Comparison of reference evapotranspiration values calculated from conventional and automatic meteorological stations data
Öz
Accurate and consistent estimates of crop evapotranspiration (ETc) in irrigated agriculture are important for planning and managing irrigation and water resources and for using water resources efficiently. The most common procedure for estimating ETc is to adjust the reference evapotranspiration (ETo) values with the crop coefficient (Kc). This approach calculates ETo for a standard surface using reference parameters and agro-meteorological data. Then, it applies appropriate empirical crop coefficients for obtaining ETc. FAO Penman- Monteith (FAO-PM) method was recommended as the standard method to compute ETo from meteorological data. The meteorological data used to calculate evapotranspiration and/or reference evapotranspiration is obtained from conventional (synoptic) and automatic stations. Because of the differences in the instruments and methods used in conventional and automatic stations, the data from these stations is also different. Therefore, this research compares the ETo values determined by using temperature and relative humidity data from the synoptic station and the automatic station. The (t) test, root mean squared error (RMSE) and relative error (%E) were used as comparison criteria. It is understood that the daily ETo values obtained from two different stations are significantly different according to the (t) test (p<0.05) and the RMSE value (0.23 mm d-1) is below the acceptable error limit and the % E value is 9.42%. The average % E value for the monthly ETo values was 9.39% and the average % E value for the irrigation season was 4.39%. The ETo value obtained from the automatic station during the irrigation season was 25.9 mm less than the value obtained from the synoptic station. For this reason, it has been understood that the use of ETo value obtained from automatic station will be important for saving water.
Anahtar Kelimeler
Kaynakça
- [1] Rojas J.P., Sheffield R.E., Evaluation of the reference evapotranspiration methods as compared with the ASCE-EWRI Penman-Monteith equation using limited water data in Northeast Louisiana, J. Irrig. Drain Eng., 132(6), 285-292, 2013.
- [2] Irmak S., Payero J.O., Martin D.L., Irmak A. Howel T.A., Sensitivity analyses and sensitivity coefficients of standardized daily ASCE-Penman- Monteith equation, J. Irrig. Drain Eng., 564-578, 2006.
- [3] Allen R.G., Pereira R.S., Raes D., Smith M. Crop evapotranspiration: guidelines for computing crop water requirements. FAO Irrigation and Drainage Paper, 56, Rome, Italy, 1998.
- [4] Doorenbos J., Pruitt W.O., Crop water requirements. FAO Irrigation and Drainage Paper, 24, Rome, Italy, 1992.
- [5] Wright J.L., Crop coefficients for estimates of crop evapotranspiration, Irrigation Scheduling for Water and Energy Conservation in the 80`s, American Soc. Agric. Eng., 18-26, 1981.
- [6] Wright J.L., New evapotranspiration crop coefficients. Journal of Irrig. and Drain. Division, ASCE, 108 (IR2), 57-74, 1982.
- [7] Hupet F., Vanclooster M., Effect of the sampling frequency of meteorological variables on the estimation of the reference evapotranspiration, J. of Hydrology, 243, 192-204, 2001.
- [8] Hess T.M., A comparison between evapotranspiration calculated from an automatic weather station and conventional weather data- implication for irrigation scheduling in the UK, In. C.R. Camp, E.J. Sadler, R.E. Yoder (Eds): Proc. The Int. Conf. on Evapotranpiration and Irrig. Scheduling, San Antonio, Texas, pp. 516-521,1996.
Ayrıntılar
Birincil Dil
İngilizce
Konular
Mühendislik
Bölüm
Araştırma Makalesi
Yazarlar
Yayımlanma Tarihi
16 Aralık 2017
Gönderilme Tarihi
2 Kasım 2017
Kabul Tarihi
-
Yayımlandığı Sayı
Yıl 2017 Cilt: 6 Sayı: 2