Substrate to Nozzle Distance Influence on the Properties of Zinc Oxide Films Formed with Chemical Spray Pyrolysis Technique

Yıl 2019, Cilt: 4 Sayı: 1, 1 - 10, 15.04.2019

Halo Dalshad Omar

https://doi.org/10.30931/jetas.504837

Öz

In this work, the zinc oxide (ZnO) thin films have been deposited on the substrate glass via chemical spray pyrolysis technique that influence of the distance between nozzle and substrate on the optical, morphology, chemical composition and structural properties of two samples. Thicknesses of two samples were obtained around 300 (nm) via weighing method at a stable substrate temperature of 370 °C. Crystal structure was investigated by manner of an X-Ray Diffraction (XRD); it was found that two films have three peaks located at 2θ ≈ 32.698 ̊, 34.185 ̊ and 36.185 ̊ with hkl (100), (002) and (101), respectively. XRD pattern appeared the present of hexagonal crystal structure with (002) arrangement and polycrystalline for two samples. Optical properties of ZnO thin films were contained study of transmittance spectrum in the extent of the wave length λ (200-1100) nm with using ultraviolet-visible spectrophotometer that varies between 89-92 %. The results of optical band gap was varied between 2.97 and 3.02 (eV) along with variable distance between substrate and nozzle 20 and 30 (cm) respectively. The morphology of surface zinc oxide was investigated by scanning tunneling microscopic (STM) and root mean square (rms) of the surface films was measured via STM. XRF spectral measurement confirms and indicates that elements present in the thin films.

Anahtar Kelimeler

Spray pyrolysis, ZnO thin films, morphology

Kaynakça

• [1] Hafdallah, A., Azzedine, A., Belhani, H., Aida, M.S., Attaf, N., “Effect of the Nozzle- Substrate Distance on the Structural and Optical Properties of ZnO Thin Films Deposited by Spray Pyrolysis Technique”, American Journal of Nano Research and Applications 5(6) (2017) : 87.
• [2] Babar, A.R., Shinde, S.S., Moholkar, A.V., Bhosale, C.H., Rajpure, K.Y., “Structural and optoelectronic properties of sprayed Sb: SnO2 thin films: Effects of substrate temperature and nozzle-to-substrate distance”, Journal of Semiconductors 32(10) (2011) : 102001.
• [3] Al-khayatt, A.H.O., Jaafer, M.D., “Characteristics of Nanocrystalline ZnS thin films grown on glass with different Zn ion concentrations by CBD technique”, Journal of Applied Physics 6(1) (2014) : 27-35.
• [4] Meshram, R.S., Suryavanshi, B.M., Thombre, R.M., Chandrapur, D., Gadchiroli, D., “Structural and optical properties of CdS thin films obtained by spray pyrolysis”, Adv. Appl. Sci. Res 3 (2012) : 1563-1571.
• [5] Faraj, M.G., Chaqmaqchee, F.A.I., Omar, H.D., “Structural, morphological and electrical properties of Zn doped PbS thin films by chemical spray pyrolysis”, Journal of Optoelectronics and Advanced Materials 19(5-6) (2017) : 412-416.
• [6] Gumus, C., Ozkendir, O.M., Kavak, H., Ufuktepe, Y., “Structural and optical properties of zinc oxide thin films prepared by spray pyrolysis method”, Journal of optoelectronics and advanced materials 8(1) (2006) : 299.
• [7] Jamil, S.S.B., “The optical and structural properties of ZnO films prepared by spray pyrolysis”, Engineering and Technology Journal 28(20) (2010) : 6061-6073.
• [8] Ahmed, G.S., “Study The Effect of Thickness on Zno Thin Films prepared by Spray Pyrolysis Method”, Journal of university of Anbar for Pure science 7(2) (2013).
• [9] Bakr, N.A., Salman, S.A., Hameed, S.A., “Deposition and Characterization of Cu2ZnSnS4 Thin Films for Solar Cell Applications”, International Journal of Applied Engineering Research 13(6) (2018) : 3379-3388.
• [10] Turgut, G., Tatar, D., Düzgün, B., “Effect Of Nozzle-Substrate Distance On Electrical, Structural And Optical Properties Of Sno2 Thin Films Prepared By Spray Pyrolysis”, Erzincan Üniversitesi Fen Bilimleri Enstitüsü Dergisi 5(1) (2012) : 13-24.
• [11] Omar, H.D., “To Investigation the Structure and Morphology of Iron Metallic by Difference Techniques”, J. Nano. Adv. Mat 3(2) (2015) : 57-61.
• [12] Singh, P., Kumar, A., Kaur, D., “Growth and characterization of ZnO nanocrystalline thin films and nanopowder via low-cost ultrasonic spray pyrolysis”, Journal of Crystal Growth 306(2) (2007) : 303-310.
• [13] Suhail, A.M., Saeed, N.M., “Preparation and properties of Nanostructure Zinc Oxide Thin Films”, Iraqi Journal of Physics 7(8) (2009) : 75-81.
• [14] Hani, M.Y., Al-Aarajiy, A.H., Abdul-Lettif, A.M., “Effect of nozzle to substrate distance on the structural and absorption properties of nickel (II) tetrasulfonated phthalocyanine thin films”, Materials Research Express 5(1) (2018) : 016406.
• [15] Koçyiğit, A., Tatar, D., Battal, A., Aydın, S., Turgut, G., Düzgün, B., “Investigation of some properties of SnO2: Sb: F thin films by an economic spray pyrolysis technique”. 2013.
• [16] Guneri, E., Gumus, C., KIRMIZIGUL, F., “Studies on properties of sprayed SnO2 thin films as a function of substrate-nozzle distance and substrate temperature”, Optoelectronics and Advanced Materials–Rapid Communications (2009) : 383-389.
• [17] Omar, H.D., “Intensity Correction and Pole Figure Measurement of Copper Metallic by XRD”, Journal of Basic and Applied Sciences 12 (2016) : 320-322.
• [18] Immanuel, P., Prakash, A.A., Mohan, C.R., “Ethanol sensing of V2O5 thin film prepared by spray pyrolysis technique: Effect of substrate to nozzle distance”, In AIP Conference Proceedings: AIP Publishing 1832(1) (2017) : 080022.
• [19] Rajalakshmi, P.U., Oommen, R.A.C.H.E.L., Sanjeeviraja, C., “Effect of substrate temperature on the structural, optical and electrical properties of nebulised spray pyrolysed Bi2S3 thin films”, Chalcogenide Lett 8(10) (2011) : 649-657.
• [20] Awodugba, A.O., Yusuf, G.T., “Substrate-Nozzle Distance (SND) Influence on the Properties of Fluorine-Doped Tin Oxide Thin Films”. 2017.
• [21] Chiu, F.C., “Conduction mechanisms in resistance switching memory devices using transparent boron doped zinc oxide films”, Materials 7(11) (2014) : 7339-7348.
• [22] Hasan, N.B., Mohammed, M.A., “Constructing Spray Pyrolysis System For The Preparation of Thin Films and Study The Optical Properties of PbO Films”, International Letters of Chemistry, Physics and Astronomy 53 (2015) : 146-153.
• [23] Ali, A.I.A., “Molarities effect on structural and optical properties of ZnO prepared by spray pyrolysis”, International Journal of Scientific & Engineering Research 5(1) (2014) : 2250.
• [24] Saleh, A.F., Jaffar, A.M., Samoom, N.A., Mahmmod M.W., “Effect Adding PVA Polymer on Structural and Optical Properties of TiO2 Thin Films”, Al-Nahrain Journal of Science 17(2) (2014) : 161-121.