INFLUENCES OF GRINDING CONDITIONS ON GALENITE-SPHALERITE FLOTATION KINETICS
Öz
Grinding is more than just crushing, it is also a process that causes a chemical reaction on the surface of the mineral. Water used in the grinding process significantly affects the galvanic interaction.
Different grinding conditions result in different pulp chemistries. This becomes especially important in sulfide flotation in terms of recovery and selectivity. There are limited studies examining the effects of dry and wet grinding prior to the flotation of sulfide minerals. This study compared the effects of wet and dry grinding on the flotation kinetics of complex Pb-Zn sulfide ore at P80 of 20 and 50 µm grind sizes. Results showed that dry grinding positively affected the sphalerite ore flotation compared to wet grinding in terms of recovery and grade in both galenite and sphalerite rougher flotation stages. Considering that the effect of dry grinding was due to the difference in pulp chemistry, the reasons were explored based on particle morphology, and pulp potentials.
The results showed that grinding the same ore under dry and wet conditions significantly affected the flotation performance. In light of the pulp potential measurements, it was determined that the reducing environment obtained in the wet grinding negatively affected the flotation performance, while the oxidizing environment formed during the dry grinding affected the flotation performance positively. This was attributed to the fact that galvanic interactions that occurred during wet grinding were significantly reduced during dry grinding. Hence, better galenite and sphalerite flotation was obtained following dry grinding.
Anahtar Kelimeler
flotation, dry grinding, wet grinding
Destekleyen Kurum
ESOGÜ BAP
Proje Numarası
2015-697 & 2017-1625
Teşekkür
The authors would like to thank ESOGÜ BAP “2015-697 & 2017-1625” for their financial support. The authors are also thankful to Prof. Dr. Uğur Ulusoy for his contribution to particle shape analysis.
Kaynakça
- Allison, S.A., Goold, L.A., Nicol, M.J.& Granville, A. (1972). A determination of the products of reaction between various sulphide minerals and aqueous xanthate solution, and a correlation of the products with electrode rest potential. Metall. Trans. 3, 2613–2618.
- Başaran, Ç. (2006). Kuru öğütmenin sülfürlü cevherlerin flotasyon performansına etkisi, Yüksek Lisans Tezi, Hacettepe Üniversitesi, Ankara, Türkiye.
- Bruckard, W.J., Sparrow, G.J. & Woodcock, J.T. (2011). A review of the effects of the grinding environment on the flotation of copper sulphides, International Journal of Mineral Processing, 100,1-13. http://dx.doi.org/10.1016/j.minpro.2011.04.001
- Bulatovic, S., & Wyslouzil, D.M. (1985). Selection of reagent scheme to treat massive sulphide ores, Complex Sulphides, Processing of Ores, Concentrates and By-Products (Ed. By A.D. Zunkel, R.S. Boorman, A.E. Morris and R.J. Wesely), Metallurgical Society, 101-141.
- Cases, J.M., de Donato, P., Kongolo, M., & Michot, L. (1989). The influence of grinding media on the adsorption and abstraction of potassium amyl xanthate on finely ground galena and pyrite, SME Preprint, SME, Littleton Colorado, 89-62.
- Chapman, N. A., Shackleton, N. J., Malysiak, V., & O'Connor, C. T., (2013). Comparative study of the use of HPGR and conventional wet and dry grinding methods on the flotation of base metal sulphides and PGMs, The Journal of the Southern African Institute of Mining and Metallurgy, 113, 407-413.
- Dávila-Pulido, G.I., Uribe-Salas, A., & Espinosa-Gómez, R., (2011). Comparison of the depressant action of sulfite and metabisulfite for Cu-activated sphalerite, International Journal of Mineral Processing, 101(1-4), 71-74.
- https://doi.org/10.1016/j.minpro.2011.07.012
- Ek, C. S., (1985). Selective flotation of different complex pyritic ores, In Complex Sulfides, Zunkel A.D. and others (Eds.), TMS-AIME, Warrendale, 83-101.
- Fahlstrom, P.H. (1974). Autogeneous grinding of base metal ores at Boliden Aktiebolag. CIM Bulletin, 78, 127-141.