Experimental Performance Evaluation of Hybrid Isolation Systems

Öz

The seismic isolation technology is an innovative design/retrofit method. It decouples the structural response from the ground motion to reduce floor accelerations while concentrating most of the deformation demands at the isolation interface. The main objective of this research study is to investigate the effectiveness of passive-hybrid isolation systems for a ¼ scaled mass concentric three-story steel structure. The passive-hybrid isolation system is a combination of HDRB and PTFE sliding bearings. The ground motion used in the shake table tests is gradually increased to investigate changes in the dynamic response characteristics of the hybrid isolation system. It has been observed that the isolation system consisting of elastomer units with larger shear modulus subjected to higher base shear with displacement demands than the system with the lower shear modulus.

Anahtar Kelimeler

• Seismic isolation
• HDRB
• Flat friction sliders
• shake table tests

Karma Deprem Yalıtım Sistemlerinin Deneysel Performans Değerlendirmesi

Öz

Deprem yalıtım teknolojisi yer hareketi ile yapısal sistem arasında bir ayrışım yaratarak depremlerin yıkıcı etkilerini azaltmak amacı ile kullanılan yenilikçi bir tasarım ve güçlendirme yöntemidir. Bu çalışma ¼ ölçekli üç katlı simetrik ve eşmerkezli çelik yapının korunması için önerilen karma yalıtım sistemlerinin sarsma masası deneyleri ile etkinliğinin araştırılması üzerine odaklanmaktadır. Kullanılan pasif yalıtım sistemi, yüksek sönümlü elastomer ve düz yüzeyli sürtünme tipi kayıcı yalıtım birimlerinden oluşmaktadır. Deney programında kullanılan yer hareketi kademeli olarak arttırılarak, yalıtım sisteminde ortaya çıkabilecek davranış farkları araştırılmıştır. Deprem kaydının %100 etkitildiği durumda daha yüksek kayma modülüne sahip olan elastomer birimlerden oluşan yalıtım sisteminin daha düşük kayma modulüne sahip olan deprem yalıtım sistemine oranla taban kesme kuvveti açısından beklenildiği gibi daha yüksek değerler verdiği gözlenmiştir.

Anahtar Kelimeler

• Deprem Yalıtımı,
• Yüksek Sönümlü Elastomer,
• Sürtünme tipi düz yüzeyli elastomer,
• Sarsma Masası
• Sismik İzolasyon

Kaynakça

1. Hancilar, U., Tuzun, C., Yenidogan, C., and Erdik, M. 2010. ELER software – a new tool for urban earthquake loss assessment, Natural Hazards Earth System. Sci., 10, 2677-2696, doi: 10.5194 /nhess-10-2677-2010
2. Erdik, M., Sesetyan, K., Demircioglu, M.B., Hancilar, U., Zulfikar, C., Durukal, E., Kamer, Y., Yenidogan, C., Tuzun, C., Cagnan, Z., Harmandar, E. 2010. Rapid Earthquake Hazard and Loss Assessment for Euro-Mediterranean Region, Acta Geophysica, vol.58, no.5, pp: 855 -892
3. Multi-hazard Loss Estimation Methodology Earthquake Model Hazus MHMR4 Technical Manual, Department of Homeland Security Emergency Preparedness and Response Directorate FEMA Mitigation Division, 2003.
4. Di Sarno, L., Yenidogan, C., Erdik, M. 2013. Field evidence and numerical investigation of the Mw = 7.1 October 23 Van, Tabanlı and the MW > 5.7 November earthquakes of 2011, Bulletin of Earthquake Engineering, 11:313–346. DOI: 10.1007/s10518-012-9417-0
5. Kani N. Current 2009. State of Seismic Isolation Design, Journal of Disaster Research; 4(4):175–181.
6. Türkiye Bina Deprem Yönetmeliği, TC İçişleri Bakanlığı AFAD Afet ve Acil Durum Yönetimi Başkanlığı, Resmi Gazete No.: 30364, 2018
7. Yenidogan, C., Yokoyama, R., Nagae, T., Tahara, K., Tosauchi, Y., Kajiwara, K., Ghannoum, W. 2018. Shake table test of a full-scale four-story reinforced concrete structure and numerical representation of overall response with modified IMK model, Springer, Bulletin of Earthquake Engineering, Cilt 16 s. 2087–2118. DOI: 10.1007/s10518-017-0261-0
8. Nagae, T., Uwadan, S., Yenidogan, C., Yamada, S., Kashiwa, H., Hayashi, K., Takahashi, T., Inoue,T., 2021. The 2019 full-scale shake table test program of wood dwellings, 17th World Conference on Earthquake Engineering, 17WCEE, September 27 to October 2, Paper No. C002274.

9. Yenidogan, C., Takahashi, T., Nagae, T., Inoue, T. 2021. Seismic Performance Evaluation of a Base Isolated P&B Structure Through Full-Scale Shake Table Tests, 17th World Conference on Earthquake Engineering, 17WCEE, September 27 to October 2, Paper No. C002274.
10. Yenidogan, C., Nishi, R., Nagae, T., Koichi Kajiwara, 2020. Full-scale cyclic test of a Japanese post and beam wood shearwall assembly, Bull Earthquake Eng Cilt 18, 4985–5008.
11. Yenidogan C., Nishi,R., Uwadan, S., Nagae, T., Isoda,H., Tsuchimoto,T., Inoue,T., Kajiwara, K.2021.Full-scale shake table tests of P&B type of Japanese three-story wood dwellings for the collapse characterization, Soil Dynamics and Earthquake Engineering, Vol. 150, 1-22. DOI: 10.1016/j.soildyn.2021.106898
12. Aydin E.R., Ozturk B., Kilinc O.F. Seismic Response of Low-Rise Base Isolated Structures. In15th World Conference on Earthquake Engineering, Portugal 2012 Vol. 24, pp. 19493-19502
13. Kelly JM. 1997. Earthquake-Resistant Design with Rubber. Springer-Verlag London Limited, 243s.
14. Naiem, F. and J.M. Kelly, 1999. Design of Seismic Isolated Structures. Wiley; HAR/CDR Edition John Wiley & Sons, New York, 304s.
15. Skinner, R.I., W.H. Robinson, and G.H. McVerry, 1993. An Introduction to Seismic Isolation, John Wiley& Sons, New York, 354s.
16. Xuan, D., Pavel, C., Wang, SJ, Medel, RA, Smirnov, V., Yenidogan, C., Forni, M., Aiken, I. 2016. Recent Information on Seismically Isolated Buildings in the World, Journal of Japanese Society of Seismic Isolation “MENSHIN”, May, 2016.
17. Yenidogan, C., Erdik, M. 2014. The State of Art in Seismic Isolation and Energy Dissipation Applications in Turkey, The Japan Society of Seismic Isolation, Menshin Cilt 83, 49-59, 2014-02.
18. Yenidogan, C. 2021. Earthquake-Resilient Design of Seismically Isolated Buildings: A Review of Technology, Vibration, Cilt 4, no. 3, s. 602-647. DOI: 10.3390/vibration4030035
19. Türkiye Sağlık Bakanlığı, Deprem Yalıtımlı olarak İnşa Edilecek Yapılara Ait Proje ve Yapım İşlerinde Uyulması Gereken Asgari Standartlar, 2013.
20. Deprem Bölgelerinde Yapılacak Binalar Hakkında Yönetmelik,Resmi Gazete No.: 26454, 2007
21. CSI SAP2000V22. Analysis Reference Manual. CSI: Berkeley (CA, USA): Computers and Structures Inc. 2020.
22. Mazzoni S, McKenna F, Scott MH, Fenves GL. OpenSees command language manual. Pacific Earthquake Engineering Research (PEER) Center. 2006 Jul 19;264.
23. Basu, B..,Bursi, O. S.,Casciati, F.,Casciati, S.,Del Grosso, A. E.,Domaneschi, M.,Faravelli, L.Holnicki‐Szulc, J.,Irschik, H.,Krommer, M.,Lepidi, M.,Martelli, A.,Ozturk, B.,Pozo, F.,Pujol, G.,Rakicevic, Z. and Rodellar, J.(2014),A European Association for the Control of Structures joint perspective. Recent studies in civil structural control across Europe,Struct. Control Health Monit.,21:1414–1436. DOI:10.1002/stc.1652
24. Yenidogan, C and Mustafa E. 2016. A comparative evaluation of design provisions for seismically isolated buildings, Soil Dynamics and Earthquake Engineering, Cilt 90, s. 265-286. DOI: 10.1016/j.soildyn.2016.08.016
25. Prestandard and Commentary for the Seismic Rehabilitation of Buildings, FEMA 356, 2000, Prepared by the American Society of Civil Engineers for the Federal Emergency Management Agency, Washington, D.C. pp. 100-400.
26. Minimum Design Loads and Associated Criteria for Buildings and Other Structures ASCE/SEI 7 16, American Society of Civil Engineers, 2017.
27. CEN, Eurocode 8: design of structures for earthquake Resistance—Part 1: general rules, seismic actions and rules for buildings. EN 1998–1:2004. Comité Européen de Normalisation, Brussels, 2004.
28. Japanese Ministry of Land, Infrastructure and Transport, Notification No. 2009–2000, Technical Standard for Structural Specifications and Calculation of Seismically Isolated Buildings. (in Japanese). 2000.
29. Constantinou, M.C., Tsopelas, P., Kasalanati, A., and Wolff, E.D. 1999. Property modification factors for seismic isolation bearings. Report MCEER-99-0012, Multidisciplinary Center for Earthquake Engineering Research, State University of New York.
30. Tsopelas, P.C., Constantinou, M.C. and Reinhorn, A.M., 1994. 3D-BASIS-ME: Computer program for nonlinear dynamic analysis of seismically isolated single and multiple structures and liquid storage tanks.