Farklı Kılıf Lif Türü, İplik Numarası ve Öz Filament İnceliği Kullanılarak Üretilen Elastan İçerikli Özlü İpliklerin İplik Ve Bazı Kumaş Özelliklerinin İncelenmesi

Abstract

Bu çalışmada, kılıf lif türü, öz filamenti inceliği ile ve iplik numarası gibi özlü iplik üretim parametrelerinin iplik ve bazı kumaş özelliklerine etkisi incelenmiştir. %100 pamuk yanında %100 viskon ve %50/50 pamuk/Tencel lifleri kılıf tabakası ve iki farklı inceliğe sahip elastan (Lcyra) filamentleri öz olarak kullanılmış, üç farklı iplik numarasına sahip özlü iplikler elde edilmiştir. İplik özellikleri yanında elde edilen dokuma ve örme kumaşların kopma mukavemeti ve uzaması, patlama mukavemeti, boncuklanma direnci gibi özellikleri belirlenmiştir. Çalışma sonunda, konvansiyonel ring, OE-rotor gibi bilinen iplik türlerinde olduğu gibi kılıf lifine ait lif uzunluğu, kısa lif sayısı gibi elyaf özelliklerini etkilemesi açısından kılıf lif türünün iplik düzgünsüzlüğü ve hataları, liflere ait gerilme özellikleri açısından iplik ve kumaş mukavemeti ve kopma uzaması, kılıf tabakasındaki lif sayısını belirlemesi açısından iplik numarasının özlü ipliklerin iplik özellikleri üzerinde etkili olduğu, öz filamentinin kaplanabilmesi ve kılıf tabakasındaki lif sayısı durumu açısından öz filamenti inceliğinin iplik ve kumaş özelliklerini etkilediği tespit edilmiştir.  

Keywords

• Özlü iplik,elastik ürünler,esneklik,elastan

Study of Yarn and Fabric Properties of Elastane Core-Spun Yarns Produced From Different Sheath Fibre Types, Yarn Counts and Core Filament Finenesses

Abstract

 In this study, it was aimed to research the effects of various production parameters of core-spun yarns such as different sheath fibre type, core filament linear density and yarn fineness on yarn and some of the fabric properties. In addition to 100% cotton fibres, viscose (100%) and cotton/Tencel (50/50%) fibres were chosen as sheath fibres for the covering of the core filaments in the yarn centre while elastane (Lcyra) core filament having two different filament linear densities were used as a core material and core-spun yarns were obtained having three different yarn counts. In the study, known yarn quality parameters and also breaking strength and elongation, bursting strength and pilling behaviour of woven and knitted fabrics were determined. As in known yarn types such as conventional ring, OE-rotor etc., it is determined that analyzed production parameters have an influence on yarn and fabric properties. For example, sheath fibre characteristics reflect onto yarn unevenness and faults resulted from fibre length and number of short fibres and also onto breaking strength and elongation of yarn and fabrics resulted from fibre tensile properties. On the other hand, yarn count resulted from number of fibres in yarn structure and core filament fineness regarding with coating of the core filament and the number of fibres in the sheath layer of core-spun yarns affects yarn and fabric properties. 

Keywords

• Core-spun yarn,elastic products,elasticity,elastane

References

1. Akankwasa, N.T., Jun, W., Yuze, Z., Mushtaq, M., (2014), Properties of Cotton/T-400 and 100% Cotton Plain Knitted Fabric Made From Ring Spun Yarn, Materialwissenschaft und Werkstofftechnik, 45(11), 1039-1044.
2. Das, A., Chakraborty, R., (2013), Studies On Elastane-Cotton Core-Spun Stretch Yarns And Fabrics: Part I-Yarn Characteristics, Indian Journal Of Fibre&Textile Research, 38, 237-243.
3. Babaarslan, O., (2001), Method Of Producing A Polyester/Viscose Core-Spun Yarn Containing Spandex Using A Modified Ring Spinning Frame, Textile Research Journal, 71(4), 367-371.
4. Babaarslan, O., Tüzün, Z., (2000), Core-spun Properties, Textile Asia, 31(12), 29–31.
5. Bizjak, E.A., Kadoğlu, H., Kostajnšek, K., Çelik, P., Bayraktar, G.B., Duran, D., Dimitrovski, K., (2017), Properties Of Elastic Fabrics With Treated And Untreated Co/PBT Yarns In Weft Direction, In IOP Conference Series: Materials Science and Engineering, 254(9), 092001.
6. Çelik, H., Kaynak, H.K., (2017), An Investigation On The Effect Of Elastane Draw Ratio On Air Permeability Of Denim Bi-Stretch Denim Fabrics, In IOP Conference Series: Materials Science and Engineering, 254(9), 082007.
7. Kaynak., H.K., (2017), Optimization Of Stretch And Recovery Properties Of Woven Stretch Fabrics, Textile Research Journal, 87(5), 582–592.
8. Akankwasa, N.T., Wang, J., Zhang, Y., (2016), Study Of Optimum Spinning Parameters For Production Of T-400/Cotton Core Spun Yarn By Ring Spinning, The Journal Of The Textile Institute, 107(4), 504-511.

9. Kadoğlu, H., Dimitrovski, K., Marmaralı, A., Çelik, P., Başal Bayraktar, G., Bedez Üte, T., Ertekin, G., Demšar, A., Kostanjek, K., (2016), Investigation Of The Characteristics Of Elasticised Woven Fabric By Using PBT Filament Yarns, Autex Research Journal, 16(2), 109-117.
10. Maqsood, M., Tanveer, H., Mumtaz, H.M., Nawab, Y., (2016), Modeling The Effect Of Elastane Linear Density, Fabric Thread Density And Weave Float On The Stretch, Recovery, And Compression Properties Of Bi-Stretch Woven Fabrics For Compression Garments, The Journal of The Textile Institute, 107(3), 307-315.
11. Varghese, N., Thilagavathi, G., (2015), Development Of Woven Stretch Fabrics And Analysis On Handle, Stretch and Pressure Comfort, The Journal Of The Textile Institute, 106(3), 242-252.
12. Qadir, M.B., Hussain,T., Malik, M., Fahemm, A., Jeong, S.H., (2014), Effect of Elastane Linear Density and Draft Ratio On The Physical and Mechanical Properties Of Core-Spun Cotton Yarns, The Textile Institute, 105(7), 753-759.
13. Helali, H., Babay, A.D., Msahli, S., (2013), Effect of Elastane Darft on The Rheological Modelling Of Elastane Core-Spun Yarn, The Journal Of The Textile Institute, 103(4), 451-457.
14. Helali, H., Babay, A.D., Msahli, S., (2012a), Influence Of Dorlastan Draft and Yarn Count On The Elastic Recovery Of The Dorlastan Core Spun Yarns Following Cyclic Test, 103(4), 378-374.
15. Helali, H., Babay, A.D., Msahli, S., (2012b), Rheological Modeling of the Dorlastan Core Spun Yarns for Various Dorlastan Drafts and Yarn Counts, 3, 127, DOI:10.4172 / 2165-8064.1000127.
16. Mourad, M.M, Elshakankery, M.H., Almetwally, A.A., (2012), Physical and Stretch Properties of Woven Cotton Fabrics Containing Different Rates of Spandex, Journal of American Science, 8(4), 567-572.
17. Adeli, B., Akbar, A., Shanbeh, G.M., (2011), Structural Evaluation Of Elastic Core-Spun Yarns And Fabrics Under Tensile Fatigue Loading, Textile Research Journal, 81(2), 137–147.
18. Baghaei, B., Shanbeh, M., Ghareaghaji, A.A., (2010), Effect Of Tensile Fatigue Cyclic Loads On Bagging Deformation Of Elastic Vovwen Fabrics, Indian Journal Of Fibre&Textile Research, 35, 298-302.
19. Vuruşkan, D., (2010), Elastan İçerikli İplik Üretmek Üzere Modifiye Edilen Ring Makinasında Üretim Değişkenlerinin Optimizasyonu Ve İplik Kalitesi Üzerindeki Etkisi, Çukurova Üniversitesi, Fen Bilimleri Enstitüsü, Doktora Tezi, Adana.
20. Herath, C.N., Kang, B.C., (2008), Dimensional Stability Of Core Spun Cotton/Spandex Single Jersey Fabrics Under Relaxation, Textile Research Journal, 78(3), 209–216.
21. Özdil, N., (2008), Stretch and Bagging Properties of Denim Fabrics Containing Different Rates of Elastane, Fibres & Textiles in Eastern Europe, 16(1), 66.
22. Kakvan, S., Najar, S., Saidi, R.G., Nami, M., (2007), Effects Of Draw Ratio And Elastic Core Yarn Positioning On Physical Properties Of Elastic Wool/Polyester Core-Spun Ring Yarns, The Journal Of The Textile Institute, 98(1), 57-63.
23. Dhouib, A.B., El-Ghezal, S., Cheikhrouhou, M., (2006), A Study Of The Impcat Of Elastane Ratio On Mechanical Properties Of Cotton Wrapped Elastane-Core Spun Yarns, The Journal Of The Textile Institute, 97(2), 167-172.
24. Demirbaş, S., (2005), Farklı Elastomerik Elyaf Çeşitlerinin Fiziksel Özelliklerinin Karşılaştırılması, Süleyman Demirel Üniversitesi Fen Bilimleri Enstitüsü, Yüksek Lisans Tezi, Isparta.
25. Su, C.I., Maa, M.C., Yang, H.Y., (2004), Structure And Performance Of Elastic Core-Spun Yarn, Textile Research Journal, 74(7), 607-610.
26. Su, C.I., Yang, H.Y., (2004), Structure And Elasticity Of Fine Elastomeric Yarns, Textile Research Journal, 74(12), 1041-1044.
27. Örtlek, H.G., Babaarslan, O., (2003), Spandex (Lycra®) İçerikli Core-Spun İpliklerin (Pes/Viskon) Tüylülük Özelliklerinin İncelenmesi, Uludağ Üniversitesi Mühendislik-Mimarlık Fakültesi Dergisi, 8(1), 79-91.
28. Örtlek, H., G., (2001), Spandex içerikli (lycra)'lı core-spun ipliklerin tüylülük özelliklerinin incelenmesi, 89.
29. Çelikkan Aydoğdu, S.H., (2018), Tek Ve Çift Elastan Bileşenli Özlü İpliklerin Ve Üretilen Kumaşlarin Özelliklerinin İncelenmesi, Yüksek Lisans Tezi, Süleyman Demirel Üniversitesi, Fen Bilimleri Enstitüsü, Isparta.
30. Bilir, T.B., Şardağ, S., (2017), Tencel ve Pamuk Karışımlı İpliklerin Performans Özelliklerinin İncelenmesi, Uludağ Üniversitesi Mühendislik Fakültesi Dergisi, 22(1).
31. Örtlek, H.G., Ülkü, Ş., (2007), Effects of Spandex and Yarn Counts on the Properties of Elastic Core-spun Yarns Produced on Murata Vortex Spinner, Textile Research Journal, 77(6), 432–436.