Experimental Examination of Performance, Exhaust Emission and Combustion Behaviours of A Ci Engine Fuelled With Biodiesel/Diesel Fuel Blends

Yıl 2018, , 1274 - 1281, 01.10.2018

Alaattin Osman Emiroğlu

https://doi.org/10.16984/saufenbilder.395134

Cited By: 3

Öz

The main objective of this
study is to evaluate the effect on diesel engine performance, exhaust emission
and combustion characteristics of canola oil biodiesel. The biodiesel was
blended with petroleum-based diesel fuel (DF) by 10% (B10), 20% (B20) and 50%
(B50) volumetrically. Engine tests were carried out on a direct injection,
single-cylinder, compression ignition engine at different engine loads and the
results were compared with the reference DF. The results showed that the
maximum cylinder pressure and heat release rate values of DF were higher than
those of the biodiesel blends at all engine loads. The addition of biodiesel to
DF increased the brake specific fuel consumption (BSFC) and decreased the brake
thermal efficiency (BTE) at all engine loads. In addition, biodiesel blends
caused a slight increase in nitrogen oxide (NO_x) emissions while
causing a decrease in smoke opacity and carbon monoxide (CO) emissions.

Anahtar Kelimeler

Biodiesel, canola oil, diesel engine, combustion

Kaynakça

• Referans1 E. Alptekin, M. Canakci, “Determination of the density and the viscosities of biodiesel–diesel fuel blends,” Renewable Energy, vol. 33, pp. 2623–2630, 2008.
• Referans2 J. Hwang, D. Qi, Y. Jung and C. Bae, “Effect of injection parameters on the combustion and emission characteristics in a common-rail direct injection diesel engine fueled with waste cooking oil biodiesel,” Renewable Energy, vol. 63, pp. 9-17, 2014.
• Referans3 A. Keskin, “Experimental investigation of the effect of cottonseed oil biodiesel eurodiesel mixtures on combustion, performance and emissions at full load,” Afyon Kocatepe University Journal of Science and Engineering, vol. 17, pp. 797-809, 2017.
• Referans4 A. O. Emiroğlu, A. Keskin, and M. Şen, “Experimental investigation of the effects of turkey rendering fat biodiesel on combustion, performance and exhaust emissions of a diesel engine,” Fuel, vol. 216, pp. 266-273, 2018.
• Referans5 Ö. Can, E. Öztürk and H. S. Yücesu, “Combustion and exhaust emissions of canola biodiesel blends in a single cylinder DI diesel engine,” Renewable Energy, vol. 109, pp. 73-82, 2017.
• Referans6 G. Labeckas and S. Slavinskas, “The effect of rapeseed oil methyl ester on direct injection diesel engine performance and exhaust emissions,” Energy conversion and Management, vol. 47, no. 13-14, pp. 1954-1967, 2006.
• Referans7 O. M. Ali, R. Mamat, N. R. Abdullah and A. A. Abdullah, “Analysis of blended fuel properties and engine performance with palm biodiesel–diesel blended fuel,” Renewable Energy, vol. 86, pp. 59-67, 2016.
• Referans8 O. Özener, L. Yüksek, A. T. Ergenç and M. Özkan, “Effects of soybean biodiesel on a DI diesel engine performance, emission and combustion characteristics,” Fuel, vol. 115, pp. 875-883, 2014.
• Referans9 M. S. Shehata, A. M. Attia and S. A. Razek, “Corn and soybean biodiesel blends as alternative fuels for diesel engine at different injection pressures,” Fuel, vol. 161, pp. 49-58, 2015.
• Referans10 E. Öztürk, “Performance, emissions, combustion and injection characteristics of a diesel engine fuelled with canola oil–hazelnut soapstock biodiesel mixture,” Fuel Processing Technology, vol. 129, pp. 183-191, 2015.
• Referans11 C. D. Rakopoulos, D. C. Rakopoulos, D. T. Hountalas, E. G. Giakoumis and E. C. Andritsakis, “Performance and emissions of bus engine using blends of diesel fuel with bio-diesel of sunflower or cottonseed oils derived from Greek feedstock,” Fuel, vol. 87, no. 2, pp. 147-157, 2008.
• Referans12 A. N. Ozsezen, M. Canakci, A. Turkcan and C. Sayin, “Performance and combustion characteristics of a DI diesel engine fueled with waste palm oil and canola oil methyl esters,” Fuel, vol. 88, no. 4, pp. 629-636, 2009.
• Referans13 I. Celikten, A. Koca and M. A. Arslan, “Comparison of performance and emissions of diesel fuel, rapeseed and soybean oil methyl esters injected at different pressures,” Renewable Energy, vol. 35, no. 4, pp. 814-820, 2010.
• Referans14 S. Sivalakshmi, T. Balusamy, “Effects of dimethyl carbonate-biodiesel blends on the combustion, performance and exhaust emissions of a DI diesel engine,” SAE International, 2012.
• Referans15 L. Zhu, C. S. Cheung, W. G. Zhang, Z. Huang, “Combustion, performance and emission characteristics of a DI diesel engine fueled with ethanol-biodiesel blends,” Fuel, vol. 90, pp. 1743-1750, 2011.
• Referans16 C. Sayin and M. Canakci, “Effects of injection timing on the engine performance and exhaust emissions of a dual-fuel diesel engine,” Energy conversion and management, vol. 50, no. 1, pp. 203-213, 2009.
• Referans17 A. O. Emiroğlu and M. Şen, “Combustion, performance and exhaust emission characterizations of a diesel engine operating with a ternary blend (alcohol-biodiesel-diesel fuel),” Applied Thermal Engineering, 2018.
• Referans18 L. G. Schumacher, S. C. Borgelt, D. Fosseen, W. Goetz and W. G. Hires, “Heavy-duty engine exhaust emission tests using methyl ester soybean oil/diesel fuel blends,” Bioresource Technology, vol. 57, no. 1, pp. 31-36, 1996.
• Referans19 A. O. Emiroğlu and M. Şen, “Combustion, performance and emission characteristics of various alcohol blends in a single cylinder diesel engine,” Fuel, vol. 212, pp. 34-40, 2018.
• Referans20 D. H. Qi, L. M. Geng, H. Chen, Y. Z. Bian, J. Liu and X. C. Ren, “Combustion and performance evaluation of a diesel engine fueled with biodiesel produced from soybean crude oil,” Renewable Energy, vol. 34, no. 12, pp. 2706-2713, 2009.