Investigations on LaFeO3 Thin Film Using Sol–Gel Technique for Magnet Technology

Yıl 2017, Cilt: 17 Sayı: 1, 346 - 351, 24.04.2017

Mehmet Faruk Ebeoğlugil

Öz

In this study, lanthanum Ferrite (LaFeO3) thin films were prepared by sol-gel method for magnet technology. With this context, precursor solutions with low contact angles were synthesized from all nitrate salts of the respective cations (La, Fe), using methanol as solvent and citric acid as chelating agents. The obtained gel films were dried at heat-treated at 500 oC for 10 minutes in air. The oxide thin films were annealed at 850 oC for 60 and 120 minutes and 1000 oC for 120 minutes in air. DTA/TG results revealed that endothermic and exothermic reactions are observed at temperature between 29 oC and 450 oC due to solvent removal, combustion of carbon based materials and oxidation of La and Fe. The spectrum of La-Fe precursor film annealed at 850oC and 1000 oC shows an absence of absorption bands corresponding to organics and hydroxyls. LaFeO3 phase was found as well as pure perovskite with low intensity from XRD patterns. It was found that surface morphologies of the film with homogeneous structures. The thermal, phase, microstructural and magnetic properties of the obtained samples were determined by TG/DTA, FTIR, XRD, SEM, XPS, wetting angles and VSM. The results show that sustained perovskite polycrystalline films were grown on the (100)-oriented Si substrates. In addition, the films show strong ferromagnetic behavior.

Anahtar Kelimeler

LaFeO3, Sol-gel, Magnetic properties

Kaynakça

• Abrashev, M. V., Litvinchuk, A. P., Iliev, M. N., et al., 1999. Comparative study of optical phonons in the rhombohedrally distorted perovskites LaAlO3 and LaMnO3. Phys. Rev. B 59, 4146. doi: http://dx.doi.org/10.1103/PhysRevB.59.4146
• Bai, S., Shi, B., Ma, L., Yang, P., Liu, D.Q., Chen, A.F., 2009. Synthesis of LaFeO3 catalytic materials and their sensing proper- ties. Sci. China Ser. B 52, 2106.
• Brankovic Z, Duris K, Radojkovic A, et al., 2010. Magnetic properties of doped LaMnO3 ceramics obtained by a polymerizable complex method. J. Sol–Gel Sci. Technol. 55 311. doi: 10.1007/s10971-010-2251-4
• C. Monterrubio-Badillo, H. Ageorges, T. Chartier, et al., 2006. Preparation of LaMnO3 perovskite thin films by suspension plasma spraying for SOFC cathodes. Surface and Coatings Technology, 200, 3743-3756. doi:10.1016/j.surfcoat.2005.01.002
• Chandradass, J., Kim, K.H., 2010. Nano-LaFeO3 powder preparation by calcining an emulsion. Mater. Chem. Phys. 122, 329.
• D. Kivana, J. Delval, J. Kirchnerova, J. Chaouki, 1997. Appl.Catal. A: Gen., 165 - 171.
• G. Zampieri, M. Abbate, F. Prado, et al., 2002. XPS and XAS spectra of CaMnO3 and LaMnO3. Physica B Condensed Matter, 320, 1–4:51–55. doi:10.1016/S0921-4526(02)00618-X
• Gupta A., McGuire T. R., Duncombe P. R., et al., 1995. Applied Physics Letter, 67, 349
• N. Setter, D. Damjanovic, L. Eng, et al., 2006. Ferroelectric thin films: Review of materials, properties, and applications. Journal of Applied. Physics. 100, 051606. doi: http://dx.doi.org/10.1063/1.2336999
• Ni H., Yu D., Zhao K., Kong Y. C., et al., 2011. Oxygen content dependence of the photovoltaic characteristic of miscut manganite thin films. J. Appl. Phys. 110 033112 doi: http://dx.doi.org/10.1063/1.3620984
• O. Yamamoto, 2000. Solid oxide fuel cells: fundamental aspects and prospects. Electrochimica Acta, 45, 2423-2435. doi:10.1016/S0013-4686(00)00330-3
• P. R. N. Silva and A. B. Soares, 2009. Lanthanum based high surface area perovskite-type oxide and application in CO and propane combustion. Eclet. Quím., vol.34, no.1, São Paulo. doi: http://dx.doi.org/10.1590/S0100- 46702009000100005
• Poplawski, K., Lichtenberger, J., Keil, F.J., Schnitzlein, K., Amiridis, M.D., 2000. Catalytic oxidation of 1,2- dichlorobenzene over ABO3-type perovskites. Catal. Today 62, 329.
• Raj Sankar C. and Joy P. A., 2005. Magnetic properties of the self-doped lanthanum manganites La1−xMnO3. Physical Review B, 72-02440. doi: http://dx.doi.org/10.1103/PhysRevB.72.024405.
• Ritter C , I barra M R , D e T eresa J M , e t a ll., 1 997. Influence of oxygen content on the structural, magnetotransport, and magnetic properties of LaMnO3+δ. Physical Review B. 56-8902. doi:http://dx.doi.org/10.1103/PhysRevB.56.8902
• Saracco, G., Cerri, I., Specchia, V., Accornero, R., 1998. Catalytic pre-mixed fibre burners. Chem. Eng. Sci. 54, 3599.
• Shimizu Y., and Murata T., 1997. Sol–Gel Synthesis of Perovskite-Type Lanthanum Manganite Thin Films and Fine Powders Using Metal Acetylacetonate and Poly(vinyl alcohol). Journal of the American Ceramic Society, 80-2702. doi: 10.1111/j.1151- 2916.1997.tb03178.x
• Shudan Li, Liqiang Jing, Wei Fu, Libin Yang, Baifu Xin, Honggang Fu, 2006. Photoinduced charge property of nanosized perovskite-type LaFeO3 and its relationships with photocatalytic activity under visible irradiation. Materials Research Bulletin 42, 204.
• Tejuca, J.L., Fierro, J.L.G., 1993. Properties and Applications of Perovskite-Type Oxides. Mazcel Dekker, New York.
• Tsukasa Nagai, Naoko Fujiwara, Masafumi Asahi, et al., 2014. Synthesis of nano-sized perovskite-type oxide with the use of polyvinyl pyrrolidone. Journal of Asian Ceramic Societies, Vol. 2, Issue 4, 329-332, ISSN 2187-0764, http://dx.doi.org/10.1016/j.jascer.2014.08.004
• Y. Teraoka, K. Kanada, S. Kagawa, 2001. Synthesis of La K Mn O perovskite-type oxides and their catalytic property for simultaneous removal of NOx and diesel soot particulates. Applied Catalysis B: Environmental, Vol. 34, Issue 1, 73-78, http://dx.doi.org/10.1016/S0926-3373(01)00202-8
• Yamaguchi, S., Wada, H., Sanchez-Rodriguez, D., et al., 2016. Synthesis of perovskite-type oxide, LaFeO3, from coordination polymer precursor, La[Fe(CN)6]5H2O. Journal of the Ceramic Society of Japan, Vol.124-1, 7-12, doi: http://doi.org/10.2109/jcersj2.15198