1. INTRODUCTION

This paper is a template for Copy Editors and Authors. If you are reading a paper or PDF version of this template, please download the file from the Science Literature web site at http://www.scienceliterature.com. Thus, you can use it to prepare your manuscript. In this section, please provide an adequate background with presentation a detailed literature survey about the using materials, techniques and reasons of preferred of related study.

According to the article type, widely scanned literature information should be given in this section.

2. EXPERIMENTAL

The detailed experiment should be given with mark (brand) of using materials and measurement devices. The experiment should be understandable and can be repeated easily.

2.1. Procedures for Preparing Submission

A simple way to comply with the formatting requirements of journal is to use this paper and simply type your manuscript into it.

The template is used to format your paper and style the text. All margins, column widths, line spaces, and text fonts are prescribed; please do not alter them. Your paper is one part of the entire proceedings, not an independent document. Please do not revise any of the current designations. Paper should be orderly prepared like sections;

1. INTRODUCTION

2. EXPERIMENTAL

3. RESULTS

4. CONCLUSION

Appendix (Optional)

Acknowledgement (Optional)

References

Biographies (Optional)

Figure(s) with Caption(s) (Optional)

Table(s) with Caption(s) (Optional)

3. RESULTS

The obtaining results, graphs and tables if there are, should be expressed in this section clearly. The subject can be discussed with the similar studies by giving references.

3.1. Page Format

Your paper should use a page size suitable to A4 paper which is 210mm wide and 297mm long. The margins are set as follows: top= 1.5 cm, bottom= 1.5 cm, right=1.75 cm, left = 2.0 cm. Your paper should be in two column format with a space of 0.7 cm between columns.

3.2. Text Font

The entire document should be prepared in Times New Roman font size 10 pt. Paper title should be regular font size 22 pt, centered, bold, and not all with upper case. Author names should be centered, regular font size 10 pt. Affiliations should be regular font size 8 pt and italic. Email address of corresponding author should be centered, font size 8 pt. More than 3 levels of headings should not be used. Level 1 headings should be left-justified, bold, numbered using Arabic numerals, regular font size 10 pt. The all letter of each title capitalized. Level 2, 3 and more headings should be left-justified, italic, numbered using Arabic numerals, regular font size 10 pt. The first letters of each title word capitalized and then lowercased. A line should be given before the each title.

3.3. Equations and Units

Equations should be centered with equation numbers set flush right as in Equ. (1). Formatting for MathType, use the Times + Symbol 11. Use either SI (MKS) or CGS as primary units. As a common mistake, please use (arb. uni.) for abbreviation of “arbitrary units”, not use (a.u.) because of the “atomic unit”.

                                                         (1)

3.4. Tables

For table title, table head, and table text should be provided. Tables and figures can be placed on separate pages at the back of the manuscript if it is necessary. Table body should be centered and in 10 pt Regular font.

Table 1. Publication number in 2013 as an example.

3.5. Figures

One Figure or Graph, each with a title, can be placed apart from the article text in the separate page if it is necessary. Figures should be numbered using Arabic numerals in the text. Figures grouped together should have similar dimensions and be labeled "a, b, c", etc. The colorful and black-white images should be imported at a minimum of 300 dots per inch (dpi). Examples; ....in Figure 1, Figure 2(a) shows….., ….from Figure 2(a-d).

3.6. Figure Captions

Figures should be numbered using Arabic numerals. Figure captions should be in 10 pt. Figure captions should be centered below the related figure.   A caption should comprise a brief title.

Fig. 1. An example figure for preparing manuscript for a journal of Science Literature.

3.7. Table captions

Table heads should appear above the tables and tables should be numbered using Arabic numerals. Table title should be centered and in 10 pt. Captions with table numbers should be placed above the related tables, as shown in Table 1.

Fig. 2. Graph example. (a) Abcxyz (b) Xyzabc (c) Abcabc (d) Xyzxyz

3.8. References Formats

All reference items should be in 10 pt font. Number the reference items consecutively in square brackets as in [1]. When referring to a reference item, please simply use the reference number, as in [2]. Indicate references by number(s) in square brackets in line with the text. The actual authors can be referred to, but the reference number(s) must always be given.

Example: As demonstrated multiple references [1,4] or [3,6-9]. “Wang and Demir [11] or Brown et al. [12]…obtained a similar result.”

4. CONCLUSION

Please include a brief summary of the possible implications of your study in the conclusion section. Although a conclusion may review the main points of the manuscript, please do not replicate the abstract or another part from the text as the conclusion.

Appendix

Appendixes, if needed, appear before the acknowledgment. Please not use number for the heading of this section.

Acknowledgement

Please not use number for the heading of the Acknowledgments section. Acknowledgement example;

The authors would like to thank for the contributions of Prof. Dr. Abc Xyz and/or This work was supported by the Abc University Project No: 23232323434-2011.

References

[1]       A.A. One, A.B. Two, A.C. Three. Journal citation style: Title of article. J. Sci. Lit. 1(4) 1-3 (2013).

[2]       X.A. Four, Y.B. Five, Z.C. Six. Journal citation style: Title of article. J. Sci. Lit. (In Press).

[3]       A.A. One, A.B. Two, A.C. Three. Book citation style: Title of book. Science Literature Publishing (2. Ed) 11-33 (1968).

[4]       A.A. One, A.B. Two, A.C. Three. Thesis citation style: Title of thesis. Xyz Univ. 21-23 (2015).

[5]       A.A. One, A.B. Two, A.C. Three. E-book citation style: Title of e-book. Science Literature Publishing (1. Ed) 1231-1257 (2014).

Biographies (Optional for each journal)

A technical biography for each author may be included. It should begin with the author’s full name as bold. A photograph should also be included for each author. The photo should be 2.5 centimeters wide by 3.0 centimeters high. The head and the photo should be flush with the left margin. The space required for each biographies. The following is an example of the text of a technical biography:

Biographies

Oktay Sinanoğlu (write your full name) was born on February 25, 1935 in Bari, Italy where his father served as a consul general. In 1939 by the commence of World War II, the family returned to Turkey. In 1953, he attended the high school "TED Yenişehir Lisesi" in Ankara, and after graduating won a scholarship for education of chemistry in the USA. In 1956, he graduated from Berkeley in chemical engineering with the highest rank. In only eight months, he graduated from MIT in1957 with the highest degree. In two years, he finished his doctorate at the University of California at Berkeley. In 1960, Sinanoğlu started working as associate professor at Yale University. He theorized the "Many-Electron Theory of Atoms and Molecules" in1962 by solving a mathematical theorem that had been unsolved for 50 years. The same year, he earned the "Alfred Sloan" prize. As appointed professor in1963 at the age of only 28, he became the youngest person in the past century at Yale to attain the status as a full professor. He got his second life-long chair in Yale in Molecular Biology.

Submission Preparation Checklist

As part of the submission process, authors are required to check off their submission's compliance with all of the following items, and submissions may be returned to authors that do not adhere to these guidelines.

1. The submission has not been previously published, nor is it before another journal for consideration (or an explanation has been provided in Comments to the Editor).
2. The submission file is in OpenOffice or Microsoft Word document file format.
3. Where available, URLs for the references have been provided.
4. The text is single-spaced; uses a 10-point font; employs italics, rather than underlining (except with URL addresses); and all illustrations, figures, and tables are placed within the text at the appropriate points, rather than at the end.
5. The text adheres to the stylistic and bibliographic requirements outlined in the Author Guidelines, which is found in About the Journal.
6. If submitting to a peer-reviewed section of the journal, the instructions in Ensuring a Blind Review have been followed.

Copyright Notice

I/We hereby declare that the material being presented by me in this paper is my/our original work, and does not contain or include material taken from other copyrighted sources. Wherever such material has been included, it has been clearly indented and/or identified by quotation marks and due and proper acknowledgements given by citing the source at appropriate places.  The paper, the final version of which I/we enclose, is not substantially the same as any that I/we have already published elsewhere.  I/we have not sent the paper or any paper substantially the same as the enclosed one, for publication anywhere else. It will not be submitted anywhere else for publication prior to acceptance/rejection by this Journal. A copyright permission is obtained for materials published elsewhere and which require this permission for reproduction.

Furthermore, I/we hereby transfer the unlimited rights of publication of the above mentioned paper in whole to www.scienceliterature.com. The copyright transfer covers the exclusive right to reproduce and distribute the article, including reprints, translations, photographic reproductions, microform, electronic form (online, offline) or any other reproductions of similar nature. The corresponding author signs for and accepts responsibility for releasing this material on behalf of any and all co-authors. This agreement is to be signed by at least one of the authors who have obtained the assent of the co-author(s) where applicable. After submission of this agreement signed by the corresponding author, changes of authorship or in the order of the authors listed will not be accepted. If any law full occur www.scienceliterature.com will not any responsible for my/our work.

 Please complete and sign this copyright form and send it to www.scienceliterature.comwith the final version of your manuscript. A written confirmation from the author(s) is required for paper(s) to be considered for publication in www.scienceliterature.com.

Privacy Statement

The names and email addresses entered in this journal site will be used exclusively for the stated purposes of this journal and will not be made available for any other purpose or to any other party.