PERFORMANCE AND EMISSION CHARACTERISTICS OF A DIESEL ENGINE FUELLED WITH EMULSIFIED BIODIESEL-DIESEL FUEL BLENDS

Öz

In this study, effects of emulsified fuels on the performance and emissions of a diesel engine were investigated experimentally. Effective power, specific fuel consumption and thermal efficiency as well as emissions of carbon monoxide, hydrocarbon, nitrogen oxide and carbon were considered as parameters for the investigation. Two emulsified fuels, namely B20W10 and B20W15, containing 10 and 15% water by volume, respectively, were prepared by using diesel fuel-biodiesel blend (B20). The emulsified fuels were tested in a naturally aspirated, direct injection diesel engine at partial load conditions. The test results obtained from the emulsified fuels were compared with those of neat diesel fuel and B20. It was found that the emulsified fuels yield higher specific fuel consumptions, while they cause only slight changes in thermal efficiency. The emulsified fuels are very capable of reducing NOx emission at all engine loads. On the other hand, the use of emulsified fuels brings about significant increase in CO and HC emissions at low engine loads, while they cause moderate CO and HC emissions at high engine loads.

Anahtar Kelimeler

• Emulsified fuel,biodiesel; diesel engine; engine performance; exhaust emissions

Kaynakça

1. Demirbas A. Importance of biodiesel as transportation fuel. Energy Policy, 2007, 35:4661–4670.
2. Hasimoglu C. Performance and emission investigation of a biodiesel fueled low heat rejection diesel engine, Energy Education Science and Technology Part A: Energy Science and Research, 2012, 28 (2):1033-1034.
3. Fazal M.A., Haseeb A.S.M.A., Masjuki H.H. Biodiesel feasibility study: an evaluation of material compatibility; performance, emission and engine durability. Renewable and Sustainable Energy Reviews, 2011, 15:1314−1324.
4. Ozsezen A.N., Canakci M., Turkcan A., Sayin C. Performance and combustion characteristics of a DI diesel engine fueled with waste palm oil and canola oil methyl esters. Fuel, 2009, 88:629−636.
5. Gumus M. A comprehensive experimental investigation of combustion and heat release characteristics of a biodiesel (hazelnut kernel oil methyls ester) fueled direct injection compression ignition engine. Fuel, 2010, 89:2802−2814.
6. Keskin A., Guru M., Altiparmak D., Aydin K. Using of cotton oil soapstock biodiesel-diesel fuel blends as an alternative fuels. Renewable Energy, 2008, 33:553−557.
7. Karabektas M., Ergen G., Hosoz M. Effects of the blends containing low ratios of alternative fuels on the performance and emission characteristics of a diesel engine. Fuel (In press).
8. Xue J., Grift T.E., Hansen A.C. Effects of biodiesel on engine performances and emissions. Renewable and Sustainable Energy Reviews, 2011, 15:1098−1116.

9. Wu F., Wang J., Chen W., Shuau, S. A study on emission performance of a diesel engine fueled with five typical methyl ester biodiesels. Atmospheric Environment, 2009, 43:1481−1485
10. Godiganur S., Murthy C.H.S., Reddy R.P. 6BTA 5.9 G2-1 Cummins engine performance and emission tests using methyl ester mahua (madhuca indica) oil/diesel blends. Renewable Energy, 2009, 34:2172−2177.
11. Zhu L., Zhang W., Liu W., Huang Z. Experimental study on particulate and NOx emissions of a diesel engine fueled with ultra low sulphur diesel, RME-diesel blends and PME-diesel blends. Science of the Total Environment, 2010, 408:1050−1058.
12. Basha S.A., Gopal K.R., Jebaraj S. A review on biodiesel production, combustion, emissions and performance. Renewable and Sustainable Energy Reviews, 2009, 13:1628−1634.
13. Lin C.Y., Lin S.A. Effects of emulsification variables on fuel properties of two-and three-phase biodiesel emulsions. Fuel, 2007, 86:210−217.
14. Lin C.Y., Wang K.H. Diesel engine performance and emission characteristics using three-phase emulsions as fuel. Fuel, 2004, 83:537−545.
15. Ghojel J., Honnery D., Al-Khaleefi K. Performance, emissions and heat release characteristics of direct injection diesel engine operating on diesel oil emulsions. Applied Thermal Engineering, 2006, 26:2132−2141.
16. Husnawan M., Masjuki H.H., Mahlia T.M.I., Saifullah M.G. Thermal analysis of cylinder head carbon deposits from single cylinder diesel engine fueled by palm oil-diesel fuel emulsions. Applied Energy, 2009, 86:2107−2113.
17. Nadeem M., Rangkuti C., Anuar K., Haq M.R.U., Tan I.B., Shah S.S. Diesel engine performance and emission evaluation using emulsified fuels stabilized by conventional and gemini surfactants. Fuel, 2006, 85:2111−2119.
18. Subramanian K.A. A comparison of water-diesel emulsion and timed injection of water into the intake manifold of a diesel engine for simultaneous control NO and smoke emissions. Energy Conversion and Management, 2011, 52:849−857.
19. Lin C.Y., Chen L.W. Engine performance and emission characteristics of three-phase diesel emulsions prepared by an ultrasonic emulsification method. Fuel, 2006, 85:593−600.
20. Qi D.H., Chen H., Matthews R.D., Bian Y.Z.H. Combustion and emissions characteristics of ethanol-biodiesel-water micro-emulsions used in a direct injection compression ignition engine. Fuel, 2010, 89:958−964.
21. Kannan G.R, Anand R. Experimental investigation on diesel engine with diestrol-water micro emulsions. Energy, 2011, 36:1680−1687.
22. Bueno A.V., Velasquez J.A., Milanez L.F. Heat release and engine performance effects of soybean oil ethyl ester blending into diesel fuel. Energy, 2011, 36:3907−3916.
23. Raheman H., Phadatare A.G. Diesel engine emissions and performance from blends of karanja methyl ester and diesel. Biomass and Bioenergy, 2004, 27:393−397.
24. Karabektas M., Ergen G., Hosoz M. The effects of preheated cottonseed oil methyl ester on the performance and exhaust emissions of a diesel engine. Applied Thermal Engineering, 2008, 28:2136−2143.
25. Ng J.H., Ng H.K., Gan S. Engine-out characterization using speed-load mapping and reduced test cycle for a light-duty diesel engine fuelled with biodiesel blends. Fuel, 2011, 90:2700−2709.