Araştırma Makalesi

Voltage Dependent Barrier Height, Ideality Factor and Surface States in Au/(NiS-PVP)/n-Si (MPS) type Schottky Barrier Diodes

Cilt: 11 Sayı: 2 1 Haziran 2021
PDF İndir
EN TR

Voltage Dependent Barrier Height, Ideality Factor and Surface States in Au/(NiS-PVP)/n-Si (MPS) type Schottky Barrier Diodes

Öz

Metal-Polymer-Semiconductor (MPS) Schottky Barrier Diodes (SBD) were manufactured and their basic electrical parameters were obtained by the measurement of the forward and reverse bias current-voltage (I-V) in the wide bias voltage range (±3V) to determine the voltage dependent effects on Nickel-Sulphur (NiS) doped Poly Vinyl Pyrrolidone (PVP) polymer interlayer. The saturation current (I0), zero-bias barrier height (ΦB0), rectifying rate (RR), ideality factor (n) and the real value of series - shunt resistances (Rs - Rsh) were calculated. The voltage dependent profile of n (V), ΦB(V), and Rs (V) were derived. The forward bias ln I-V plot of the MPS type SBD indicates a good rectifier behaviour and it has two distinctive linear parts with different slopes which correspond to low (0.288 ≤V ≤0.625 V) and moderate (0.672 ≤ V ≤ 0.960 V) bias voltages and then deviates from linearity due to Rs and interlayer at high forward bias voltages. Energy dependent profile of Nss was obtained from the forward bias I-V data by considering voltage dependent barrier height (ΦB) and n. Nss plot represents U-shape behaviour in the forbidden bandgap. The mean value of Nss was found at about 7.0x1012 eV-1 cm-2 and this value is in the acceptable limit for a semiconductor device and such lower values of Nss are the consequences of the passivation effect on the surface states.

Anahtar Kelimeler

Kaynakça

  1. Akhlaghi EA, Badali Y, Altindal S, Azizian-Kalandaragh Y, 2018. Preparation of mixed Copper/PVA nanocomposites as an interface layer for fabrication of Al/Cu-PVA/p-Si Schottky structures. Physica B-Condensed Matter, 546: 93-98.
  2. Alptekin S, Altindal S, 2019. Comparative study on current/capacitance: Voltage characteristics of Au/n-Si (MS) structures with and without PVP interlayer. Journal of Materials Science: Materials in Electronics, 30: 6491-6499.
  3. Altindal Yeriskin S, Balbaşi M, Orak I, 2017. The effects of (graphene doped-PVA) interlayer on the determinative electrical parameters of the Au/n-Si (MS) structures at room temperature. Journal of Material Science: Material Electronics, 28: 14040–14048.
  4. Altindal Yerişkin S, 2019. The investiagtion of effects of (Fe2O4-PVP) organic interlayer, surface states, and series resistance on the electrical characteristics and sources of them. Journal of Materials Science Materials in Electronics, 30: 17032-17039.
  5. Badali Y, Nikravan A, Altindal S, Uslu I, 2018. Effects of a thin Ru-doped PVP interface layer on electrical behaviour of Ag/n-Si structures. Journal of Electronic Materials, 47: 3510-3520.
  6. Bohlin KE, 1986. Generalized Norde plot including determination of the ideality factor. Journal of Applied Physics, 60: 1223.
  7. Card HC, Rhoderick EH, 1971. Studies of tunnel MOS diodes I. Interface effects in silicon Schottky diodes. Journal of Physics D: Applied Physics, 4: 1589–1601.
  8. Cheung SK, Cheung NW, 1986. Extraction of Schottky diode parameters from forward current-voltage characteristics. Applied Physics Letters, 49: 85.

Ayrıntılar

Birincil Dil

İngilizce

Konular

Metroloji,Uygulamalı ve Endüstriyel Fizik

Bölüm

Araştırma Makalesi

Yayımlanma Tarihi

1 Haziran 2021

Gönderilme Tarihi

14 Ekim 2020

Kabul Tarihi

29 Aralık 2020

Yayımlandığı Sayı

Yıl 2021 Cilt: 11 Sayı: 2

Kaynak Göster

APA
Bucurgat, M. (2021). Voltage Dependent Barrier Height, Ideality Factor and Surface States in Au/(NiS-PVP)/n-Si (MPS) type Schottky Barrier Diodes. Journal of the Institute of Science and Technology, 11(2), 1058-1067. https://doi.org/10.21597/jist.810687
AMA
1.Bucurgat M. Voltage Dependent Barrier Height, Ideality Factor and Surface States in Au/(NiS-PVP)/n-Si (MPS) type Schottky Barrier Diodes. Iğdır Üniv. Fen Bil Enst. Der. 2021;11(2):1058-1067. doi:10.21597/jist.810687
Chicago
Bucurgat, Mahmut. 2021. “Voltage Dependent Barrier Height, Ideality Factor and Surface States in Au/(NiS-PVP)/n-Si (MPS) type Schottky Barrier Diodes”. Journal of the Institute of Science and Technology 11 (2): 1058-67. https://doi.org/10.21597/jist.810687.
EndNote
Bucurgat M (01 Haziran 2021) Voltage Dependent Barrier Height, Ideality Factor and Surface States in Au/(NiS-PVP)/n-Si (MPS) type Schottky Barrier Diodes. Journal of the Institute of Science and Technology 11 2 1058–1067.
IEEE
[1]M. Bucurgat, “Voltage Dependent Barrier Height, Ideality Factor and Surface States in Au/(NiS-PVP)/n-Si (MPS) type Schottky Barrier Diodes”, Iğdır Üniv. Fen Bil Enst. Der., c. 11, sy 2, ss. 1058–1067, Haz. 2021, doi: 10.21597/jist.810687.
ISNAD
Bucurgat, Mahmut. “Voltage Dependent Barrier Height, Ideality Factor and Surface States in Au/(NiS-PVP)/n-Si (MPS) type Schottky Barrier Diodes”. Journal of the Institute of Science and Technology 11/2 (01 Haziran 2021): 1058-1067. https://doi.org/10.21597/jist.810687.
JAMA
1.Bucurgat M. Voltage Dependent Barrier Height, Ideality Factor and Surface States in Au/(NiS-PVP)/n-Si (MPS) type Schottky Barrier Diodes. Iğdır Üniv. Fen Bil Enst. Der. 2021;11:1058–1067.
MLA
Bucurgat, Mahmut. “Voltage Dependent Barrier Height, Ideality Factor and Surface States in Au/(NiS-PVP)/n-Si (MPS) type Schottky Barrier Diodes”. Journal of the Institute of Science and Technology, c. 11, sy 2, Haziran 2021, ss. 1058-67, doi:10.21597/jist.810687.
Vancouver
1.Mahmut Bucurgat. Voltage Dependent Barrier Height, Ideality Factor and Surface States in Au/(NiS-PVP)/n-Si (MPS) type Schottky Barrier Diodes. Iğdır Üniv. Fen Bil Enst. Der. 01 Haziran 2021;11(2):1058-67. doi:10.21597/jist.810687

Cited By