Investigation of thermal transformation of composite material obtained from granite and recrystallized limestone natural stone wastes

Yıl 2022, , 27 - 38, 05.12.2022

Gökhan Erol Devrim Pekdemir

https://doi.org/10.19111/bulletinofmre.1081187

Öz

In this study, the usability of granite (magmatic) and recrystallized limestone (metamorphic) natural stone wastes as alternative raw materials in ceramic tile production was investigated. Based on the CaO, SiO2, and Al2O3 compounds found in waste powders, mixtures containing 65% granite and 35% recrystallized limestone (by mass) were prepared to obtain the ceramic phases of gehlenite, wollastonite and anorthite as a result of thermal transformation. The grain size of both raw materials is -149 μm (d90 = 110.957 μm). The powder mixtures were moistened with 7% (by mass) water and shaped in a steel mold with dimensions of 75x20x50 mm with a uniaxial press with a setting of 127 MPa. The first series samples were called as natural building stone (DYT), and the second series samples, in which wood chips of 2% (by mass) -1 mm grain size are added to obtain porous material, were called as natural building stone - porous (DYT-G). The samples belonging to both series was applied heat treatment at 1.160°C. Phase analysis of samples obtained after heat treatment was measured by X-Ray Diffraction (XRD) and Scanning Electron Microscope (SEM-EDS) methods, and sintering properties were measured using water absorption coefficient, flexural strength, modulus of elasticity, density-porosity and color measurement tests. Gehlenite and wollastonite phases were detected in the heat treated samples, but no anorthite phase was observed. According to the test results, it was determined that the flexural strength (22.64 MPa) of the DYT marked sample was in accordance with the ceramic tile standards. In the DYT-G example, despite the decreasing unit volume mass value, it was determined that the bending strength (16.50 MPa) was in the range

of ceramic tile strength values.

Anahtar Kelimeler

Waste, Limestone, Thermal-Mechanical Behavior, Granite, Natural Stone.

Kaynakça

• ASTM C1259-15. 2015. standard test method for dynamic Young’s modulus, shear modulus, and poisson’s ratio for advanced ceramics by ımpulse excitation of vibration, ASTM International, West Conshohocken, PA.
• ASTM D5550-14. 2014. Standard test method for specific gravity of soil solids by gas pycnometer, ASTM International, West Conshohocken, PA.
• Callebaut, K., Elsen, J., Van Balen, K., & Viaene, W. (2001). Nineteenth century hydraulic restoration mortars in the Saint Michael's Church (Leuven, Belgium): natural hydraulic lime or cement?. Cement and Concrete Research 31(3), 397-403.
• Ciullo, P.A. 1996. Industrial Minerals and Their Uses, Noyes Publications, New Jersey, 607.
• DPT. 2001. Madencilik Özel İhtisas Komisyonu Raporu Endüstriyel Hammaddeler Alt Komisyonu Toprak Sanayii Hammaddeleri Çalışma Grubu Raporu. Devlet Planlama Teşkilatı Ankara(yayımlanmış).
• Erol, G., Pekdemir, D. 2018. Investigation of thermal and mechanical behavıors of construction materials obtained from some natural stone waste. Bulletin of the Mineral Research and Exploration 157(157), 185-190.
• Genç, Ş. C. , Kayacı, K., Yıldırım, Y., Keskin, A., & Çırpın, A. 2019. Biga yöresi zeolitik tüfitlerin karakterizasyonu ve duvar karosu bünyelerinde kullanım olanaklarının araştırılması. Afyon Kocatepe Üniversitesi Fen ve Mühendislik Bilimleri Dergisi 19, 310-320.
• Gustavo, A. 2019. Evaluation of the effect of natural stone processing waste ıncorporation on red ceramics physical properties. London Journal of Research of Engineering Research 19(1).
• Gündüz, L. 1995. Dekoratif taş endüstrisinde granit. Endüstriyel Hammaddeler Sempozyumu, İzmir.
• Kara, A., Özer, F., Kayaci, K., & Özer, P. 2006. Development of a multipurpose tile body: phase and microstructural development. Journal of the European Ceramic Society 26(16), 3769-3782.
• Kogel, J. E., Trivedi, N. C., Barker, J. M., Krukowski,S. T. 2006. Industrial Minerals and Rocks (7th Edition). Society for Mining, Metallurgy, and Exploration Inc., Colorado, 1507.
• Pastor, J. L., Tomás, R., Cano, M., Riquelme, A., & Gutiérrez, E. 2019. Evaluation of the ımprovement effect of limestone powder waste in the stabilization of swelling clayey soil. Sustainability 11(3), 679.
• Sletson, L. C., Reed. J.S. 1988. Microstructure development in a vitrified anorthite porcelain. The American Ceramic Society Bulletin 67(8), 1403-1408.
• Sousa, S. J. G., Holanda, J. N. F. 2005. Development of red wall tiles by the dry process using Brazilian raw materials. Ceramics International 31(2), 215-222.
• T. C. Ekonomi Bakanlığı. 2014. Doğal Taş Sektör Raporu. Ankara(yayımlanmış).
• TS EN 12407. 2019. Natural stone test methods-petrographic examination. Turkish Standards Institute.
• TS EN 14411. 2006. Ceramic tiles-definitions, classification, characteristics and marking. Turkish Standards Institute.
• TS EN 15309. 2008. Characterization of waste and soil - determination of elemental composition by x-ray fluorescence. Turkish Standards Institute.
• TS ISO 13320. 2009. Particle size analysis - laser diffraction methods. Turkish Standards Institute.
• Uz, B. 1990, Granit mermer. Mermer Dergisi 13, 18-19.