Investigation of the Effect of X-ray Irradiation on the Contact Parameters of a Barrier Diode via Electrical Characterization
Abstract
In this study, the effects of high-energy X-ray irradiation on the electrical characteristics of Au/LiF/p-Si/Al barrier diodes were investigated. The device structure was obtained by inserting a thin lithium fluoride (LiF) interfacial layer between gold (Au) and p-type silicon (p-Si) using the thermal evaporation method. The current–voltage (I–V) characteristics of the fabricated diodes were measured under dark conditions at room temperature (300 K). The samples were exposed to X-ray radiation doses of 0 Gy (before irradiation), 25, 50, and 75 Gy, and the variations in the main diode parameters, namely the ideality factor (n), barrier height (Φb), and series resistance (Rs), were analyzed. The electrical parameters were calculated using the thermionic emission (TE) theory, and a detailed analysis was also performed using the Cheung and Norde methods. For the Au/LiF/p-Si/Al device, the ideality factor and barrier height using TE were calculated as 1.22 and 0.64 eV, respectively, before irradiation. At 25 Gy, the ideality factor and barrier height of the device were found to be 1.29 and 0.68 eV, respectively, while at 75 Gy, these values changed to 1.76 and 0.82 eV, respectively. Similar behavior has been observed in calculations using other methods. The obtained results indicated that irradiation significantly affects the diode behavior. Deviations from ideal behavior were observed with increasing radiation dose, which were attributed to radiation-induced defects and interface states.
Keywords
Barrier diode, X-ray irradiation, LiF, interface layer, rectifier contact
Thanks
References
- E. H. Rhoderick, R. H. Williams, “Metal–semiconductor contacts,” Clarendon Press, Oxford, 2nd ed., 1988.
- L. B. Taşyürek, et al., “The synthesis of SrTiO3 nanocubes and the analysis of nearly ideal diode application of Ni/SrTiO3 nanocubes/n-Si heterojunctions,” Materials Research Express, vol. 5, 015060, 2018.
- A. R. Deniz, et al., “The investigation of the electrical properties of Fe3O4/n-Si heterojunctions in a wide temperature range,” Journal of Colloid and Interface Science, vol. 473, pp. 172–181, 2016
- A. R. Deniz, et al., “Investigation of electrical properties of Ni/Crystal Violet (C25H30ClN3)/n-Si/Al diode as a function of temperature,” Journal of Alloys and Compounds, vol. 763, pp. 622–628, 2018.
- R. T. Tung, “Electron transport at metal–semiconductor interfaces,” Physical Review B, vol. 45, pp. 13509, 1992.
- V. R. Reddy, “Electrical properties of Au/polyvinylidene fluoride/n-InP Schottky diode with polymer interlayer,” Thin Solid Films, vol. 556, pp. 300–306, 2014.
- M. Erdoğan, A. R. Deniz, Z. Çaldıran, “A novel thiophene-based D-π-A type organic material: Synthesis, characterization and Schottky diode applications,” Journal of Photochemistry and Photobiology A: Chemistry, vol. 443, 114877, 2023.
- H. K. Lee, et al., “Effects of Ta-oxide interlayer on the Schottky barrier parameters of Ni/n-type Ge Schottky barrier diode,” Microelectronic Engineering, vol. 163, pp. 26–31, 2016.
- A. Yeşildağ, M. Erdoğan, Ö. Sevgili, Z. Çaldıran, İ. Orak, “Optical and electrical properties of pyrene–imine organic interface layer based on p-Si,” Journal of Electronic Materials, vol. 50, no. 11, pp. 6448–6458, 2021.
- Z. Çaldıran, “Fabrication of Schottky barrier diodes with the lithium fluoride interface layer and electrical characterization in a wide temperature range,” Journal of Alloys and Compounds, vol. 816, 152601, 2020.
