GERİLİM SARKMALARINA KARŞI YÜK DUYARLILIKLARINI GÖSTERMEK İÇİN BULANIK MANTIK UYGULAMASI

Yıl 2021, , 297 - 310, 31.12.2021

Hakan Öztürk , Ertan Yanıkoğlu

https://doi.org/10.31796/ogummf.912917

Öz

Gelişen teknolojiyle birlikte elektrik enerjisine olan ihtiyaç her geçen gün artmaktadır. Elektrik enerjisinin dağıtımı sırasında birçok hata (gerilim yükselmeleri, gerilim sarkmaları, harmonikler) meydana gelebilmektedir. Bu hataları düzeltmek için STATCOM ve DVR gibi sistemler kullanılmaktadır. Böylece enerjinin kalitesi arttırılmaya çalışılmaktadır. Bu çalışmada; hata olarak gerilim sarkmasının meydana geldiği bir iletim hattına yük bağlanarak bu yükün gerilim sarkması karşısındaki durumu ve hassasiyeti, ardından düzeltici olarak DVR kullanıldığındaki durumu ve hassasiyeti araştırılmıştır. DVR sisteminin yükler karşısındaki durumu detaylı olarak incelenmiştir. İlgili veriler MATLAB/Bulanık Mantık uygulamasına aktarılarak analiz edilmiştir.

Anahtar Kelimeler

Bulanık Mantık, Asenkron motorlar, Gerilim Sarkmaları, Elektrik Güç Sistemleri, Hat Arızaları

FUZZY LOGIC APPLICATION TO SHOW LOAD SENSITIVITIES AGAINST VOLTAGE SAG

Öz

With the developing technology, the need for electrical energy is increasing day by day. Many power quality problems such as voltage spikes, voltage sags, harmonics can occur during the distribution of electrical energy. Systems such as STATCOM and DVR are used to correct these problems. Thus, the quality of the energy is tried to be increased. In this study; By connecting a load to a distribution line where voltage sag occurs as an error, the condition and sensitivity of this load against voltage sagging, and then the condition and sensitivity when using DVR as a corrector, were investigated. The situation of DVR against the loads has been analyzed in depth. Relevant data have been transferred to MATLAB / Fuzzy Logic application and analyzed.

Anahtar Kelimeler

Fuzzy Logic, Induction Motors, Voltage Sags, Electric Power Systems, Line Faults

Kaynakça

• C. Balu ve D. Maratukulam (1994), Power system voltage stability. McGraw Hill.
• T. V. Cutsem ve C. Vournas (1998). "Voltage stability of electric power systems,"
• C. J. I. I. Heising (2007), New York, "IEEE recommended practice for the design of reliable industrial and commercial power systems,".
• M. F. McGranaghan, D. R. Mueller, ve M. J. J. I. T. o. i. a. Samotyj (1993). "Voltage sags in industrial systems," vol. 29, no. 2, pp. 397-403.
• J. Lamoree, D. Mueller, P. Vinett, W. Jones, ve M. J. I. T. o. I. A. Samotyj (1997). "Voltage sag analysis case studies," vol. 30, no. 4, pp. 1083-1089.
• M. Haque (2001). "Compensation of distribution system voltage sag by DVR and D-STATCOM," in 2001 IEEE Porto Power Tech Proceedings (Cat. No. 01EX502), vol. 1, p. 5 pp. vol. 1: IEEE.
• R. Weissbach, G. Karady, ve R. J. I. T. o. P. D (1999). Farmer, "Dynamic voltage compensation on distribution feeders using flywheel energy storage," vol. 14, no. 2, pp. 465-471.
• H. Hatami, F. Shahnia, A. Pashaei, ve S. Hosseini (2007). "Investigation on D-STATCOM and DVR operation for voltage control in distribution networks with a new control strategy," in 2007 IEEE Lausanne Power Tech, pp. 2207-2212: IEEE.
• C. Benachaiba ve B. J. A. J. o. A. S. Ferdi (2009). "Power quality improvement using DVR," vol. 6, no. 3, p. 396.
• E. Babaei ve M. F. J. E. P. S. R. Kangarlu (2012). "Sensitive load voltage compensation against voltage sags/swells and harmonics in the grid voltage and limit downstream fault currents using DVR," vol. 83, no. 1, pp. 80-90.
• C. Benachaiba, B. J. E. P. Q. Ferdi, ve U. Journal (2008), "Voltage quality improvement using DVR," vol. 14, pp. 39-46.
• R. Omar ve N. Abd Rahim (2008). "Modeling and simulation for voltage sags/swells mitigation using dynamic voltage restorer (DVR)," in 2008 Australasian Universities Power Engineering Conference, pp. 1-5: IEEE.
• A. K. Sadigh ve K. Smedley (2012). "Review of voltage compensation methods in dynamic voltage restorer (DVR)," in 2012 IEEE Power and Energy Society General Meeting , pp. 1-8: IEEE.
• F. A. Jowder (2007). "Modeling and simulation of dynamic voltage restorer (DVR) based on hysteresis voltage control," in IECON 2007-33rd Annual Conference of the IEEE Industrial Electronics Society, pp. 1726-1731: IEEE.
• R. H. Salimin ve M. Rahim (2011). "Simulation analysis of DVR performance for voltage sag mitigation," in 2011 5th International Power Engineering and Optimization Conference, pp. 261-266: IEEE.
• M. R. Azim ve M. A. J. I. J. o. C. A. Hoque (2011). "A fuzzy logic based dynamic voltage restorer for voltage sag and swell mitigation for industrial induction motor loads," vol. 30, no. 8, pp. 9-18.
• Mithilesh, S., ve Shubhrata, G. (2015). Fuzzy Logic Based Simulation of DVR and DSTATCOM in Power Systems for Power Quality Improvement. In National Conference on Knowledge, Innovation in Technology and Engineering (NCKlTE) (pp. 10-11).
• S. S. Choi, B. Li, ve D. J. I. T. o. p. s (2000). Vilathgamuwa, "Dynamic voltage restoration with minimum energy injection," vol. 15, no. 1, pp. 51-57.
• S. Chattopadhyay, M. Mitra, ve S. Sengupta (2011). "Electric power quality," in Electric Power Quality: Springer, pp. 5-12.
• A. Shokri, A. M. Hussain Shareef, H. Zayandehroodi, M. J. R. J. o. A. S. Farhoodnea (2013.). Engineering, and Technology, "Effect of network parameters on the injection current requirement of D-STATCOM designed to mitigate voltage sag," vol. 5, no. 1, pp. 161-166.
• P. Roncero-Sanchez ve E. J. I. T. o. p. d. Acha (2009). "Dynamic voltage restorer based on flying capacitor multilevel converters operated by repetitive control," vol. 24, no. 2, pp. 951-960.
• P. Gonzalez ve A. Cerrada (2010)."Analysis of a Neutral-Point-Connected DVR and comparison with a conventional and a Transformer-less DVR," Internal report2010.