Overview

1- The uploaded article should not have been sent to another journal and should not be published. Likewise, the scientific studies sent to the journal should not be in the evaluation stage for publication elsewhere as a published / oral / poster / presentation.
2- While the article is being uploaded to the system, the corresponding author must upload the "Copyright Agreement Part B" with the names and signatures of the other authors, if any, to the DERGİPARK system.
3- Pre-Loading Format; None of the author's names and addresses that contributed to the study should be written in the Part B of the Journal of Science. Thus, the referees will not be able to see which author (s) the study belongs to. (Double Blind Review Process)
4- After at least two referees' opinions are received and the relevant section editor accepts, the uploaded article is accepted.
5- Detailed information about the evaluation and acceptance process of the article can be found at https://dergipark.org.tr/tr/pub/gujsb.
6- The originality and similarity rates of the study are screened by the Turnitin program and only the articles with originality rates below 20% are evaluated.
7- The total text of the article should be between 10-15 pages.
8- Abstract text should not exceed 250 words.

Article Preparation

Abstract
Research articles and reviews should be started with a summary that highlights new information and briefly describes the content of the article. Abbreviations and jargon must not be used. The abstracts should be suitable for abstract format without rewriting. Abstract for a maximum of 250 words should be placed after the address of the author and one blank line. After one blank line from the abstract, key words should be written.

Keywords
Key words reflecting the major features of the work should be inserted. Key words should be written as italic and occured at least three words but no more than five words.

The Text
This is the numbered part of the manuscript which may include the parts: 1. Introduction, 2. Experimental/Theoretical Framework 3. Results and Discussion, 4. References. The text may include sub headings with the following numbering style (2.1, 2.2,…etc.). The minimum and maximum number of pages should be 2 and 15 respectively. If necessary the advisory board may increase the maximum.

Introduction
Every paper must have a concise introduction explaining the state of the topic, and stating clearly what is new in the paper submitted.

Experimental
The experimental methods and the materials used should be described after the introductory paragraphs. Detailed technical descriptions should be restricted to one section of the paper, and not scattered throughout the text. Sufficient information should be given to allow any reasonably experienced worker to carry out the procedure. Detailed descriptions of well-known techniques and equipment are unnecessary, as are simple preparations of reagents or solutions, and lists of common materials. In writing, complete sentences should be used.

Results and Discussion
Preferably these should be treated together to avoid unnecessary repetition. Unsupported elaboration of hypotheses and verbose exposition of ideas should be avoided. Results and Discussion may be presented in different sections.

Acknowledgements
If any support is given to the work by an institution or a person, it should be indicated as acknowledgement in the manuscript. Acknowledgements should be kept as short as possible, and placed at the conclusion of the text.

References
Literature references are to be numbered consecutively and should be grouped together at the end of the paper under the heading “References”. In the text references are quoted by giving the corresponding numbers of the references list as Arabic numerals in square brackets. APA style, which is the international reference writing format, should be used. In scientific articles using footnotes, the references for footnotes should be included in the references at the end of the article.
If the reference is a journal paper: Author surname, first name initial(s), title of the paper, journal name, volume number, pages, year.
Goto, S., Levec, J. and Smith, J.M., “Mass transfer in packed ebds with two-phase flow”, Ind. Eng. Chem. Process Des. Dev . , 14(2): 473-485, (1975).
If the reference is a book: Author surname, first name initial(s), title of the book, volume number, editor(s) (if provided), place of print , page interval, year.
McAdams, W. H., Heat Transmission 2 nd ed. , McGraw Hill , New York, (1942).
If the reference is a printed thesis: Author surname, first name initial(s), title of the thesis, thesis type (MSc. or Ph.D), institute submitted, place, page interval, year.
Tezcan, L., “Mathematical Modeling of Karst Aquifer Systems with the Use of Tritium Isotope”, Phd.Thesis, Hacettepe University Institute of Science and Technology, Ankara, 10-15 (1993).
If the reference is a congress presentation: Author surname, first name initial(s), title of the presentation, name of the congress, seminar or conference, place, page interval, year.
Toppare, L., “4-bromstrien and a-metilstiren Copolimerization with Electrochemical Process”, II. National Macromolecule Symposium, İzmir, 85-96, (1985).
If the reference is a source publication: Author surname, first name initial(s), report name, name of the organization (if the report is prepared by an organization), report number (if applicable), place, page interval, year.
Baran, I. and Kasparek,M., “Marine Turtles Of Turkey; Status Survey 1988 And Recommendations For Conservation And Management”, WWF Report , Heidelberg, 123-130, (1989).
If the reference is a daily magazine or newspaper:
Corliss, Richard, Sept. 13, Pacific Overtures Times, 142(11): 68-70 (1993).
If the reference is For Electronic Encyclopedia and books:
Internet: Bosnia and Herzegovina, In Britannica Online. http://www.-eb.com:180/cgi-bin/g?DocF=micro/79/88.html , (2000).
Articles not yet published should be given as “accepted” or “in press” only if accepted for publication. Otherwise, unpublished articles should be referred to as “submitted for publication”, “in preparation” or “personal communication”, as appropriate.

Figures and Tables
Figures, graphs, photographs and tables in JPG or TIFF format should be given inside (not a seperate page) the manuscript. The photographs should be scanned and submitted as original copies. All figures and tables should be numbered consecutively in Arabic numerals throughout the paper. Footnotes to tables should be with lower-case letters. Line drawings are preferable to photographs. Scanned graphs are less preferred and acceptable only if adequately resolved. Inscriptions should be clearly legible. It is recommended that the letters are 2-3 mm high. Half-tone illustrations, if any, should be well contrasted and trimmed at right angles in the desired final size. Graphs should not be present in large format (e. g. A4 full size), but rather in a typical size of 6—8 cm.

Nomenclature, symbols and abbreviations
In general, the recommendations of the SI units should be followed. Symbols, formulas and equations should be written with great care, capitals and lower case letters being distinguished where necessary. Particular care should be taken in typing mathematical expressions containing superscripts and in proof-reading such equations. Mathematical expressions should be written by an equation editor (Word format) in 9 point size. Indices font should be 8 point size. Each equation in text should be numbered in parenthesis ( ). Unusual symbols employed for the first time should be defined by name in the left-hand margin. Abbreviations require definition when first used.
The authors may recommend 2 arbitrators on request.
Note: Authors may recommend two potential reviewers from different geographical locations. These should be experts in their field, who will be able to provide an objective assessment of the manuscript. Any suggested peer reviewers should not have published with any of the authors of the manuscript within the past five years, should not be current collaborators, and should not be members of the same research institution. Reviewers suggested by authors will be considered alongside potential reviewers recommended by the Editorial Board. Authors must add the name, address and e-mails of reviewers to the part of "Author Comments" during the submission of the manuscript.

JOURNAL ETHICS

Gazi University Journal of Science Part B: Art Humanities Design and Planning has accepted that internationally accepted ethical rules and publication policies should be applied by all parties (editor, referee, author).

GUJSPB observes the publication ethics principles, standards and recommendations set by COPE (Committee on Publication Ethics). As of April 1, 2022, GUJSPB guarantees the publication and quality of the articles in terms of compliance with the ethical rules. Ethical issues will be evaluated in accordance with COPE rules and journal guidelines. The ethical responsibilities of the parties are also specified below.

While the article is uploaded to the system, the "Copyright Transfer Form" filled and signed by all authors and the "Manuscript Title Form" containing the author's information should also be uploaded. In order for an article to be published in the journal, it must be approved for publication by at least two referees. The articles that passed the blind referee process and did not have any missing documents were deemed suitable for publication and sharing in the journal. However, in the publication process or after publication, articles that do not comply with the publication ethics policy of the journal are removed from publication. Journal referees and/or editorial board have the right to request documents related to the work outputs from the authors in the studies they deem necessary. If the required documents are not submitted, the article will be rejected.

If there is a behavior that does not comply with the ethical principles of the parties, an unethical situation of a work sent or published for publication, the journal e-mail address should be informed.

Ethical Responsibilities of Editors

• Editors should strive to improve the quality of publication in the journal.
• Editors should be independent of any commercial institution.
• Editors should be clear about their expectations from reviewers and authors.
• Public interest should be considered in the decisions made in the journal.
• Editors should keep records of each article and correspondence related to the journal electronically or in print.
• Editors should complete their work with impartiality, confidentiality, conflict of interest and peer review processes.
• Editors should manage unethical behavior in accordance with rational ethical rules.
• The articles uploaded to the journal should be checked for compliance with the journal before they are submitted to the referees (at least 2 copies) by the relevant editor. These are the eligibility steps:
o Compliance with spelling rules
o Compliance with the template in shape
o Compliance with its purpose and scope
o Compliance with publication principles
o Compliance with publication ethics
o Scientific quality and originality should be examined.

Ethical Responsibilities of Referees

• The article should be checked in accordance with the journal's guidelines.
• The academic quality and originality of the article should be examined.
• Should not share information about the work with the authors or others.
• Evaluations should be concrete, measured and objective.
• During the evaluation process, the referees should pay attention to the time given to them. If necessary, additional time should be requested.
• In case of copyright infringement and plagiarism, the editor should be informed immediately.

Ethical responsibilities of authors

• Author names should be presented in full.
• Person(s) who did not contribute to the study should not be included as authors.
• Studies that are not covered by the journal should not be submitted.
• Studies involving plagiarism and unethical publishing behavior should not be done.
• There should be no copyright infringement.
• It should not disclose a place/person/institution/organization etc.
• There should be no conflicts of interest.
• Must comply with reporting standards.
• The data used should be available when needed.
• Be open and honest about the results of the study.
• The methodology of the study should be clearly stated.
• Multiple publications should not be made from the same work.
• Appropriate citations and references should be used within the scope of the study.
• The article should not have obvious errors.
• The similarity rate detected before publication should be below 20% (Turnitin).

The authors are responsible for the submitted and published work.

JOURNAL PUBLICATION POLICY

As of 2013, all parts (a, b, c) of Gazi University Journal of Science are published in English and in electronic format, 4 issues per year.

Gazi University Journal of Science Part B: Art Humanities Design and Planning is a double-blind, peer-reviewed, indexed and open access journal. The content of the journal can be accessed online at no cost. Therefore, Gazi University Journal of Science Part B: Art Humanities Design and Planning does not charge any product processing fees (APC) and article submission fees (ASC).
Article finalization period is a maximum of 4 months.

The article (or study) in the evaluation process can be withdrawn through the DergiPark system, provided that all authors send the withdrawal request letter with wet signature. However, the article cannot be sent to another journal before this process is completed. A completed article cannot be withdrawn.

All rights of the published articles belong to Gazi University Journal of Science, Part B: Art Humanities Design and Planning.

Scientific responsibilities of the article belong to the authors.