Experimental investigation of diesel engine emissions with producer gas and blends of neat Karanja oil as fuel adding turbocharger

Yıl 2014, Cilt: 4 Sayı: 3, 675 - 682, 01.09.2014

Chandrakant Nayak Saroj Acharya

Öz

This paper highlights the impact of turbocharger and addition of producer gas flow rate on the emissions of  a twin cylinder diesel engine fuelled with diesel and  blends of neat Karanja oil (10% and 20%) with diesel (on weight basis). The test is carried out with and without turbocharged mode in two cases of operations. In case 1, the above fuels are tested at an optimum gas flow rate of 21.49 kg/hr under different engine loading conditions. In case 2, the same fuels are tested at an optimum load of 10 kW under different gas flow rates. During turbo mode operation it is found that mixing of inlet air and producer gas becomes a difficult issue due to their pressure difference and hence a proper arrangement is needed for it. The study reveals that the turbocharged mode operations of all the tested fuels show a significant reduction of hydrocarbon, carbon monoxide and smoke opacity. However, with increase in gas flow rate up to an optimum level, the nitrogen oxide emission and smoke opacity decreases significantly. At an optimum gas flow rate of 21.49 kg/hr, producer gas can be used as a potential fuel for diesel to reduce emissions. 

Anahtar Kelimeler

Energy, Renewable Energy, Biomass Energy

Kaynakça

• Z. Sahin, and O. Durgun, “Numerical investigation of the effects of injection parameters on performance and exhaust emission in a DI diesel engine”, Proceedings of the 4th International Exergy, Energy and Environment system, AUS, Sharjah 19-23 April 2009.
• G.P. Merker, C.Schwarz, G. Stiesch, and F. Otto, “Simulation combustion, simulation of combustion and pollution Germany, Spinger-Verlag Berlin Heiddelberg, 2006. for
• engine-development”, [3] D.C. Rakopoulos, E.G.
• Papagiannakis, and D.C. Kyritsis, “Experimental
• stochastic investigation of the combustion cyclic
• variability in HSDI diesel engine using ethanol-diesel
• blends”, Fuel, Vol. 87, pp.1487-1491, 2008. R.G.
• M. Abu-Qudais, O. Haddad, and M. Qudaisat, “The effect of alcohol fumigation on diesel engine performance and emission”, Energy Conversion Management, Vol. 41, pp. 389-399, 2000.
• Y.D. Wang, T. AL-Shemmeri, P. Eames, J. McMullan, T. Hewitt, and Y. Huang, “An experimental investigation of the performance and gaseous exhaust emission of a diesel engine using blends of a vegetable oil”, Applied Thermal Engineering, Vol. 26, pp. 1684- 1691, 2006.
• O.M.I. Nwafor, “Effect of choice of pilot fuel on the performance of natural gas in diesel engine”, Renewable Energy, Vol. 21, pp.495-504, 2000a.
• O.M.I. Nwafor, “Effect of advanced injection timing on the performance of natural gas in diesel engine”, Sadhana, Vol.25, No. 1, pp.11-20, 2000b.
• A. Henham, and M.K. Makkar, “Combustion of simulated biogas in a dual-fuel diesel engine”, Energy Conversion Management, Vol. 39, pp. 2001-2009, 1998.
• Z. Sahin, O. Durgun, and C. Bayram, “Experimental investigation of gasoline fumigation in a turbocharged IDI diesel engine”, Fuel, Vol. 95, pp. 113-121, 2012.
• M. Kao, J.J. Moskwa, “Turbocharged diesel engine modelling for nonlinear engine control and state estimation”, Journal of Dynamic System Measurement and Control, Vol. 117, No. 20, 1995.
• C.D. Rakopoulos, A.M. Dimaratos, E.G. Giakoumis, and D.C. Rakopoulos, Study of turbocharged diesel engine operation, pollutant emissions and combustion noise radiation during starting with bio-diesel or n- butanol diesel fuel blends”, Applied Energy, Vol. 88, pp. 3905-3916, 2011.
• M.G. Shirk, T.P. McGuire, L. Gary, and H.D. Neal, “Investigation of a hydrogen assisted combustion system for a light-duty diesel vehicles”, International Journal of Hydrogen Energy, Vol. 33, pp. 7237-44, 2008.
• C. Liew, H. Li, S. Liu, M.C. Besch, B. Ralston, N. Clark, and Y. Huang, “Exhaust emissions of a H2- enriched heavy-duty diesel engine equipped with cooled EGR and variable geometry turbocharger”, Fuel, Vol. 91, pp. 155-163, 2012.
• G. Zamboni, and M. Capobianco, “Influence of high and low pressure EGR and VGT control on in-cylinder pressure diagram and rate of heat release in an automotive turbocharged diesel engine”, Applied Thermal Engineering, Vol. 51, pp. 586-596, 2013.
• N.L. Panwar, and B.L. Salvi, “Experimental investigation of producer gas burner for thermal application”, International journal of Sustainable Energy, Vol. 30, No. 6, pp.376-384, 2011.
• N.R. Banapurmath, P. G. Tewari, and R. S. Hosmath, “Performance Compression ignition engine operated on Honge, Jatropha and sesame oil methyl esters”, Renewable Energy, Vol. 33, pp.1982-1988, 2008. of
• N.R. Banapurmath, P.G. Tewari, V.S. Yaliwal, S. Kambalimath, and Y.H. Basavarajappa, “Combustion characteristics of a 4-strokeci engine operated on Honge oil, Neem oil and Rice Bran oils when directly injected and dual fuelled with producer gas induction”, Renewable energy, Vol. 34, pp. 1877-1884, 2009.
• A. Srivastava, and R. Prasad, “Triglycerides-based diesel fuels”, Renewable Sustainable Energy Reviews, Vol. 4, pp.111-133, 2000.
• A.K. Agarwal, and K. Rajamanoharan, “Experimental investigation of the performance and emission of Karanja oil and its blends in a single cylinder agriculture diesel engine”, Applied Energy, Vol. 86, pp.106-112, 2009.
• C. Nayak, S.K. Acharya, and R.K. Swain, “Performance of twin cylinder dual-fuel diesel engine using blends of neat Karanja oil and producer gas”, International journal of Ambient Energy, (2014), http:// dx.doi.org/ 10.1080/01430750.2013.874370.