Performance Analyses of Combined Cycle Power Plants

Yıl 2023, Cilt: 9 Sayı: 2, 165 - 169, 30.06.2023

Rabi Karaali

https://doi.org/10.22399/ijcesen.1310338

Öz

In this article, different compressor pressure and different excess air rates for a gas turbine based combine cycle power plant with steam Rankine cycle as bottoming cycle were analyzed by using 1. and 2. laws of thermodynamics and exergy analyses methods to obtain the best performances of the cycle. Exergy efficiency of the cycle, net powers of the gas and steam turbines and the overall cycle, exergy loss of the components, the efficiencies of the components are obtained, compared and discussed. It was found that, increasing the compressor pressure increases exergy efficiency of cycle, gas turbine and total plant power, and the combustion chamber, the HRSG and the compressor efficiencies. However, increasing compression rates decreases steam turbine power, combustion chamber, steam turbine, and HRSG exergy losses and the gas turbine efficiency. Also, it is found that, increases in excess air ratios gives an optimum or a maximum exergy efficiency, at 2.5 excess air rate of the cycle.

Anahtar Kelimeler

Combine cycle, Exergy, Performance

Kaynakça

• [1] Keven A., Karaali R., (2015). Investigation of an Alternative Fuel for Diesel Engines. Acta Physica Polonica A, 128(2B);282 – 286.
• [2] Karaali, R., (2016). Thermodynamic Analysis of a Cascade Refrigeration System. Acta Phys. Pol. A 130(1);101-106. DOI: 10.12693/APhysPolA.130.101
• [3] Karaali, R., (2016). Exergy Analysis of a Combined Power and Cooling Cycle. Acta Phys. Pol. A 130(1);209-213. DOI: 10.12693/APhysPolA.130.209
• [4] Karaali, R. (2010). Thermoeconomic optimization of cogeneration power plants (Doctoral dissertation, PhD Thesis. Kocaeli Univ).
• [5] Karaali R., Öztürk İ.T. (2017). Performance Analyses of Gas Turbine Cogeneration Plants. ISI Bilimi ve Teknigi Dergisi-Journal of Thermal Science and Technology. 37(1);25 – 33.
• [6] Karaali R., Keven A., (2022). Evaluation of Four Different Cogeneration Cycles by Using Some Criteria. Applied Rheology, 32(1);122 – 137.
• [7] Jiangfeng Wang, Yiping Dai, and Lin Gao, (2008). Parametric analysis and optimization for a combined power and refrigeration cycle. Applied Energy. 85;1071–1085
• [8] Christoph Koch, Frank Cziesla and George Tsatsaronis, (2007). Optimization of combined cycle power plants using evolutionary algorithms. Chemical Engineering and Processing 46;1151–1159
• [9] M. A. Javadi, S. Hoseinzadeh, M. Khalaji and R. Ghasemiasl, (2019). Optimization and analysis of exergy, economic, and environmental of a combined cycle power plant. Sadhana 44;121. https://doi.org/10.1007/s12046-019-1102-4
• [10] Keyvan Bahlouli, (2018) Multi-objective optimization of a combined cycle using exergetic and exergoeconomic approaches. Energy Conversion and Management. 171;1761–1772. https://doi.org/10.1016/j.enconman.2018.06.100
• [11] Bejan, A., Tsatsaronis, G,, Moran, M. (1996). Thermal Design and Optimization. Danvers, Massachusetts: Wiley Pub.
• [12] Şanlı, H., Alptekin, E., Çanakç, M., (2022). Using low viscosity micro-emulsification fuels composed of waste frying oil-diesel fuel-higher bio-alcohols in a turbocharged-CRDI diesel engine, Fuel, 308;1-13.
• [13] Alptekin, E., Şanlı, H., Çanakç, M., (2019). Combustion and performance evaluation of a common rail DI diesel engine fueled with ethyl and methyl esters, Applied Thermal Engineering, 149;180-191.
• [14] Şanlı, H., (2018). An experimental investigation on the usage of waste frying oil-diesel fuel blends with low viscosity in a Common Rail DI-diesel engine. Fuel, 222;434-443.