Production and Analysis of Composite Nanofiber and Heat Applied Nanofiber
Öz
In this study, two different applications related with nanofiber production have been studied. In one application, nanofiber was obtained from Maleic Anhydrite grafted Polypropylene (MAH PP) that it is not possible to produce nanofiber at the environmental temperature by solvent technique. The effect of the temperature of polymer solvent on nanofiber producibility has been investigated. It has been seen that it is not possible to produce nano fiber by o o solvent below 70 C. The bead on the nanofiber increases when solution temperature is around 100 C. Bead formation may be due to lower viscosity resulted from higher temperature. In the other application, elastomeric polymer (Polystyrene-block-poly(ethylene-ran-butylene)-block-polystyrene graft-maleic anhydride) (SEBS-g-MA) together with cellulose nanowhiskers (CNW) was used to produce composite nanofiber. The effect of feed rate and also the amount of water content on properties of composite nanofiber have been investigated. It has been seen that an increase of water content results to deformation of nanofiber morphology and decrease of feeding rate results to thinner fiber.
Anahtar Kelimeler
Ayrıntılar
Birincil Dil
İngilizce
Konular
Mühendislik
Bölüm
Araştırma Makalesi
Yazarlar
Onur Ayaz
Bu kişi benim
Nuray Uçar
Bu kişi benim
Elif Bahar
Bu kişi benim
Mustafa Oksuz
Bu kişi benim
Mehmet Ucar
Bu kişi benim
Aysen Onen
Bu kişi benim
Ali Demir
Bu kişi benim
Youjiang Wang
Bu kişi benim
Yayımlanma Tarihi
1 Mart 2012
Gönderilme Tarihi
13 Aralık 2013
Kabul Tarihi
-
Yayımlandığı Sayı
Yıl 2012 Cilt: 19 Sayı: 85