Determination Structural Properties of In-Doped CdTe/CdS Thin Films Solar Cells

Öz

Many methods have been used to produce thin film solar cells. Many of these methods are technically complex and expensive. In the present study, a thermal evaporation method with fewer usage parameters was used to produce thin film solar cells. In addition, the impacts of annealing on the structure of solar cells were investigated. The surface morphology of solar cells and the approximate content of each element were carried out with a QUANTA (FEG-250) model scanning electron microscopy and Energy Dispersive X-Ray Spectroscopy (SEM/EDS).The X-ray diffraction (XRD) measurements was performed using a BRUKER XRD system (D8 Advance) X-ray diffractometer. In the SEM analyzes, it was determined that the reduced in the roughness of the film surfaces was and clumping occurred as a result of annealing. But if the crystallite size is at submicron level, this negative situation can be overlooked. An increase in Cd was observed with EDS analysis. XRD diffraction has shown that the peaks in the (111), (200) and (211) planes increase the intensity of these peaks in the annealing result. As a result, it was determined that annealing affects positively the structural characteristics of In-doped CdTe/CdS solar cells.

Anahtar Kelimeler

• Thermal evaporated,Thin film solar cells,In-doped CdTe,Structural properties

Kaynakça

1. Tariq, G.H. and Anis-ur-Rehman, M., (2015). Annealing effects on physical properties of doped CdTe thin films for photovoltaic applications. Mater. Sci. Semicond. Process, 30: 665-671.
2. Singh S., Kumar R. and Sood K.N., (2010). Structural and electrical studies of thermally evaporated nanostructured CdTe thin films. Thin Solid Films, 519: 1078-1081.
3. Garadkar, K.M., Pawar, S.J., Hankare, P.P. and Patil, A.A., (2010). Effect of annealing on chemically deposited polycrystalline CdTe thin films. J. Alloys Compd., 491: 77-80.
4. Lalitha, S., Karazhanov, S.Z., Ravindran, P., Senthilarasu, S., Sathyamoorthy, R. and Janabergenov, J., (2007). Electronic structure, structural and optical properties of thermally evaporated CdTe thin films. Phys. B Condens. Matter, 387: 227-238.
5. Echendu, O.K., Dejene, B.F. and Dharmadasa, I.M., (2018). The effects of anode material type on the optoelectronic properties of electroplated CdTe thin films and the implications for photovoltaic application. J. Phys. Chem. Solids, 114: 100-108.
6. Zia, R., Saleemi, F. and Nassem, S., (2016). Optical properties of thermally evaporated CdTe thin films by varyingsubstrate temperature. Opt. - Int. J. Light Electron Opt., 127: 1972-1974.
7. Chander, S. and Dhaka, M.S., (2015). Physical properties of vacuum evaporated CdTe thin films with post-deposition thermal annealing. Phys. E Low-dimensional Syst. Nanostructures, 73: 35-39.
8. Shenouda, A.Y., Rashad, M.M. and Chow, L., (2013). Synthesis, characterization and performance of Cd1−xInxTe compound for solar cell applications. J. Alloys Compd., 563: 39-43.

9. Kırbaş, İ. and Karabacak, R., (2016). Effect of annealing on the structural properties of thermal evaporated CdIn2Te4/CdS thin film solar cells. Optik - International Journal for Light and Electron Optics, 127: 7986-7992.
10. Pandey, S.K., Tiwari, U., Raman, R., Prakash, C., Krishna, V., Dutta, V. and Zimik, K., (2005). Growth of cubic and hexagonal CdTe thin films by pulsed laser deposition. Thin Solid Films, 473: 54-57.
11. Khairnar, U.P., Bhavsar, D.S., Vaidya, R.U. and Bhavsar G.P., (2003). Optical properties of thermally evaporated cadmium telluride thin films. Mater. Chem. Phys., 80: 421-427.
12. Patil, V.B., More, P.D., Sutrave, D.S., Shahane, G.S., Mulik, R.N. and Deshmukh, L.P., (2000). A new process for deposition of the CdTe thin films. Mater. Chem. Phys., 65: 282-287.
13. Yilmaz, K., Golcur, D., Ozcan, Y., Takanoglu, D. and Karabulut, O., (2017). Effect of Substrate Temperature on the Transport Mechanisms of Polycrystalline CdIn2Te4 Thin Films Grown by Thermal Evaporation. J. Ovonic Res., 13(2): 71-76.
14. Li, H. and Liu, X., (2015). Improved performance of CdTe solar cells with CdS treatment. Sol. Energy, 115: 603-612.
15. Han, J., Fu, G., Krishnakumar, V., Liao, C., Jaegermann, W. and Besland, M.P., (2013). Preparation and characterization of ZnS/CdS bi-layer for CdTe solar cell application. J. Phys. Chem. Solid, 74: 1879-1883.
16. Rmili, A., Ouachtari, F., Bouaoud, A., Louardi, A., Chtouki, T., Elidrissi, B. and Erguig, H., (2013). Structural, optical and electrical properties of Ni-doped CdS thin films prepared by spray pyrolysis. J. Alloys Compd., 557: 53-59.
17. Chavez, H., Jordan, M., McClure, J.C, Cush, G. and Singh, V.P., (1997). Physical and electrical characterization of CdS films deposited by vacuum evaporation solution growth and spray pyrolysis. J. Mater. Sci. Electron, 8: 151-154.
18. Chander, S. and Dhaka, M.S., (2016). Impact of thermal annealing on physical properties of vacuum evaporated polycrystalline CdTe thin films for solar cell applications. Phys. E Low-dimensional Syst. Nanostructures, 80: 62-68.
19. Shaaban, E.R., Afify, N. and El-Taher, A., (2009). Effect of film thickness on microstructure parameters and optical constants of CdTe thin films. J. Alloys Compd., 482: 400-404.
20. Galloway, S.A., Edwards, P.R. and Durose, K., (1999). Characterization of thin film CdS/CdTe solar cells using electron and optical beam induced current. Sol. Energy Mater. Sol. Cells., 57: 61-74.
21. Ganetsos T., Belas E. and Kotsos B., (2011). Electrical properties and Raman study of In-doped effects in CdTe. Procedia Eng., 25: 354-357.
22. Belas, E., Grill, R., Franc, J., Hlidek, P., Linhart, V., Slavicek, T. and Höschl, P., (2008). Correlation of electrical and optical properties with charge collection efficiency of In-doped and In+Si co-doped CdTe. Nucl. Instruments Methods Phys. Res. Sect. A, 591: 200-202.
23. Mohammed, W.F. and Yousif, M.A.S., (2002). The electrical properties of post-deposition annealed and as-deposited In-doped CdTe thin films. Renew. Energy, 26: 285-294.
24. Seto, S., Suzuki, K., Abastillas, Jr V.N. and Inabe, K., (2000). Compensating related defects in In-doped bulk CdTe. J. Cryst. Growth, 214/215: 974-978.
25. Kumar, S., Sharma, S.K., Sharma, T.P. and Husain, M., (2000). CdTe photovaltic sintered films. J. Phys. Chem. Solids, 61: 1809-1813.
26. Rajendra, B.V. and Kekuda, D., (2012). Flexible cadmium telluride/cadmium sulphide thin film solar cells on mica substrate. J. Mater. Sci. Electron, 23: 1805-1808.
27. Chander, S. and Dhaka, M.S., (2015). Optimization of physical properties of vacuum evaporated CdTe thin films with the application of thermal treatment for solar cells. Mater. Sci. Semicond. Process, 40: 708-712.
28. El-Nahass, M.M., Youssef, G.M. and Noby, S.Z., (2014). Structural and optical characterization of CdTe quantum dots thin films. J. Alloys Compd., 604: 253-259.
29. Freik, D., Parashchuk, T. and Volochanska, B., (2014). Thermodynamic parameters of CdTe crystals in the cubic phase. J. Cryst. Growth, 402: 90-93.