Load shifting and operational cost optimization in cold-climate ground source heat pumps using phase change material (PCM) -based thermal energy storage

Öz

This study investigates the integration of a phase change material (PCM) thermal storage tank with a ground-source heat pump (GSHP) system for residential heating in a cold-climate region (Erzurum, Türkiye) under a time-of-use (TOU) electricity pricing scheme. The configuration incorporating a PCM tank (ATP52) and a buffer tank was modeled using TRNSYS software to enhance energy storage during off-peak periods and reduce reliance on the grid during high-tariff hours. Nine different configurations were analyzed by varying the PCM mass fraction (75%, 100%, and 125%) and the charging set-point temperature, which was defined with respect to the PCM melting temperature. (Tmelting, Tmelting +2 °C, and Tmelting +5 °C). Simulation results show that PCM integration enables significant load shifting, reducing peak-period heat pump electricity use by up to 95% and lowering annual operating costs by 9% (from 163,848 TRY to 149.002 TRY), despite a 10% increase in total energy consumption. Consequently, annual electricity costs are reduced, with the highest savings observed in the PCM High–2 scenario. In addition, compared to a conventional water-based system, similar or greater economic benefits were achieved with a PCM tank volume of only 15 m3, versus the 50 m3 required for water storage. These results highlight the efficiency and economic advantages of PCM-based storage for optimizing building heating systems in cold climates under dynamic tariff structures.

Anahtar Kelimeler

• Thermal energy storage
• Phase change material (PCM)
• Ground source heat pump (GSHP)
• Cold climate heating
• Load shifting
• optimization

Kaynakça

1. [1] Jakučionytė-Skodienė M, Krikštolaitis R, Liobikienė G. “The contribution of changes in climate-friendly behaviour, climate change concern and personal responsibility to household greenhouse gas emissions: Heating/cooling and transport activities in the European Union”. Energy, 246,123387, 2022.
2. [2] Jakučionytė-Skodienė M, Krikštolaitis R, Liobikienė G. “Global Warming of 1.5 °C”. Geneva, Switzerland, Special Report, 2018.
3. [3] International Energy Agency. “Heating”. https://www.iea.org/reports/heating (24.06.2026).
4. [4] Cabeza LF, Chàfer M. “Technological options and strategies towards zero energy buildings contributing to climate change mitigation: A systematic review”. Energy and Buildings, 219, 110009, 2020.
5. [5] Kutlu C, Zhang Y, Lyu Q, Su Y, Riffat S. “Direct-expansion solar-assisted heat pump coupled with crystallisation-controlled supercooled PCM for shifting building electricity demand”. Energy and Buildings, 301, 113660, 2023.
6. [6] Cascone Y, Capozzoli A, Perino M. “Optimisation analysis of PCM-enhanced opaque building envelope components for the energy retrofitting of office buildings in Mediterranean climates”. Applied Energy, 211, 929-953, 2018.
7. [7] Kumar VV. “Energy conservation of residential buildings in extreme climates with phase change material-aluminum radiation reflector cool roof”. Energy Sources, Part A: Recovery, Utilization, and Environmental Effects, 44(4), 9703-9715, 2022.
8. [8] Arıcı M, Karabay H, Kan M. “Flow and heat transfer in double, triple and quadruple pane windows”. Energy and Buildings, 86, 394-402, 2015.

9. [9] Zhou Y, Wu G, Li D, Jiang W, Hussein AK, Fu S. “Dynamic thermal stress analysis of PCM-glazed unit under intermittent solar irradiation”. Energy Sources, Part A: Recovery, Utilization, and Environmental Effects, 47(1), 7730-7748, 2025.
10. [10] Can ÖF. “Numerical investigation of wind resistance and heat island formation in buildings of different configurations”. Pamukkale University Journal of Engineering Sciences, 30(6), 729-736, 2024.
11. [11] Allesina G, Ferrari C, Muscio A, Pedrazzi S. “Easy to implement ventilated sunspace for energy retrofit of condominium buildings with balconies”. Renewable Energy, 141, 541-548, 2019.
12. [12] Altun M, Akçamete A, Meral Akgül Ç. “Investigation of the effect of outdoor temperature data on the building heating energy requirement and validity of the TS 825 degree-day region clustering”. Pamukkale University Journal of Engineering Sciences, 26(6), 1062-1075, 2020.
13. [13] Pelella F, Zsembinszki G, Viscito L, Mauro AW, Cabeza LF. “Thermo-economic optimization of a multi-source (air/sun/ground) residential heat pump with a water/PCM thermal storage”. Applied Energy, 331, 120398, 2023.
14. [14] Su C, Madani H, Palm B. “Building heating solutions in China: A spatial techno-economic and environmental analysis”. Energy Conversion and Management, 179, 201-218, 2019.
15. [15] Deng J, Wei Q, Liang M, He S, Zhang H. “Does heat pumps perform energy efficiently as we expected: Field tests and evaluations on various kinds of heat pump systems for space heating”. Energy and Buildings, 182, 172-186, 2019.
16. [16] Jiang J, Hu B, Ge T, Wang RZ. “Comprehensive selection and assessment methodology of compression heat pump system”. Energy, 241, 122831, 2022.
17. [17] Esen H, Esen M, Ozsolak O. “Modelling and experimental performance analysis of solar-assisted ground source heat pump system”. Journal of Experimental & Theoretical Artificial Intelligence, 29(1), 1-17, 2017.
18. [18] Esen M, Ayhan T. “Development of a model compatible with solar assisted cylindrical energy storage tank and variation of stored energy with time for different phase change materials”. Energy Conversion and Management, 37(12), 1775-1785, 1996.
19. [19] Esen M, Yuksel T. “Experimental evaluation of using various renewable energy sources for heating a greenhouse”. Energy and Buildings, 65, 340-351, 2013.
20. [20] Corberán JM, Cazorla-Marín A, Marchante-Avellaneda J, Montagud C. “Dual source heat pump, a high efficiency and cost-effective alternative for heating, cooling and DHW production”. International Journal of Low-Carbon Technologies, 13(2), 161-176, 2018.
21. [21] Montagud C, Corberán JM, Montero Á. “In situ optimization methodology for the water circulation pumps frequency of ground source heat pump systems”. Energy and Buildings, 68, 42-53, 2014.
22. [22] Arteconi A, Brandoni C, Rossi G, Polonara F. “Experimental evaluation and dynamic simulation of a ground coupled heat pump for a commercial building”. International Journal of Energy Research, 37(15), 1971-1980, 2013.
23. [23] Gu H, Chen Y, Yao X, Huang L, Zou D. “Review on heat pump (HP) coupled with phase change material (PCM) for thermal energy storage”. Chemical Engineering Journal, 455, 140701, 2023.
24. [24] Kohlhepp P, Harb H, Wolisz H, Waczowicz S, Müller D, Hagenmeyer V. “Large-scale grid integration of residential thermal energy storages as demand-side flexibility resource: A review of international field studies”. Renewable and Sustainable Energy Reviews, 101, 527-547, 2019.
25. [25] Ozcan H. “Thermodynamic analysis of an ice slurry thermal energy storage system for decreased size and cost of HVAC systems”. Pamukkale University Journal of Engineering Sciences, 24(1), 25-29, 2018.
26. [26] Cirocco L, Pudney P, Riahi S, Liddle R, Semsarilar H, Hudson J, Bruno F. “Thermal energy storage for industrial thermal loads and electricity demand side management”. Energy Conversion and Management, 270, 116190, 2022.
27. [27] Baeten B, Rogiers F, Helsen L. “Reduction of heat pump induced peak electricity use and required generation capacity through thermal energy storage and demand response”. Applied Energy, 195, 184-195, 2017.
28. [28] Lin B, Chen J, Wesseh PK. “Peak-valley tariffs and solar prosumers: Why renewable energy policies should target local electricity markets”. Energy Policy, 165, 112984, 2022.
29. [29] Siddiqui S, Macadam J, Barrett M. “The operation of district heating with heat pumps and thermal energy storage in a zero-emission scenario”. Energy Reports, 7, 176-183, 2021.
30. [30] Ermel C, Bianchi MVA, Cardoso AP, Schneider PS. “Thermal storage integrated into air-source heat pumps to leverage building electrification: A systematic literature review”. Applied Thermal Engineering, 215, 118975, 2022.
31. [31] Cao Y, Zeng Z, Huang D, Chen Y, Zhang L, Sheng X. “Multifunctional phase change composites based on biomass/MXene-derived hybrid scaffolds for excellent electromagnetic interference shielding and superior solar/electro-thermal energy storage”. Nano Research, 15(9), 8524-8535, 2022.
32. [32] Li Z, Lu Y, Huang R, Chang J, Yu X, Jiang R, Yu X, Roskilly AP. “Applications and technological challenges for heat recovery, storage and utilisation with latent thermal energy storage”. Applied Energy, 283, 116277, 2021.
33. [33] Yu M, Li S, Zhang X, Zhao Y. “Techno-economic analysis of air source heat pump combined with latent thermal energy storage applied for space heating in China”. Applied Thermal Engineering, 185, 116434, 2021.
34. [34] Huang H, Xiao Y, Lin J, Zhou T, Liu Y, Zhao Q. “Improvement of the efficiency of solar thermal energy storage systems by cascading a PCM unit with a water tank”. Journal of Cleaner Production, 245, 118864, 2020.
35. [35] Parvin K, Hannan MA, Mun LH, Hossain Lipu MS, Abdolrasol MGM, Ker PJ, Muttaqi KM, Dong ZY. “The future energy internet for utility energy service and demand-side management in smart grid: Current practices, challenges and future directions”. Sustainable Energy Technologies and Assessments, 53, 102648, 2022.
36. [36] Heinz A, Gritzer F, Thür A. “The effect of using a desuperheater in an air-to-water heat pump system supplying a multi-family building”. Journal of Building Engineering, 49, 104002, 2022.
37. [37] Heng W, Wang Z, Wu Y. “Experimental study on phase change heat storage floor coupled with air source heat pump heating system in a classroom”. Energy and Buildings, 251, 111352, 2021.
38. [38] Qi D, Pu L, Sun F, Li Y. “Numerical investigation on thermal performance of ground heat exchangers using phase change materials as grout for ground source heat pump system”. Applied Thermal Engineering, 106, 1023-1032, 2016.
39. [39] Zhu C, Li B, Yan S, Luo Q, Li C. “Experimental research on solar phase change heat storage evaporative heat pump system”. Energy Conversion and Management, 229, 113683, 2021.
40. [40] Kim T, Choi BI, Han YS, Do KH. “A comparative investigation of solar-assisted heat pumps with solar thermal collectors for a hot water supply system”. Energy Conversion and Management, 172, 472-484, 2018.
41. [41] Yıldız Ç, Seçilmiş M, Arıcı M, Mert MS, Nižetić S, Karabay H. “An experimental study on a solar-assisted heat pump incorporated with PCM based thermal energy storage unit”. Energy, 278, 128035, 2023.
42. [42] Kotegov R, Abokersh M, Mateu C, Shobo A, Boer D, Vallès M. “Solar district energy systems with a seasonal energy storage: Advanced data-driven metaheuristic optimization”. Journal of Energy Storage, 131, 117557, 2025.
43. [43] T.E.S. Specialists. “Mathematical Reference”. http://web.mit.edu/parmstr/Public/Documentation/05-MathematicalReference.pdf (24.06.2026).
44. [44] Eisapour AH, Rad FM, Fung AS. “Techno-economic and environmental study of a hybrid solar ground source heat pumps for a heating-dominated community in a cold climate; a case study in Toronto”. Renewable Energy, 231, 120874, 2024.
45. [45] Acar U, Kaska O. “Performance assessments of ground source heat pump assisted by various solar panels to achieve zero energy buildings in cold climate conditions”. Journal of Building Engineering, 96, 110611, 2024.
46. [46] Moser C, Heinz A, Schranzhofer H. “TRNSYS Type 840: Simulation model for PCM/water storage tanks (Version 3.0)”. Graz University of Technology, Graz, Austria, Software, 2022.
47. [47] Axiotherm. “ATP-52”. https://www.axiotherm.de/en/produkte/axiotherm-pcm/ (12.07.2025).
48. [48] İzgi B, Arslan M. “Effect of phase change material on thermal stratification of solar hot water tank with a mantle: A numerical analysis”. Journal of Energy Storage, 52, 105078, 2022.