Investigation of the design parameters affecting the safety factor in fittings by using Taguchi method
Öz
Introduction.
In Turkey, it
has been observed that unqualified Chinese fittings are used in water and
natural gas connections. Domestic production industry of cast iron did not
remain competitive. It is thought that due to the production of aluminum pipe
fasteners and corrosion resistance, production easiness and low cost, it can be
preferred. Material and methods.For
the design of aluminum tee pipe fittings, the authors have proposed a new
design. This design incorporates angled inner surface and bracelet design with
some standard measurements. In this study, the parameters forming the new type
design are determined. Design parameters and their levels are specified.
Pressure endurance analysis was performed by using the finite element method.
The Taguchi method was used to reduce the number of experiments and to
investigate of optimum conditions of the effects of the parameters on the
pressure balance. Results.
The results of
compressive strength analysis were listed by using the ANSYS program.
Variations in weight, elastic deflection amount, vertical and horizontal axis
maximum stress amounts were analyzed by Taguchi method andvariance analysis.
The percent effect ratios of the design parameters were investigated. Conclusions. With this work, it is
desired to optimize in design and production. Minimum weight and maximum safety
coefficient are desired. Although the weight is not much, the parameter values
that increase the strength were determined.
Anahtar Kelimeler
Kaynakça
- Özkan Küçük1, Burak Öztürk2, Samed Varhan3 1Kastamonu University, Faculty of Engineering and Architecture, Department of Materials Science and Nanotechnology Engineering, Kastamonu 2Kastamonu University, Institute of Science, Materials Science and Engineering, Kastamonu 3Yıldırım Beyazıt Üniversitesi, Faculty of Architecture and Engineering, Mechanical Engineering
Öz
Kaynakça
- Özkan Küçük1, Burak Öztürk2, Samed Varhan3 1Kastamonu University, Faculty of Engineering and Architecture, Department of Materials Science and Nanotechnology Engineering, Kastamonu 2Kastamonu University, Institute of Science, Materials Science and Engineering, Kastamonu 3Yıldırım Beyazıt Üniversitesi, Faculty of Architecture and Engineering, Mechanical Engineering
Ayrıntılar
| Bölüm | Articles |
|---|---|
| Yazarlar | |
| Yayımlanma Tarihi | 1 Haziran 2017 |
| Yayımlandığı Sayı | Yıl 2017 Cilt: 2 Sayı: 1(3) - Volume 2, Issue 1(3) |
