Investigation of the behaviour of screw piles under uplift and compressive forces

Yıl 2024, Cilt: 13 Sayı: 3

Talha Sarıcı Mustafa Özcan

https://doi.org/10.28948/ngumuh.1380651

Öz

The usage of screw piles is one of the increasingly widespread ground improvement methods. In this study, the behaviour of linear, triangular, and square pattern screw piles in groups under tensile and compressive forces is investigated. The model experiments in the literature on screw piles were modelled by finite element method and a reasonably accurate agreement with the experimental results was obtained. Then, the number of helixes and helix diameters of the screw piles used in the experimental study were changed and the effect of the change in the number of helixes and diameter on the bearing capacity was investigated. Also, the behaviour and failure surfaces of screw piles under load were investigated. In conclusion, increasing the number of helixes significantly increased the bearing capacity. In fact, it was observed that the increase in the number of helixes was sufficient to reduce the number of piles as a result of the increase in the bearing capacity up to 100%. In addition, the increasing the diameter of the helixes by 1.8 times resulted an increase in the bearing capacity values between 80% and 100%. However, it was determined that the bearing capacity increases were different in each pattern.

Anahtar Kelimeler

Bearing Capacity, Screw Pile, Plaxis, Numerical Analysis, Tensile and Compression Force

Proje Numarası

FYL-2023-3293

Vidalı kazıkların çekme ve basınç kuvveti altında davranışının incelenmesi

Öz

Vidalı kazıklar kullanımı gittikçe yaygınlaşan zemin iyileştirme yöntemlerinden biridir. Bu çalışmada, doğrusal, üçgen ve kare örüntülü grup halindeki vidalı kazıkların çekme ve basınç kuvveti etkisi altındaki davranışları araştırılmıştır. Bu amaçla, literatürde kazıklar üzerinde gerçekleştirilen model deneyler sonlu elemanlar yöntemi ile modellenmiş ve deneysel sonuçlar ile son derece iyi bir uyum elde edilmiştir. Daha sonra deneysel çalışmada kullanılan kazıkların helezon sayısı ve helezon çapları değiştirilerek, helezon sayısı ve çap değişiminin taşıma gücüne etkisi incelenmiştir. Ayrıca vidalı kazıkların yük altındaki davranış ve yenilme yüzeyleri araştırılmıştır. Sonuç olarak, helezon sayısını arttırmak taşıma gücü kapasitesini önemli ölçüde arttırmıştır. Öyle ki, taşıma gücünde elde edilen %100’e varan artış sayesinde, helezon sayısındaki artışın kazık sayısını azaltacak mertebeye geldiği görülmüştür. Ek olarak helezonun çapının 1.8 kat artması ile taşıma gücü değerleri %80 ile %100 arasında artışa neden olmuştur. Bununla birlikte taşıma gücü artışlarının her örüntüde farklı oranda olduğu belirlenmiştir.

Anahtar Kelimeler

Taşıma Gücü, Vidalı Kazık, Plaxis, Sayısal Analiz, Çekme ve Basınç Kuvveti

Destekleyen Kurum

İnönü Üniversitesi Bilimsel Araştırma Projeleri Birimi

Proje Numarası

FYL-2023-3293

Teşekkür

İnönü Üniversitesi Bilimsel Araştırma Projeleri Birimi

Kaynakça

• H.A. Perko, Helical Piles: A Practical Guide to Design and Installation. 1st ed. John Wiley & Sons Inc, USA, 2009.
• J. G. Trofimenkov and L. G. Maruipolshii, Screw piles used for mast and tower foundations. Proceedings of the 6th International Conference on Soil Mechanics and Foundation Engineering, 2, pp. 328–332, Montreal, Canada, 1965.
• J. I. Adams and T. W. Klym, A study of anchorages for transmission tower foundations. Canadian Geotechnical Journal, 9(1), 89-104, 1972. https://doi.org/10.1139/t72-007.
• M. P. Mitsch and S. P. Clemence, The uplift capacity of helix anchors in sand. In: Uplift Behaviour of Anchor Foundations in Soil. American Society of Civil Engineers, pp. 26–47, New York, USA, 1985.
• J.S. Mooney, S. Adamczak and S.P. Clemence, Uplift capacity of helix anchors in clay and silt. American Society of Civil Engineers, 48–72, 1985.
• B. Ok ve A. Demir, Helisel ankraj plakalarının tabakalı zeminlerdeki çekme kapasitelerinin incelenmesi. Selcuk University Journal of Engineering, Science and Technology, 3(2), 25-25, 2015. https://doi.org/10.15317/Scitech.2015211035.
• S. Seifi, A. Nayeri and S.H. Lajevardi, Field and numerical studies on bearing capacity of helical screw piles in Caspian Sea coast soil. Innov. Infrastruct. Solut., 8, 54, 2023. https://doi.org/10.1007/s41062-022-01019-z
• H. Wang, H. Zhang and W. Zhang, Research on pile parameters of screw pile based on horizontal bearing capacity. Journal of Innovation and Development, 3(1), 168-174, 2023. https://doi.org/10.54097/ jid.v3i1.8476
• C. Yuan, D. Hao, S. Ding and M. Ding, Field experimental study on the uplift and lateral capacity of deep helical anchors and grouped helical anchors in clays. Buildings, 14(3), 662, 2024. https://doi.org/10.3390/buildings14030662
• S. Simonenko, J.A. Loya and M. Rodriguez-Millan, An experimental and numerical study on the ınfluence of helices of screw piles positions on their bearing capacity in sandy soils. Materials, 17(2), 525, 2024. https://doi.org/10.3390/ma17020525
• D. J. Y. Zhang, R. Chalaturnyk, P. K. Robertson, D. C. Sego, and G. Cyre, Screw anchor test program (Part I & II): instrumentation, site characterisation and installation. In: Proceedings of the 51st Canadian Geotechnical Conference, Edmonton, Canada, 1998.
• R. Schmidt and M. Nasr, Screw piles: uses and considerations. Struct. Mag., 29–31, 2004.
• B. Livneh and M.H.M. Naggar, Axial testing and numerical modelling of square shaft helical piles under compressive and tensile loading. Can. Geotech. J., 45 (8), 1142–1155, 2008. https://doi.org/10.1139/T08-044.
• M. Sakr, Performance of helical piles in oil sand. Can. Geotech. J., 46(9), 1046–1061, 2009. https://doi.org/10.1139/T09-044.
• M. Sakr, Installation and performance characteristics of high capacity helical piles in cohesionless soils. Deep Found. J., 5(1), 39–57, 2011. http://dx.doi.org/10.1179/dfi.2011.004
• B. Ok, Ankraj plakalarının farklı zemin koşullarındaki çekme kapasitelerinin incelenmesi. Yüksek Lisans Tezi, Osmaniye Korkut Ata Üniversitesi Fen Bilimleri Enstitüsü, Türkiye, 2014.
• Arup Geotechnics, Design of Screw Piles: Assessment of Pile Design Methodology. Ove Arup & Partners Ltd, London, 2005.
• V. Vignesh and M. Muthukumar, Experimental and numerical study of group effect on the behavior of helical piles in soft clays under uplift and lateral loading, Ocean Engineering, 268, 113500, 2023. https://doi.org/10.1016/j.oceaneng.2022.113500.
• His Teknik Çelik, Vidalı kazık galeri, https://histeknik.com/galeri/, Erişim 10 Kasım 2023.
• J. Binquet and K.L. Lee, Bearing capacity analysis of reinforced earth slabs. Journal of the Geotechnical Engineering Division, 101(12), 1257-1276, 1975.
• H.M. Bak, A.M. Halabian, H. Hashemolhosseini and M. Rowshanzamir, Axial response and material efficiency of tapered helical piles. Journal of Rock Mechanics and Geotechnical Engineering, 13(1), 176-187, 2021. https://doi.org/10.1016/j.jrmge.2020.04.007
• Y. Abdelghany, P. Eng, E. Hesham, and P. Naggar, Helical screw piles performance – a versatile efficient foundation system alternative for rehabilitation. New Sustainable Structures Construction and Infrastructure Delivery Sharjah, UAE, 2016.