Deprem Giriş Enerjisi İle Spektral Hız Arasındaki İlişkinin İrdelenmesi

Abstract

Deprem etkisine göre tasarım için önerilen enerji esaslı analiz yöntemleri sahip oldukları üstünlükler nedeniyle gün geçtikçe daha fazla ilgi görmektedir. Analizde depremin süresi ve frekans içeriğinin dikkate alınabiliyor olması bu tür yöntemlerin en önemli üstünlükleridir. Enerji esaslı analiz yöntemlerinin başarılı sonuç üretebilmesi için yapı sistemine giren deprem enerjisinin “doğru” tahmini önem taşımaktadır. Enerji denge denkleminin çözümüyle giren deprem enerjini elde etmek zahmetli bir işlem olduğundan, bu büyüklük literatürde genellikle eşdeğer spektral hız cinsinden ifade edilmektedir. Bu ilişkinin sadece sönümsüz sistemler için geçerli olacağı literatürde tartışılmaktadır. Bu bağlamda, yapısal sönümün yapıya aktarılan deprem enerjisi ile eşdeğer hız arasındaki ilişkiye olan etkisi bu çalışmada kanıtlanmıştır. Çok sayıda deprem kaydı ve farklı sönüm özellikleri için zaman tanım alanında analizler gerçekleştirilmiştir. Deprem kayıtlarının seçiminde kayma dalgası hızı (V_s30) ve kayıt türü (sıradan ve darbe etkili) değişkenleri dikkate alınmıştır. Gerçekleştirilen analizler sonucunda, yapıya aktarılan deprem enerjisi ile eşdeğer spektral hız arasındaki ilişkinin farklı sönüm özellikleri için aynı olmadığı görülmüştür. Mevcut ilişki için yeni katsayılar önerilmiştir.

Keywords

• Giren enerji,spektral hız,enerji denge deklemi,enerji esaslı sismik tasarım

Evaluation of the Relation between Seismic Input Energy and Spectral Velocity

Abstract

Energy based seismic design concept is getting attention owing to its advantages over the conventional methodologies. Particularly, the consideration of duration and frequency content of the earthquake record are chief superiority of the concept. For this original design procedure, accurate determination of seismic input energy is crucially important. Because of solving energy balance equation is a tedious job, the seismic input energy is determined in terms of equivalent velocity in the literature mostly. However, it was also shown that this relation is valid for only undamped systems. Therefore, this study aims to provide the nonsteady relation between seismic input energy and equivalent velocity for damped systems. Intensive response history analyses were performed by using plenty of earthquake records those were selected by considering the impulsive characteristics (ordinary and pulse-like) and shear wave velocity. It was found that the relation given in the literature for seismic input energy and spectral velocity relation is not true for damped systems. Dependently, it is proposed a set of coefficients considering structural damping properties to modify the existing relation.

Keywords

• Input energy,Spectral velocity,Energy balance equation,energy based seismic design

References

1. [1] Structural Engineers Association of California (SEAOC) VISION 200 Committee. 1995. Performance Based Seismic Design of Buildings; vol 1.
2. [2] Chou, C.C, Uang, C.M. 2000. Establishing Absorbed Energy Spectra – An Attenuation Aprroach. Earthquake Engineering and Structural Dynamics, Cilt. 29, No. 10, s. 1441-1455.
3. [3] Güllü, A., Yüksel, E., Yalçın, C., Dindar, A.A., Özkaynak, O., Büyüköztürk, O. 2019. An Improved Input Energy Spectrum Verified by The Shake Table Tests Earthquake Engineering and Structural Dynamics, Cilt. 48, s. 27-45. DOI: 10.1002/eqe.3121.
4. [4] Housner, G.W. 1956. Limit Design of The Structures to Resist Earthquakes. 1st World Conference on Earthquake Engineering, Berkeley: California.
5. [5] Akiyama, H. 1985. Earthquake Resistant Limit State Design for Buildings. University of Tokyo Press.
6. [6] Uang, C.M, Bertero, V.V. 1990. Evaluation of Seismic Energy in Structures. Earthquake Engineering and Structural Dynamics. Cilt. 19, No. 1, s. 77-90.
7. [7] Kuwamura, H., Halambos, T.V. 1989. Earthquake Load for Structural Reliability. Journal of Structural Engineering. Cilt. 115, No. 6, s. 1446-1462.
8. [8] Chai, Y.H., Fajfar, P., Romstad, K.M. 1998. Formulation of Duration-Dependent Inelastic Seismic Design Spectrum. Journal of Structural Engineering. Cilt. 124, No. 8, s. 913-934.

9. [9] Chapman, C.M. 1999. On the Use of Elastic Input Energy For Seismic Hazard Analyses. Earthquake Spectra. Cilt. 15, No.1, s. 607-635.
10. [10] Cheng, Y., Lucchini, A., Mollaioli, F. 2014. Proposal of New Ground Motion Prediction Equations for Elastic Input Energy Spectra. Earthquakes and Structures. Cilt. 7, No. 4, s. 485-510.
11. [11] Alıcı, F.S., Sucuoğlu, H. 2016. Prediction of Input Energy Spectrum: Attenuation Models and Velocity Spectrum Scaling. Earthquake Engineering and Structural Dynamics. Cilt. 45, No. 13, s. 2137-2161.
12. [12] Merter, O., Bozdağ, Ö., Düzgün, M. 2012. Energy-Based Design of Steel Structures According to the Predefined Interstory Drift Ratio. Teknik Dergi. Cilt. 23, No. 1, s. 5777-5798.
13. [13] Merter, O., Uçar, T. 2017. Energy-Based Design Base Shear for RC Frames Considering Global Failure Mechanism and Reduced Hysteretic Behavior. Structural Engineering and Mechanics. Cilt. 63, No. 1, s. 23-35.
14. [14] Güllü, A., Yüksel, E., Yalçın, C., Dindar, A.A., Özkaynak, H. 2017. Experimental Verification of the Elastic Input Energy Spectrum and a Suggestion. International Conference on Interdiciplinary Perspectives for Future Building Envelopes. Istanbul: Turkey.
15. [15] Cheng, Y., Lucchini, A., Mollaioli, F. 2019. Ground-Motion Prediction Equations for Constant-Strength and Constant-Ductility Input Energy Spectra. Bulletin of Earthquake Engineering. https://doi.org/10.1007/s10518-019-00725 -x
16. [16] PEER Ground Motio Database, NGA‐West2. http://ngawest2.berkeley.edu/.
17. [17] Güllü, A. Determination of the Inelastic Displacement Demand and Response Control of Steel Structures by Seismic Energy Equations. Istanbul Technical University, Institute for Science and Technology, PhD Dissertation, 178s, İstanbul.
18. [18] Güllü A, Yüksel E. 2019. Piece-wise Exact Computation of Seismic Energy Balance Equation. International Conference on Civil, Structural & Environmental Engineering Computing. September 16-19, Riva del Garda, Italy.
19. [19] Arias, A. 1985. A Major of Earthquake Intensity. Hansen, R., J., ed. 1985. MIT Press Cambridge.
20. [20] Trifunac, M.D., Brandy, A.G. 1975. A Study on the Duration of Strong Ground Motion. Bulletin of the Seismological Society of America. Cilt. 65, No. 3, s. 585-626.
21. [21] Lopez-Almansa, F., Yazgan, A.U., Benavent-Climent, A. 2013. Desing Input Energy Spectra for High Seismicity Regions Based on Turkish Registers. Bulletin of Earthquake Engineering. Cilt. 11, s. 885-912.
22. [22] Alıcı, S.F., Sucuoğlu, H. 2018. Elastic and Inelastic Near-Fault Input Energy Spectra. Earthquake Spectra. Cilt. 24, No. 2, s. 611-637.
23. [23] Sütçü, F., Inoue, N., Hori, N. 2006. Damper Design of a Structure with a Displacement Controlled Soft-Story. Journal of Structural Engineering (Architectural Institute of Japan). Cilt. 52B, s. 255-260.
24. [24] Benavent-Climent, A., Zahran, R. 2010. An Energy Based Procedure for the Assessment of Seismic Capacity of Existing Frames: Application to RC Wide Beam System in Spain. Soil Dynamics and Earthquake Engineering. Cilt. 30, s. 354-367.
25. [25] Bruneau, W., Wang, N. 1996. Some Aspects of Energy Methods for the Inelastic Seismic Response of Ductile SDOF Structures. Engineering Structures. Cilt. 18, No. 1, s. 1-12.
26. [26] Ye, L., Cheng, G., Qu, Z. 2009. Study on Energy-Based Seismic Design Method and the Application for Steel Braced Frame Structures. International Conference on Urban Earthquake Engineering. Tokyo, Japan.
27. [27] Zhou, Y., Song, G., Huang, S., Wu, H. 2019. Input Energy Spectra for Self-Centering SDOF Systems. Soil Dynamics and Earthquake Engineering. Cilt. 121, s. 293-305.
28. [28] Zhou, Y., Song, G., Tan, p. Hysteretic Energy Demand for Self-Centering SDOF Systems. Soil Dynamics and Earthquake Engineering. Cilt. 125, s. 105703.