS modelling for seismic and geotechnical characterization of soil properties. KSCE Journal of Civil Engineering, 28(9), 3708–3721.
31. Youd, T. L. (1984). Geologic effects-liquefaction and associated ground failure. Proceedings of the Geologic and Hydraulic Hazards Training Program, 210–232.